OJA GT001 Portable Steamer for Clothes Instruction Manual
- June 16, 2024
- OJA
Table of Contents
Hand-held
Garment Steamer Instruction Manual
GT001
Garment Steamer Parts
-
Decorative strip
-
Water tank
-
Handle
-
Steam switch
-
Panel
-
Upper cover
-
Display cover
-
Display screen
-
Back cover
-
Power button
-
Wire sheath
-
Bottom cover
-
Brush
-
Anhydrous detection prompt
-
Automatic power-off prompt
-
Large steam prompt
-
Small steam prompt
Before First Use
- Remove any labels or protective covers from the steam head, straighten and straighten the wires before use.
- When using the garment steamer for the first time, let it steam for a few minutes. This will remove any remaining Impurities and odors.
- To avoid circuit overload, it is recommended not to use the same socket circuit with other electrical appliances.
- When unpacking your garment steamer, check the list of all items and parts you received to avoid throwing them away.
Installation and Use
-
Grasp the grooves on both sides of the water tank, pull out the water tank, open the water tank cover, and fill the water tank with water. Make sure the tank is at least one third full of water and not over the top line.
Then put it back in the tank. -
Hold the handle of the steamer with one hand, and install the additional cloth brush on the steam head with the other hand. There will be a “click” sound when installed in the correct position.
-
Connect the device to a power outlet and turn on the power. Press the power button, the LED light on the display screen will flash once in a cycle, then return to the blue light flashing, and the garment steamer will start heating. When the blue light stops blinking and becomes steady on, the warm-up is complete and you can start using it. When the power button is pressed again, the LED light switches to green and flashes, and at this time it is small steam. Long press the power button for 3 seconds, the product will shut down.
-
This product has an intelligent automatic shutdown function. When the user stops using the product for more than a certain period of time, the internal control circuit of the product will cut off the power supply and enter the automatic power-off mode. At this time, the indicator light flashes slowly, and the product stops heating to prevent accidents and save electricity.
-
This product has the function of self-detecting whether there is water. When the water in the water tank is lower than the minimum water level and the water pump cannot absorb water, the water pump will automatically stop within 25-40 seconds, which
will effectively protect the water pump and prevent the water pump from dry pumping, thus improving the service life of the water pump.
Ironing Clothes
Garment steamer is very easy to use and are suitable for ironing
wrinkled/creased garments, drapes, and crisp upholstery on most fabrics.
NOTE: Garment steamer is designed to be used on garments that hang
vertically, avoid using the garment steamer when the garment is in a
horizontal position.
-
Check whether the back of the fabric is breathable, so as not to accumulate steam on the fabric and wet the fabric.
-
Check the clothing pockets to make sure there are no items in the pockets.
-
Check the back of the clothes for any objects that are easily damaged by steam.
-
It is recommended not to use the garment steamer around the metal parts of the clothes, high temperature steam will cause the metal parts to fade.
-
When you press the steam button , you will feel the vibration and hear a subtle buzzing sound which is normal.
-
When ironing, use a fabric brush to gently move up and down on the creases of the fabric to flatten the creases.
-
If you do not use a fabric brush on the steamer, please keep a distance of at least 5 cm between the steam head and the cloth.
-
If the buzzing sound of the steamer becomes louder and there is no steam coming out, it means that the water tank is short of water.
Please check the water level of the water tank and add water to the water tank. -
Release the steam button and the steam will stop.
After Each Use
- Press the power switch or remove the power cable from the power socket when the device is not in use.
- Remove the tank, open the tank inlet cover and (in a sink or bucket ) reverse the tank to empty the remaining water in the tank.
- Place vertically on a flat table and wait for the product to cool.
Care, Cleaning and Storage
- Remove the steam brush on the steam head and clean it with a damp cloth.
- Please do not use harsh or abrasive cleaners or solvents.
- Do not immerse the garment steamer in water or other liquids.
- Do not drop, throw or try to bend it.
- Please do not try to disassemble and disassemble the appliance.
- Empty the water tank after each use.
- Avoid storing electrical appliances in damp places
- Do not place near a heat source or expose the appliance to direct sunlight.
- Always make sure that the steam outlet hole is clean, free from scale , and not blocked.
- It is recommended to store the garment steamer vertically in a flat position, such as in a cabinet.
Do not dispose of waste electrical appliances as unsorted municipal waste, but hand them over to officially designated recycling centres. Doing so is good for the environment.
Troubleshooting Guide
| Problem | Possible solutions |
|---|---|
| Garment steamer does not heat | •Check that the plug is inserted |
correctly.’Check the power supply.
‘Check the power button.
Garment steamer does not produce steam| •Check the water level and that the
tank is properly filled.
‘Press the steam button firmly.
•Leave the garment steamer in an upright position.
Water leaked from the tank| •Make sure the water does not exceed the maximum
water mark.
•Please make sure that the water tank inlet is properly closed.
•Always keep the steamer in the upright position following the operating
instructions provided.
Loud humming or pumping sound when the steam engine is running| •Check the
water level; if there is no water or the water level is low, add water to the
tank.
Avoid discoloration of metal fittings on clothing| •Do not use the garment
steamer directly on metalaccessories.
•Use steam sparingly around metal fittings.
Warning
- Before connecting the product to the power supply, please check whether the voltage marked on the product matches the local power supply voltage.
- Do not use the product if the plug, power cord or product itself has been visibly damaged, or if the product has been dropped or leaked.
- The product can only be sent to the authorized repair center for repair. Do not repair the product yourself, or the product warranty will be void.
- If the power cord is damaged, it must be replaced by the manufacturer, its maintenance department or similar professionals in order to avoid danger.
- When the product is powered on, the user must not leave.
- This product is not suitable for use by children aged 8 or above, and persons with physical impairments, sensory or mental impairments, or lack of relevant experience and knowledge, unless someone supervises or guides them to use this product to ensure their safety use, and make them aware of the associated hazards.
- Do not let children play with this product.
- When the product is powered on or cooling down, keep the product and its power cord out of the reach of children under 8 years old.
- Children aged 8 years or older may clean this product only under supervision.
- Do not touch the steam head and hot surface when using. This product will generate high-temperature steam during use, please do not point it at people or animals, and do not iron the clothes you wear to avoid the risk of burns.
- Before cleaning the product, installing or removing the brush attachment, or filling the water tank, be sure to unplug the power plug first.
Precautions
Before using this product, please read this instruction carefully and keep it properly for future reference.
Danger
- Do not immerse this product in water or other liquids, and do not rinse it under the tap.
- Be careful of the hot steam generated by the garment steamer. Steam may cause burns.
Notice
-
The product can only be used with a grounded socket.
-
If the product is hot/connected to a power source, do not place the product with the steam head in contact with any surface.
-
Regularly check whether the power cord is damaged.
-
During the operation of the product, do not let the power cord come into contact with high-temperature steam.
-
Do not use this product when the water tank is empty.
-
When you leave the product for a short time, please turn off the power of the product and unplug the power plug.
-
After ironing, please be sure to turn off the power and unplug the power plug, and let it cool for 60 minutes before cleaning the product, installing or removing accessories, emptying the water tank or storing it.
-
This product is for household use only. Please do not use this product in the bathroom or outdoors.
-
Do not drag this product on the floor.
-
Steam may damage or cause some walls or doors to discolor.
-
By design, your product is suitable for use with tap water. If you live in an area with very hard water, limescale can build up very quickly.
Therefore, it is recommended to fill the water tank with distilled water to prolong the life of the product. -
Do not inject perfume, vinegar, descaling agent, ironing agent or other chemicals into the water tank, because this product is not suitable for these chemicals.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>