DAEMA DFZ-355SCWB Display Showcase Instruction Manual

DISPLAY SHOWCASE
INSTRUCTION MANUAL
DFZ-355SCWB
Please read The operation manual before using

NAME OF PARTS

1. Light Box
2. light switch
3.handle
4.shelf
5.door
6.water draining hole
7.door pad| 8.foot screw and wheel
9.innerlight
10. Fan
11.evaporator
12.glass
13. Hot Air Outlet
14.thermostat
---|---

THE FUNCTION OF CONTROL PANEL:

1. the figure on the thermostat 1-7 only indicates the temperature level from high fo low, it does not means any specific temperature.

MAINTENANCE!

1. D0 not open the door frequently and too long to save energy.

2. Neverleave heavy or hot objects on top panel or the showcase to avoid deforming.

3. Cut off the power before cleaning.

4. 7o clean the showcase please use soft cloth dampened in some moderate detfergent.
   After cleaning .wipe in dry .never use all kinds of detergent and hot water

5. Use warm water fo clean oil fruit juice stain on the magnetic gasket in order fo keep ifs elasticity,

6. The showcase should not be left unused for a long fime to stop using the showcase ,disconnect the main power first, then clean the inside and leave the door open for 2-3days todry it.

ATTENTION

Young children or infirm person should be supervised when using the appliance.
Young children should be supervised fo ensure that they does not play with the appliance.
*We have a policy of confinuous improvement on our products and reserve the right to change materials and specifications without nofice.
To confirm the specific parameters ,please according o the rated label on the product.
THE FOLLOWING PHENOMENA ARE NORMAL:

1. There will be sound of flowing water when the refrigerant is running.
2. When the envionment humidity is foo high there will be dew condensed on the surface of the showcase.
3. While working .the condenser and the compressor will be hot.

USE OF WHEELS AND FOOT SCREWS
You can use the brakes on the wheels and/or the foot screws to stop moving of the showcase.
Remember fo lift the brake andfor turn foot screws clockwise when moving the showcase

TRANSPORTATION AND INSTALLATION INSTRUCTION

1. when you transport the showcase, the angle between the compariment body and the ground should be no less than 45°, and you should never place the showcase upside-down.
2. Do not use any of the external part as loading points, such as the door,
3. when the showcase is installed or used, the entire package(Including board and foam plastic) should be got rid of.
4. Keeping the showcase stable fo avoid vibration and noise.
5. The showcase should be installed in fhe place with good ventilation, A space of atleast 10cm should be allowed between the surrounding wall and the cabinet wall for air circulation.
6. It should be placed for form heating resource and not under direct sunshine to avoid decrease of the efficiency of refrigeration
7. Install the showcase in a dry place so as fo prevent rust on the compartment body, which may affect the electric insulation.

Cautions

1. The showcase must be grounded firmly-the ground wire should not be connected fo the heating pipe and gas pipe
2. In case the power cord or plug is damaged, please ask the maintenance worker fo change it, do not do it by yourself, hand the plug carefully when pull of insert it, do not pull the wire,
3. Please do not use the same socket with other appliances.
4. In case voltage provided by your regional power supply could not meet this requirement, please use a safe automatic voltage regulator.
5. Connecting the power o check the showcase before using, The showcase can be used when the temperature decreases obviously affer 30 minutes,
6. Adjust the dial according fo the real room temperature, the quantity of the foodstuff stored.
7. Hot food should be stored only affer it is completely cold.
8. If power cut-off is needed, you should wait for at least 5 min before plugging in gain fo avoid damage to the compressor.
9. Packing foods with plastic bag to avoid tastes mixing and frost.
10. Never put flammable, explosive and corrosive liquid or gas inthe showcase.

Trouble shooting:

The protector or the fuse has broken off
The power is off| Fit the plug well
Change the fuse
Big noise| The placing base is too soft, or the unit is inclining
The wheels do not touch the floor well
The cabinet is too close to the wall
There are other objects directly touching the unit| Mount wood at the bottom
Adjust the wheel screw
Keep a certain distance from the wall
Take the objects away
There are smells inside the unit| The cool air exit is blocked
Food with strong smell is not packed| Take away the food near to the exit
Pack the food well
The compressor does not stop| The food temperature is too high or there are too much food inside
Open the door too frequently or the door is not well closed
Directly under the sunshine or too close to the heat resource
The ventilation is not good| Put the food in after cooling or reduce the quantity
Close the door tightly
Keep off the heat resource
Keep certain space for ventilation

Remark: iyoucannot solve the troubles according fo the above-mentioned ways, please contact the affer service centres, do not hande it yourself.

Refrigerant

The refrigerant isobutene (R600a) is contained within the refrigerant circuit of the appliance, anatural gas with a high level of environmental compatibility, which is nevertheless flammable.
During transportation and installation of the appliance, ensure that none of the components of the refrigerant circuit becomes damaged.
If the refrigerant circuits become damaged:
Avoid open flames and sources of ignition.
Thoroughly ventilate the room in which the appliance is situated.
Warning ; Risk of fire/flammable materials

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>