Walmart A18 Collapsible Quadcopter Mini Drone Instruction Manual

Walmart A18 Collapsible Quadcopter Mini Drone

Limited to the original factory equipped with a charger (USB) for charging. Do not leave when charging. The battery should be stored in a cool place to avoid exposure to the sun.

2.4 GHZ EDITION
Read the manual completely before use (please read the caution and warning section). Save this manual for future reference.

Important safety information

1. This product is not a toy, but a precision device that integrates professional knowledge such as machinery, electronics, aerodynamics, and high frequency. It needs correct assembly and debugging to avoid accidents. The product holder must use a safe way to operate and control; improper operation may cause serious personal injury or property damage. We are not responsible for this because we cannot control the process of assembly, use, and operation.

2. This product is suitable for people who have experience in operating models and are not less than
   14 years old.

3. The flight site must be a local legal remote control model flight site.

4. Once the product is sold, we will not be responsible for any safety arising from operation, use, control, etc.

5. In case of problems such as use, operation, and maintenance, we entrust the distributor to provide technical support and after-sales service, please contact the local distributor.

Safety Precautions:
The remote-controlled model aircraft is a high-risk commodity, so keep away from the crowd when flying. Improper human assembly or damage to the fuselage, poor electronic control equipment, and unfamiliar operation can all lead to unpredictable accidents such as damage to the aircraft or personal injury. Pilots must pay attention to safety and understand the responsibilities caused by their own negligence.

1. Keep away from obstacles and crowds
   The RC aircraft has uncertain flight speed and state when flying, and there is a potential danger. When flying, you must stay away from crowds, high-rise buildings, high-voltage power lines, etc. At the same time, avoid flying in bad weather such as wind, rain, lightning, etc., to ensure the safety of pilots, surrounding people, and property.

2. Keep away from the humid environment
   The interior of the aircraft is composed of many sophisticated electronic originals and machinery, so it is necessary to prevent moisture or moisture from entering the body to avoid accidents caused by the
   failure of mechanical and electronic originals.

3. Safe operation
   Please operate the remote control aircraft according to your own status and flying skills. Fatigue, mental insufficiency, or improper operation will increase the probability of unexpected risks.

4. Keep away from high-speed rotating parts
   When the propeller is flying at high speed, please keep the operator, surrounding people, and objects away from the rotating parts to avoid danger and damage.

Lithium battery precautions
Lithium batteries are different from ordinary batteries in that they are surrounded by a thin layer of tin foil with chemicals. This can greatly reduce its weight, but it makes it more vulnerable
to explosion rough or inappropriate operations. Like all batteries, improper operation can cause fire and

1. Do not put the battery in the model for charging, it may cause the battery to catch fire and cause losses;
2. If you plan not to use this product for a week or more, please let the battery retain 50% of the power to increase the battery life. Let the battery retain 50% of its power and only need half of the time required to fully charge the battery to charge it;
3. Please use the professional charger provided by the factory to charge the battery;
4. Do not charge on the carpet to prevent fire;
5. Lithium batteries need to be charged after being stored for more than three months to maintain the voltage and ensure their due life.

Battery installation and charging instructions

1. Remote control battery installation

2. Lithium battery charging

3. Remove the aircraft battery from the aircraft fuselage;

4. Connect the battery to the dedicated punching wire, and then insert the punching wire into the computer USB port and other punching equipment;

5. Lights up in red when charging, and lights out when full.
   Charging time is about 80-100 minutes

6. Aircraft battery installation and startup
   Insert a fully charged battery into the battery compartment of the aircraft, and press and hold the power switch until the aircraft lights come on.

Aircraft installation

1. Folding function

2. Aircraft blade installation
   Please install the propeller in the direction of the picture on the right, and be sure to tighten the screws after installing in place.

3. Installation of aircraft protection frame
   Align the protective frame with the position of the aircraft’s boom ( as shown in the figure) and install and fasten it.

Remote control function description

Note:
Push the dual joysticks outward to calibrate, calibrate the gyroscope, and push the dual joysticks inward to unlock

Remote control

1. Mobile phone hanger
   Open the remote control phone holder and clamp the phone.

2. Pair the remote control with the aircraft
   Turn on the power switch of the aircraft, and place the aircraft on flat ground, the aircraft indicator light flashes at this time, turn on the power switch of the remote control, push the power control lever to the highest position for 1 second, and then pull it to the lowest position, the buzzer sounds a prompt, The aircraft indicator light keeps on indicating that the pairing is complete, and you can control it at this time.

3. One-key take-off and One-key landing
   Tip: This product is set by the barometer. Due to various environmental temperatures and other factors, it is normal for the aircraft to change in height when starting flight or at low voltage.
   Must be operated after pairing is completed

4. Flight control

   • Throttle (left stick)
   • Rotate left and right (left rocker)
   • Forward and backward (right stick)
   • Side fly (right stick)

5. Fine adjustment control

Headless mode direction definition and mode selection

When switching to headless mode, the aircraft will give up its front, back, left, and right directions, and take the aircraft’s nose direction (with the camera side) as the forward direction when pairing.

1. Definition of the direction before takeoff: place the aircraft’s forward direction directly in front of you (with the camera side ), then turn on the remote control to pair, and then complete the flight headless mode direction definition.
2. Press the headless mode key while flying, the remote controller will continue to make a sound, and the aircraft lights will flash quickly to enter the headless mode; press the headless mode key again, the remote controller will make two sounds to exit the headless mode.

Obstacle avoidance is turned off by default

• Press the short-press obstacle avoidance mode button after opening the aircraft Under the condition that flight speed is one gear,
• Start the obstacle avoidance induction mode, second gear and third gear, and automatically Turn off the obstacle avoidance mode or press the obstacle avoidance switch briefly again to turn it off

One-key return

Short press this button, the aircraft will fly in the backward direction defined in headless mode, and the function will stop automatically when the right stick is operated.

• This function can only automatically retreat, not automatically return to the take-off point and stop.

Speed selection

There are three speeds for forward, backward, and left and right side flight. The remote controller defaults to slow speed when the power is turned on. After pressing the speed key, two sounds are given for mid-range speed, three sounds are for fast speed, and one sound returns to slow speed. (Recommended for beginners to use slow speed operation)

Aircraft calibration and emergency stop

When the novice is operating the aircraft, if the flight is unstable after takeoff and slowly drifts in one direction, the gyro level correction function can be used to correct the aircraft. As shown in the picture on the right, after the start-up pairing is completed, the aircraft is placed on flat ground, the remote control handle is turned to the right at the same time, the buzzer sounds a reminder, and the aircraft light flashes and then lights up, indicating that the calibration is complete.

Emergency stop

1. When the aircraft tilt angle exceeds 60 degrees, the aircraft will stop rotating;
2. When the propeller is stuck, it will automatically stop the motor rotation;

Step:

1. Press the flip key once, and the remote controller will continue to sound
2. Push the right stick, and the aircraft will roll 360 ° according to the direction of the right stick

When the aircraft enters a low voltage state, the 360° roll function is automatically disabled.

Problem-Solving Guidelines

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>