LED s light 1000424 Solar Table Lamp Instruction Manual

: June 4, 2024
: LED s light

Table of Contents

LED s light 1000424 Solar Table Lamp
INSTALLATION
Introduction
Assembly
Care and Cleaning
Safety
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

LED s light 1000424 Solar Table Lamp

LED s-light-1000424-Solar-Table-Lamp-PRODUCT

INSTALLATION

Introduction

Please read these instructions carefully before use.

Assembly

Place the lampshade on the foot and press all around, until the two parts snap together.
Initial charging:
If the solar panel is covered with a thin protective film, remove it before using the product. Remove the solar puck by aligning the arrows on the solar panel and basket and then lifting the solar panel. The basket may need to be turned upside down to allow the solar puck to fall out. Remove the solar puck and remove the pull tab from the battery compartment. Place the solar puck on top of the basket and turn clockwise to lock it into place. Place the solar light in a location where it can receive a full 8 hours of sunlight to allow the rechargeable battery to reach maximum capacity.
Optimal location for charging:
Place the solar light fixture in an area where it can receive direct sunlight for at least 8 hours each day. Shadowed locations will not allow the battery to charge fully and will reduce the hours of nighttime lighting. The selected location should not be near nighttime light sources, such as porch lights, street lights or pool lights, as these may cause the solar light to turn off prematurely. Use the included ground spike to securely anchor the product in place.

Battery Replacement:

NOTE: This operation should preferably be done in the morning on a bright day. This will allow the lantern to receive a full 8 hours of sunlight so that the rechargeable battery can reach maximum capacity.

Remove the solar puck by turning it counterclockwise. The Product may need to be turned upside down to allow the solar puck to fall out.
Remove the battery cover by unscrewing the three screws.
Remove the old battery and replace it with a new AA size 1.2V rechargeable battery of the same or greater capacity (mAh).

IMPORTANT!!! USE RECHARGEABLE NiMH BATTERIES ONLY!
Note: Clean the battery contacts (if needed) and those of the device prior to battery installation.

Be sure to insert the battery in the proper direction (+/-)
Replace the battery cover on the solar puck and tighten the three screws.
Replace the solar puck by turning it clockwise.

Warning:

Safe for outdoor operation.
Failure to insert the battery in the correct polarity, as indicated in the battery compartment, may shorten the life of the battery or cause the battery to explode or leak.
Do not dispose of batteries in a fire.
Batteries should be recycled or disposed of as per the manufacturer’s recommendations.
Remove the battery if consumed or if the product is to be left unused for a long period.

Care and Cleaning

The solar panels should be cleaned periodically with a damp cloth for maintaining optimum performance (to remove dust and debris). Do not place in areas where children normally play, or where they may trip and fall against the solar lantern.

Notes on Disposal
The product is designated for separate collection at an appropriate collection point. Do not dispose of the product with household waste. For more information, contact the retailer or the local authority responsible for waste management.
Care
Before cleaning the unit, disconnect it, if necessary form other components; do not use aggressive cleaning agents. The unit has been carefully checked for defects. If nevertheless you do have
cause for complaint, please go back to the retailer where you have bought the product together with your proof of purchase. We are not liable for damage arising from incorrect handling, improper use or wear or tear. We reserve the right to make technical modifications.

Safety

General Safety

Read the manual carefully before use. Keep this manual for future reference.
Only use the product for its intended purposes. Do not use the product for other purposes than described in the manual.
Do not use this product if any part is damaged or defective. If the product is damaged or defective, replace the product immediately.
This product shall not be used by children without the supervision of an adult. Children shall not play with the device.
Do not modify the product in any way.
- Do not expose the product to water or moisture. (IP 20)
- Do not immerge the product into water. (IP 44 – IP 67)
Keep the product away from heat sources.
Do not block the ventilation openings.
Do not look directly into the LED lamp.
Keep a minimum distance of 1 meter between the lamp and the surface being illuminated.

Electrical safety

To reduce risk of electric shock, this product should only be opened by an authorized technician when service is required.
Do not use the product if the cable or plug is damaged or defective. When damaged or defective, it must be replaced by the manufacturer or an authorised repair agent.
Before use, always make sure that the voltage is the same as the voltage on the rating plate of the device.
Make sure that the cable does not hang over the edge of a worktop and cannot be caught accidentally or tripped over.

Warning

The light source contained in this luminaire shall only be replaced by the manufacturer or his service agent or a similar qualified person.
Caution, risk of electric shock.
The external flexible cable or cord of this luminaire cannot be replaced; if the cord is damaged, the luminaire has to be destroyed.

Disclaimer
Designs and specifications are subject to change without notice. All logos, brands and product names are trademarks or registered trademarks or their respective holders and are hereby recognized as such. Please visit us online on our website: www.shada.nl For more information about our company and our products,

Documentation
The product has been manufactured and supplied in compliance with all relevant regulations
and directives, valid for all member states of the European Union. The product complies with all
applicable specifications and regulations in the country of sales.
Formal documentation is available upon request. The formal documentation includes, but is
not limited to the Declaration of Conformity, the Material Safety Data Sheet and the product
test report.
CE declaration
This product complies with the following directives: