giorni 8937 Circuit Breaker Instruction Manual
- June 16, 2024
- giorni
Table of Contents
INSTALLATION INSTRUCTIONS
Model # 8937
READ AND SAVE THESE INSTRUCTIONS
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
PREPARING FOR INSTALLATION (Fig. 1)
-
Shut off power at the circuit breaker and remove the old fixture including the mounting hardware.
-
Carefully unpack your new fixture and lay out all the parts in a clear area. Take care not to misplace any small parts necessary for installation.
-
Attach crossbar (B) using outlet box screws (C) to the outlet box (A). (Fig 1)
CONNECTING THE WIRES (Fig. 2)
-
Connect the electrical wires as shown in Fig.2.
Making sure that all wire connectors are secured. If your outlet box has a ground wire (green or bare copper), connect the fixture’s ground wire to it.
Otherwise, connect the fixture’s ground wire directly to the single bar using the green screw (D) provided.
COMPLETING THE INSTALLATION (Fig. 1) -
To prevent moisture from entering the outlet box (A) and causing a short, use clear silicone sealant to outline the outside of fixture back plate (G) where it meets the wall leaving a space at bottom to allow moisture a means to escape.
-
Align back plate (G) onto nipple (E) and secure cap nut (F)(Fig 1).
-
Install 1*°7100W/E26/A bulb (not included) in accordance with the fixture specification—DO NOT EXCEED THE MAXIMUM WATTAGE RATING! (NE PAS DEPASSER LA PUISSANCE NOMINALE MAXIMALE!)
Your installation is now complete. Return power to the outlet box and test the fixture.
“CAUTION-RISK OF FIRE CONSULT A QUALIFIED ELECTRICIAN TO ENSURE CORRECT BRANCH CIRCUIT CONDUCTOR”
© Minka Lighting Inc.
This product is protected by United States Federal and/or State Law, including
Patent and/or Copyright laws.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>