GJIA 3600LM LED Wall Packs Light Instruction Manual
- June 16, 2024
- GJIA
Table of Contents
GJIA 3600LM LED Wall Packs Light
Thank you for purchasing our product. Please read the below articles carefully to see how to use this product safely. Warning contents and attention contents related to product safe use, please be sure to follow it.
WARNING
- Risk of Fire, Electrical Shock, Cuts or Other Casualty Hazards-Installation and maintenance of this product must be performed by a qualified electrician.
- This product must be installed by the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved.
- Risk of Fire and Electric Shock-Make certain power is OFF before starting installation or attempting any maintenance. Disconnect power at the fuse or circuit breaker.
- Risk of Fire-Minimum 90℃ supply conductors.
- Risk of Burn-Disconnect power and allow the fixture to cool before handling or servicing.
- Risk of Personal Injury-Due to sharp edges, handle with care.
- Failure to comply with these instructions may result in death, serious bodily injury and property damage.
This product is within the input voltage range: 100-277V, 50/60Hz. If the input voltage exceeds this range, it may cause the lamp to fail. Please be sure to operate under the correct input voltage. Ensure the ambient operating temperature of -35℃-50℃. Using this product in temperatures outside of this range will reduce the product’s lifespan. Make sure to turn off the power before starting the installation process. IP rating of IP65 can work under damp/wet locations. Please keep the product away from any corrosive substance. When you clean it, please use a damp or dry cloth.
Wiring Diagram
Product Dimension
Installation
Step 1: Remove the lens by removing the 2 screws securing it to the rear
housing and set aside.
Step 2: Loosen two screws enough to allow the reflector to slide upward
until the keyhole in the reflector releafrom two screws. Remove reflector.
Step 3: Knock out appropriate holes around the outlet hole in the rear
housing and apply the gasket to the back surface of the housing and fasten the
rear housing to the outlet box using the screws supplied with the outlet box.
Step 4: Complete the wiring to the power source and ground, Using
customer-supplied 90°C minimum rated wire connectors, make the following
electrical connections in the mounting box or junction box:
- Connect the black fixture lead to the voltage supply lead
- Connect the white fixture lead to the neutral supply lead
- Connect the ground lead to the supply ground lead.
- To ensure rain tight seal, apply silicone caulking around the back edges of the fixture.
Step 5: Replace reflector.
Step 6: Replace the front housing by reversing the procedure used to
remove it.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>