KIBTOY 3608214 Solar Security Light Motion Sensor Instruction Manual

KIBTOY 3608214 Solar Security Light Motion Sensor

Dear Customer: Thank you for purchasing our products. If you need any help, please feel free to contact us, at our email address:
service01@kibtoy.com

We provide 12 month warranty.
Thanks and best regards.

Notes & Precautions

1. After the switch is turned to the “ON” position, the wall light only illuminates when the ambient light level is below 20 Lux and there is human movement is detected.
2. The number of uses depends on the amount of electricity stored during the daytime, which is affected by the intensity and duration of sunlight.
3. Temperature affects the sensitivity of the PIR sensor, causing the detection range to vary. The higher the temperature is, the shorter the detection range will be.
4. If the light fails to light up after* days of continuous rainy or cloudy weather, it is because the battery has been exhausted. The light will function normally again at night after a sunny day.
5. Please turn the switch off; If the lamp doesn’t work, please install the lamp in a location exposed to direct sunlight, and charge it for 6-8 hours before 1st time use.
6. The light source of this luminaire is not replaceable; when the light source reaches its end of life the whole luminaire shall be replaced.

Tast

1. Turn on the switch first;
2. Cover the solar panel before the test
3. Put the lamp under the sun for 6-8 hours, if it doesn’t work.

Specification

• 6W, 70 LEDs, Lithium-ion battery 3.7V DC, 1500 mAh 18650
• 1.62A, 6500K, IP65, ABSIPCIPE,-25°CC-40 °C/-13 °F-104 °F

Light mode
Please push to the left to start the switch for first use, it will be on when people approach the light, and it will be off after about 20 seconds when people leave the light.

Various angles can be adjusted

1. The lamp can be rotated to the left or to the right by 75 degrees, (Please do not directly turn to one side over 75 degrees). The lamp can be rotated up and down by 135 degrees.
2. The two lights attached to the left and right can be rotated forward and backward by 135 degrees, and up and down by 90 degrees.
3. Caution: All rotating parts should not be rotated at too large an angle, which might cause disconnection of the internal circuit.

Product List

Installation Instructions

1. Remove the bottom of the solar sensor light.
2. Punch holes in the marked positions.
3. with a nan wall plug into the to-dine hole.
4. Align the bracket to the hole, and use a Phillips screwdriver to fix the screw on the bracket.
5. The bracket is installed.
6. Finally, install the lamp on the fixed bracket.
7. Assembly Completed.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>