TOPENS TC102 Photocell Beam Sensor User Manual
- June 4, 2024
- Topens
Table of Contents
TOPENS TC102 Photocell Beam Sensor User Manual
Definition of the terminals
Wire connection:
Please refer to the user manual of the gate opener for wire connection.
Install the PBS Switch:
Note: Install the PBS Switch over the height of 20cm. Install the
receiver not less than 3m away from the emitter. Vertically install the PBS
Switch and keep both emitter and receiver at the same level.
The wires output direction of the PBS Switch must be down so as to avoid water
ingress. . The user is recommended to add a rubber ring between the PBS Switch
and the Mounting Board (not provided).
Note: With strong power, the PBS Switch may fail if the receiver is too close to the emitter. Take the receiver at least 1m away from the emitter and try again. Remove the condenser lens in both emitter and receiver if the distance is too close and the PBS Switch is not so sensitive. The PBS Switch should be sheltered from direct sunlight.
Support
TOPENS Website
http://www.topens.com/
Any question, please do not hesitate to contact us:
E-mail: support@topens.com
Kindly include your Product Model, Purchasing Date & Site, Order #, and your
contact information. All your concerns will be replied within 24 hours.
Tel: +1 (888) 750 9899 (Toll Free USA & Canada
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>