Whirlpool W11476234A Front Load Washer Owner’s Manual
- June 15, 2024
- Whirlpool
Table of Contents
Whirlpool W11476234A Front Load Washer Owner’s Manual
IMPORTANT: Dimensional specifications are provided for planning purposes only.
ELECTRICAL REQUIREMENTS
WARNING: To reduce the risk of fire, electric shock, or injury to persons, read the IMPORTANT SAFETY INSTRUCTIONS and INSTALLATION INSTRUCTIONS, located in your appliance’s Owner’s Manual, before installing and operating this appliance.
Electrical Requirements
WFW862CHC| 4.3 cu ft DOE (US)/5.0 cu ft IEC (CAN)
Minimum Circuit Amperage Rating| 15 A
Maximum Ampere Draw| 10.36 A
Operating Voltage| 120 V AC only
Operating Frequency| 60 Hz
PRODUCT DIMENSIONS
| WFW862CHC | 4.3 cu ft DOE (US)/5.0 cu ft IEC (CAN) |
|---|---|
| Unit of Measurement | in (minimum) |
| (maximum)** | mm (maximum) |
| Height (with feet) (A) | 385∕8 |
| Product Width (B) | 27 |
FRONT VIEW
| WFW862CHC | 4.3 cu ft DOE (US)/5.0 cu ft IEC (CAN) |
|---|---|
| Unit of Measurement | in (minimum) |
| (maximum)** | mm (maximum) |
| Door Width (C) | 2511∕16 |
| Product Depth (D) | 319∕16 |
| Product Depth with Door Open (E) | 547∕8 |
| Door Height (F) | 2511∕16 |
| Height to Bottom of Door (G) | 91∕2 |
SIDE VIEW
| WFW862CHC | 4.3 cu ft DOE (US)/5.0 cu ft IEC (CAN) |
|---|---|
| Unit of Measurement | in (minimum) |
| (maximum)** | mm (maximum) |
| Position of Power Cord (H) | 355∕16 |
| Power Cord Length | 72 |
| Position of Water Inlet Valves (I) | **** 355∕16 |
| Position of Drain Hose (J) | 8 |
| Drain Hose Length | 52 |
| Diameter of Drain Hose | 1 |
BACK VIEW
All Dimensions show recommended spacing allowed, except for closet door
ventilation openings which are minimum required.
This washer has been tested for installation with spacing of 0″ (0 mm)
clearance on the sides. Consider allowing more space for ease of installation
and servicing, and spacing for companion appliances and clearances for walls,
doors, and floor moldings. Add spacing of 1″ (25 mm) on all sides of washer to
reduce noise transfer. If a closet door or louvered door is installed, top and
bottom air openings in door are required.
*For additional details (or information) specific to your model, refer to your Quick Start Guide.
CUSTOM UNDER COUNTER INSTALLATION
RECESSED AREA OR CLOSET INSTALLATION
NOTE: All 27″ wide washers should have 19″ clearance, while all 29″ wide washers should have 22″ clearance.
TM ©2020 Whirlpool. All rights reserved. Used under licence in Canada.
