Honeywell EVS-VCM Voice Control Module Instructions
- June 16, 2024
- Honeywell
Table of Contents
Honeywell EVS-VCM Voice Control Module
Specifications
- Product Name: EVS-VCM Voice Control Module
- Contained within the Silent Knight EVS Series panel enclosure
- Provides a supervised microphone for live communication
- Interface for the Emergency Voice System
- Installation and wiring must be done by NFPA 72 and local ordinances
Product Installation Document
Description
The EVS-VCM Voice Control Module is contained within the Silent Knight EVS
Series panel enclosure. It provides a supervised microphone for live com
NOTE: Installation and wiring of this device must be done under NFPA 72
and local ordinances.
Compatibility
The EVS-VCM is compatible with the following Silent Knight Series FACPs:
- 6820EVS (P/N LS10144-001SK-E)
- 5820XL-EVS (P/N 151209-L8)
NOTE: For programming and DIP switch settings, refer to the FACP Manual.
Specifications
- Standby Current: 70mA
- Alarm Current: 100mA
Board Layout and Mounting
- Open the cabinet door and the dead front panel.
- Remove AC power and disconnect the backup batteries from the main control panel.
- Mount the EVS-VCM in the middle section of the dead front on the six mounting studs. See Figure 1 for hole locations and Figure 4 for board mounting location.
Wiring to an FACP
Figure 2 below shows how to properly wire the EVS-VCM to the FACP SBUS.
Installing the Microphone
- Clip the microphone onto the microphone clip.
- Insert the microphone cord through the hole at the bottom of the dead front panel.
- Attach strain relief clip to microphone cord. The strain relief clip should have about 2.75” of microphone cord through it.
- Push the strain into the hole in the dead front panel.
- Attach the connector to the EVS-VCM board.
- Restore AC power and reconnect the backup batteries.
FAQ
- Q: What is the compatibility of the EVS-VCM?
- A: For programming and DIP switch settings, refer to the FACP Manual.
- Q: Where can I find the installation and wiring instructions for the EVS-VCM?
- A: The installation and wiring must be done in accordance with NFPA 72 and local ordinances. Please refer to the product manual for detailed instructions.
- Q: What does EVS-VCM stand for?
- A: EVS-VCM stands for Voice Control Module.
Honeywell Silent Knight
12 Clintonville Road Northford, CT 06472-1610 203.484.7161
www.silentknight.com
LS10067-001SK-E | C | 02/22 ©2022 Honeywell International Inc.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>