Hongjie K6 Wireless Lapel Microphone User Manual

Wireless Microphone
User Manual
PMN:Wireless lapel microphone

ID Diagram

One to One Charging Case| One to Two Charging Case| Microphone(Mic)| Receiver (RX)
1 Type-C Charging port
2 Charging Case Power Display
3 Mic Indicator
4 Mic Power Display| 5 Mic On/Off/ Mute
6 RX Type-C/lightning port
7 RX Type-C/lightning charging port
8 RX indicator
---|---

How to Use

Step 1 Press the on/off/mute button on the MIC for 3 seconds, the indicator will turn green and red.

Step 2 Plug RX into phone. Once the RX is plugged in, the RX’s indicator should turn green.

If the RX doesn’t light green, please:
a. Make sure your phone’s OTG is On. (search “OTG” – turn on OTG power supply)
Some phones do not support an external microphone for the built-in camera. If videos recorded with built-in camera has no sound,
b. If phone is covered with a case, please remove the case and plug RX into the phone again. The first use of the unit, the MIC and RX will go into sync mode. During sync mode, the indicator of MIC flashes red and green. Once the MIC and RX are successfully connected, the indicators of MIC and RX will turn green without blinking.
Step 3 When the indicators of MIC and RX both turn green without blinking，the MIC is ready to work. Open recorder or live video apps to pick up sound. please download other camera apps to pick up sound.

Mute
To pause the MIC double click on/off/mute button.
The MIC’s indicator lights red when in Mute mode.
Double click the button again to exit the Mute Mode.
Noise Cancellation
Once the MIC is turned on, the Noise Cancellation function is activated automatically. No operation is required.
Turn Off Mic
Press the On/Off button of MIC for 3 seconds to turn off the MIC.
Charging

1. Charging the MIC
   When charging case has power, the MIC will start charging as soon as it is put into the charging case.
   Please remove the sticker from MIC before charging the MIC through the charging case. **ONE to ONE
   When charging the MIC, the charging case will display the power. ONE to TWO****
   L The mic on the left side is charging.
   R The mic on the right side is charging.

2. Charging the Charging Case

3. Charging Phones
   You can charge your phone through the port of RX.
   Phones with type-c port : charge it with type-c cable.
   Phones with lightning port: charge it with lightning cable.

About UI

Microphone Transmitter

Receiver

Packing List

1.MIC
2.RX
3.Charging Case| 4.Type-C Charging Cable
5.User Manual
---|---

Q&A

Why is there no sound from the microphone?

Please check out indicators of MIC and RX. 1) Both indicators of MIC & RX light green without blinkging. For Samsung phones - Please use other apps but the built-in camera to pick up sound. For Google and Oneplus phones - Some models are NOT compatible with the microphone. 2) The indicators of MIC and RX light green with blinking. For OPPO and VIVO phones-Please make sure the OTG is ON. (Search “OTG”in system - turn on OTG).

Why there is noise when I record video or audio or live stream?

Please try again in other places, especially when there is a 2.4G signal nearby, such as WIFI, base station, etc.

FCC Warning
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any inte rference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interferenceto radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
Canada IC Notice

• This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two conditions:

1. this device may not cause interference, and
2. this device must accept any interference, including interference that may cause undesired operation of the device.

ISED Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirement. The device can be used installed and operated with minimum distance 0mm between the radiator and your body.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>