Yibo Electronic K2DONGLE 2.4 Wireless Setup with PC Mac User Manual
- June 16, 2024
- Yibo Electronic
Table of Contents
Yibo Electronic K2DONGLE 2.4 Wireless Setup with PC Mac User Manual
Setup
- Connect the wireless adapter to a USB port on your PC/Mac. The wireless adapter status light will blink Blue, indicating it is waiting for connection.
- Press and hold the power button of the earphone for 2 seconds to turn on the power
- When the wireless adapter status light is blue and the prompt “USB connected” is displayed, it indicates that the earphones are connected (the earphone earmuff LED is white for 10s and on for 1s).
LED Indicator on USB Adapter
Blink Blue: Waiting for connection
Solid Blue: Connected
FCC STATEMENT
- This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
- any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.