CAIROCK Ceiling Fans with Lights Remote and App Control User Guide
- June 15, 2024
- CAIROCK
Table of Contents
CAIROCK Ceiling Fans with Lights Remote and App Control
Installation instructions
Accessories diagram
small hanging cup 2big hanging cup 3light @blades (5 pieces) Slight cover
Glong hanging lever short hanging lever 8hanging bracket 9motor lamp tray I
controller remote control 13 wire cap 14self-tapping screw 15 expansion screws
Assemble the blades
Remove the 10 marked screws from the motor (9) to prepare for assemble the blades
Assemble the blades (4) with the 10 screws to the motor (9)
Assemble the blades with the 10 screws like this
Assemble the lamp tray (10)
Firstly remove the marked 3 screws from the motor
Secondly, prepare these parts
Assemble the lamp try 10) to the motor (9) with the 3 screws that just removed in last step.
Connect the wires from the light (3) to the wires on the bottom of the motor (9).
Assemble the hanging parts
the small hanging cup(O), the big honing cup (2), a hanging lever (either 6 or 0 as per your requirements)
Firstly, remove the needle at the bottom of the lever; Secondly, thread the 2 hanging cups (• & 2) into the lever from the bottom of lever to the top like the picture shows.
Make the wire on the motor go across the lever like the picture shows
Insert the lever into the motor, then insert the needle/pin, and secured with the screws
Assemble the light cover (5)
Align the light cover (5) and put it on, gentlely rotate the cover and tighten it securely with the lamp tray (10)
Assemble the hanging bracket (8)
on your ceiling or roof with the Expansion Screws (15).
between leach hole shing matizehe hanstance bracket.
Hammer the 4 expansion screws into the holes you just drilled.
Assemble and tighten the hanging bracket.
Put the ceiling fan which well assembled on the hanging bracket, gentely rotate the lever to make it perfect fixed on the bracket.
Connect the wires on the controller (1) with the ceiling fan and your L & N line.
Put the controller on the bracket after all wires well connected
Sort the wires and push the big hanging cup to the top to cover all the wires and parts. Gently rotate and tighten the cup and lever.
Fix and tighten the screws outside the big hanging cup 2 to avoid it wobbling.