Dongguan JT10A Indicator Light Instruction Manual
- June 16, 2024
- Dongguan
Table of Contents
**Dongguan JT10A Indicator Light Instruction Manual
**
Indicator light
LED indicates status
- Headphones on: white light flashes
- Left / right ear interconnection: main ear white flashes, secondary ear turns off
- Connect Bluetooth: light off
- Headphone charging: The white light of the headset is always on /off when fully charged
- Warehouse charging: white light flashes when breathing/white light goes out when fully charged
Function operation
- Turn on : Take out the headphones from the compartment and turn on the phone
- Shut down: Put the earphones back into the compartment to charge and shut down ( shut down after 3 minutes without Bluetooth connection)
- Connect to the mobile phone: After the headset is turned on, open the Bluetooth of the mobile phone and search for the corresponding device name: GK-JT10AClick to connect
- Play/pause music: click the left/right ear Touch button
- Previous song: music playing status three strikes Left / right ear Touch button
- Next song: Music playing status Double click left/ right Ear Touch button
- Answer a call: When a call comes in, click the Touch button on any earphone to answer the call.
- Hang up : call in progress Double -click the Touch button on either ear to hang up the call
- Reject an incoming call: When a call comes in, press and hold the Touch button on any headset for about 2 seconds to reject the call.
- Turn on Siri: Press and hold the Touch button on any headset for 2 seconds to activate it
here : prompt sound
- Power on : power on
- Shutdown : power off
- Connect Bluetooth : “Ding” piano sound
- Disconnect Bluetooth : ” du du “
FCC ID:2BD7C-JT10A
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmterference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipmen