LED s light 1000435 RGB Solar Path Lighting Punk Instruction Manual
- June 4, 2024
- LED s light
Table of Contents
LED s light 1000435 RGB Solar Path Lighting Punk
Introduction
Please read this instruction carefully before use.
Initial charging:
If the solar panel is covered with a thin protective film, remove it before
using the product. Remove the ground spike by holding the solar unit firmly
and turning the ground spike counter clockwise, as shown in 
and remove the pull-tab from the battery
compartment. Replace the ground spike, and turn it clockwise to lock it.
Place the product in a location where it can
receive a full8 hours of sunlight to allow the rechargeable battery to reach
maximum capacity.
Optimal location for charging:
here it can receive direct sunlight for at least 8 hours each day. Shadowed locations will not allow the battery to charge fully and will reduce the hours of nighttime lighting. The selected location should not be near nighttime gnt sources, such as porch lights, street lights or pool lights, as these may cause the solar light to turn oft prematurely.
operation
duct has two distinct modes of operation, selectable by means of the mode. switch the mode switch has three positions:
- OFF-turns the device off, it will not light at all
- ON-when darkness talls, the product will start to spread a warm white light (2.700K)
- RGB-when darkness falls, the product will start to slowly phase through all the colours of the rainbow, gently flowing from one to the other. When fully charged, the product will ight up tor 6-8 hours.
Battery Replacement:
NOTE
This operation should be done in the morning on a sunny day This will allow
the product to receive a full 8 hours of sunlight so that the rechargeable e
battery can reach maximum capacity.
- Remove the ground spike by turning it counterclockwise.
- Remove the old battery and replace with a new AAA size 1.2V rechargeable battery E PECHARCEARLF NiMH (HRO3) BATTER ONLYI)
Note:
Clean the battery contacts and those of the device prior to battery
installation.
- Be sure to insert the battery in proper direction (+/.
- Replace the ground spike on the solar puck.
Warning:
- Safe for outdoor operation.
- Failure to insert battery in the correct polarity, as indicated in the battery compartment, may shorten the life of the battery or cause battery to explode or leak.
- Do not dispose of batteries in fire.
- Batteries should be recycled or disposed of as per manufacturer’s recommendations
- Remove battery if consumed or if product is to be left unused for a long period.
Care and Cleaning:
Solar panel should be cleaned periodically with damp cloth for maintaining
optimum performance (to remove dust and debris). Do not place in areas where
children normally lay, or where they may trip and fall against the solar
lantern.
Notes on Disposal
The product is designated for separate collection at an appropriate collection
point. Do not dispose of the product with household waste. For more
information, contact the retailer or the local authority responsible for waste
management.
Care
Before cleaning the unit, disconnect it, if necessary form other components;
do not use aggressive cleaning agents. The unit has been carefully checked for
defects. If nevertheless you do have cause for complaint, please go back to
the retailer where you have bought the product together with your proof of
purchase. We are not liable for damage arising from incorrect handling,
improper use or wear or tear. We reserve the right to make technical
modifications.
Safety
General Safety
- Read the manual carefully before use. Keep this manual for future reference.
- Only use the product for its intended purposes. Do not use the product for other purposes than described in the manual.
- Do not use this product if any part is damaged or defective. If the product is damaged or defective, replace the product immediately.
- This product shall not be used by children without the supervision of an adult. Children shall not play with the device.
- Do not modify the product in any way.
- Do not expose the product to water or moisture. (IP 20)
- Do not immerge the product into water. (IP 44 – IP 67)
- Keep the product away from heat sources.
- Do not block the ventilation openings.
- Do not look directly into the LED lamp.
- Keep a minimum distance of 1 meter between the lamp and the surface being illuminated.
Electrical safety
-
To reduce risk of electric shock, this product should only be opened by an authorized technician when service is required.
-
Do not use the product if the cable or plug is damaged or defective. When damaged or defective, it must be replaced by the manufacturer or an authorised repair agent.
-
Before use, always make sure that the voltage is the same as the voltage on the rating plate
of the device. -
Make sure that the cable does not hang over the edge of a worktop and cannot be caught accidentally or tripped over
Warning
- The light source contained in this luminaire shall only be replaced by the manufacturer or his service agent or a similar qualified person.
- Caution, risk of electric shock.
- The external flexible cable or cord of this luminaire cannot be replaced; if the cord is damaged, the luminaire has to be destroyed.
Disclaimer
Designs and specifications are subject to change without notice. All logos,
brands and product names are trademarks or registered trademarks or their
respective holders and are hereby recognized as such. Please visit us online
on our website: www.shada.nl For more information about
our company and our products
Documentation
The product has been manufactured and supplied in compliance with all relevant
regulations and directives, valid for all member states of the European Union.
The product complies with all applicable specifications and regulations in the
country of sales. Formal documentation is available upon request. The formal
documentation includes, but is
not limited to the Declaration of Conformity, the Material Safety Data Sheet
and the product test report.
CE declaration
This product complies with the following directives:
LVD: 2014/35/EU
EMC: 2014/30/EU
RoHS: 2011/65/EU
Additionally, for Products with Radio transmitter units:
RED: 2014/53/EU
The complete Declaration of Conformity Document (DOC) can be found here:
http://www.shada.nl/uploads/DoCs/index.html
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>