PSA Products INT27DSKP Door Bell with Access User Guide
- June 15, 2024
- PSA Products
Table of Contents
PSA Products INT27DSKP Door Bell with Access
Product Information
Specifications
- Input Voltage: 12-15VDC
- Current: Standby: 30mA, Working: 70mA
- RFID Tag Frequency: 13.56 MHz Mifare
- Maximum RFID Capacity: 200 (000-199)
- Maximum User PIN Codes: 200
- Resolution: PAN921SCKP: 720P, INT27DSKP: 1080P
- Viewing Angle: Not specified
Wiring Diagram
- RED = 12VDC
- WHITE = AUDIO
- YELLOW = VIDEO
- BLACK = GND
- ORANGE = COMMON
- PURPLE = 12VDC
- GREY = GND
- POWER Power Supply
- GREEN = N/O
- BLUE = EGRESS OPEN
- BROWN = N/C
- MASTER MONITOR
- TV-OUT
- POWER Power Supply
- DOOR1 CAM1 IN TO DOOR2
- DOOR2 CAM2 OUT
- TV-OUT
- POWER Power Supply
- DOOR1CAM1 IN
- DOOR2CAM2 OUT SLAVE MONITOR
WIRING DIAGRAM
SPECIFICATIONS
NOTE: User PIN Codes can only be programmed together with a KEYFOB. If no KEYFOB is used, only the Public Access Code can be used.
CODE PROGRAMMING
Programming code definitions:
- Programming code = P
- New code entry =N
- Access code = A
- User code = U
NOTE: codes cannot be sequential or all the same digit, eg. 111111 or 123456 will not work
a. Changing Programming Code (Default is 999999)
b. Changing Public Access Code (Default is 123456)
c. Setting lock output time
KEY FOB PROGRAMMING
a. Setting Programmer FOB’s
- The plus and minus printed on the Fobs are for convenience, any FOB can be set as programming FOBS.
b. Adding User FOB’s using Programming FOB’s
c. Removing User FOB’s using Programming FOBs
CHANGING USER ACCESS CODES
HARD FACTORY RESET
- Disconnect power
- Short the blue & grey wires and reconnect power
- Keypad will beep 3 times
- Remove the short from blue & grey wires
SOFTWARE FACTORY RESET
NOTE : Sections 5 & 6 procedures do not delete the FOBs or User Access Codes
REMOVE ALL USER FOBS AND USER CODES
NOTE : Does not remove Programming FOBs. Programming FOBs can only be replaced.
17 Millicent Street, Burwood, VIC 3125 Australia
- Tel: 1300 772 776
- Fax: (03) 9888 9993
- enquiry@psaproducts.com.au
- psaproducts.com.au
Produced by PSA Products (www.psaproducts.com.au). Version 2.1 (Nov 2023)
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>