ruarkaudio R1MK4 Bluetooth Radio User Manual
- June 15, 2024
- ruarkaudio
Table of Contents
R1MK4 Bluetooth Radio
User Manual
For US model only
FCC ID: 2AJAA-R1MK4
FCC Warnings
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment.
This equipment should be installed and operated with a minimum distance of
20cm between the radiator and your body.
CAUTION
The internal battery is non-replaceable and there is a risk of fire or
explosion if replaced by an incorrect type.
Important information about the AC power adapter
Model DYS824-140150W-K
Input 100-240V~50/60Hz, 0.7A MAX
Output 14.0VDC 1.5A
Class II, Efficiency Level VI
- This AC adapter is for audio & video equipment use only and complies with IEC 62368 safety standard.
- The supplied 3-pin plug adapter complies with BS 1363-1 and the supplied 2-pin plug adapter complies with EN 50075.
- Before using the AC adapter, ensure the mains voltage is within the rated supply voltage range.
- The output power taken from this AC adapter must not exceed its rated output power.
- DO NOT disassemble or modify the AC adapter.
- DO NOT drop or throw the AC adapter.
- The external flexible cable cannot be replaced and if the cord is damaged, the AC adapter must be replaced.
- DO NOT expose the AC adapter to dripping or splashing water, and do not place objects filled with liquids, such as vases, on or near the device.
- DO NOT leave the AC adapter in a hot location, such as near fire or under strong sunlight.
- DO NOT cover ventilation openings on the device.
- Unplug the AC adapter during lightning storms or when unused for long periods of time to prevent damage.
- Ensure that the AC adapter is readily accessible when plugged into the mains. If an abnormal condition occurs while using it, immediately turn off the connected device and disconnect the mains adapter from the mains.
- DO NOT dispose this AC adapter as general household waste or unsorted municipal waste, dispose of it according to local regulations.
Setup wizard
Follow the setup wizard to configure your R1.
Rotate the CONTROL KNOB until your preferred choice is shown, then press the
CONTROL KNOB to SELECT.
If you live in a region without DAB/DAB+, you can choose to disable DAB. To
enable it again, simply reset the system and enable DAB during the setup
wizard.
Need more help?
For more information, see
www.ruarkaudio.com/support
Controls
-
STANDBY
-
CONTROL KNOB / SELECT
Rotate to adjust volume from a Now Playing screen.
Rotate to browse menus or station lists.
Press to SELECT.
Press to SNOOZE a sounding alarm. Press it again to
increase the snooze time or press and hold to cancel. -
press to skip to next station or track, press and hold to fast forward a track or seek next FM station.
In standby, press to increase display brightness. -
press to skip to previous station or track, press and hold to rewind a track or seek the previous FM station.
In standby, press to decrease display brightness. -
PRESET – press to recall a saved DAB/FM station or press and hold for two seconds to save a radio station.
-
SOURCE – press to change audio source.
-
press to play/pause a track or mute audio.
-
MENU – press to view the options menu, press to go back to previous screen when already in a menu.
-
ALARM / SLEEP – press to set an alarm or timer, press and hold to set sleep timer.
-
LED – indicates radio is on and flashes when Bluetooth is ready to connect or pair.
Tips
You can also press or to browse menus, sources or station lists.
Currently saved settings are highlighted with solid angle brackets, ◀Radio▶
text .
Press = tap or press and immediately release.
Press and hold = press and release after two seconds.
Specifications
Amplifier and driver
75mm Ruark NS+ driver
9W Class AB amplifier
Connectivity
DAB, DAB+
Multiregional FM Tuner with RDS
Bluetooth V4.2 SBC, AAC, BLE, A2DP
Line input 3.5mm jack (1.4Vrms max)
Headphone 3.5mm output jack (6Ω)
USB C 2.0, (5V 1A) MP3, AAC up to 48kHz 320kbps,
FLAC up to 24-bit 96kHz, WAV up to 24-bit 96kHz,
WMA up to 44.1kHz 320kbps
Features
High-contrast OLED with auto dimming
Real time clock with internal battery backup
Kensington compatible security slot
Power adapter
100-240V AC, 50-60Hz input, 14V DC 1.5A output
Dimensions
H175 x W130 x D135mm (6.9 × 5.1 × 5.3in) 1.4kg (3.1lbs)
Specification and design subject to change.
Troubleshooting
For help with your product, please refer to the FAQ (Frequently Asked
Questions) page in the support area of our website
www.ruarkaudio.com/support.
If you accidentally select the incorrect language you can factory reset your
radio by pressing and holding the standby key for 10s with your radio in
standby.
(Quick reset not available on all models.)
Regulatory information
** This device is labelled in accordance with European Directive 2012/19/EU
concerning waste electrical and electronic equipment. This symbol indicates
that the product or associated batteries should not be disposed of as general
household waste. As with any electrical equipment, please dispose of it
according to local regulations.
CE COMPLIANCE INFORMATION
This product conforms to all EU Directive requirements as applicable by law.
Hereby, Ruark Audio, declares that this device complies with the essential
requirements and other relevant provisions of the European Radio Equipment
Directive 2014/53/
EU. You can download the full CE Declaration of Conformity at
www.ruarkaudio.com/doc/R1mk4doc.pdf
UK CONFORMITY ASSESSMENT INFORMATION**
This product conforms to all UK Conformity Assessment regulations as
applicable by law. You can download the full UKCA Declaration of
Conformity at
www.ruarkaudio.com/doc/R1mk4UKCA.pdf
Safety information
- Read this user guide and follow all instructions, it will help you set up and operate your product properly.
- Heed all warnings and keep this user guide for future reference.
- Do not attempt to use a damaged device as this could result in a dangerous electric shock.
- Do not open the unit or remove any panels to expose the electronics. No user serviceable parts inside.
- Refer all servicing to qualified service personnel. Servicing is required when the device has been damaged in any way, such as when any power cord, or power plug is damaged, liquid has been spilled or objects have fallen into the device, the device has been exposed to rain or moisture, does not operate normally, or has been dropped.
- This device is intended to be operated ONLY from the AC voltages listed on the back panel or included AC mains adapter. Operation from voltages other than those indicated may cause irreversible damage to the device and void the product warranty.
- Ensure that the mains plug or mains connector into the unit is readily accessible in case disconnection from the mains is required.
- The AC mains adapter, mains plug, or mains connector must be removed from the socket to completely disconnect the system from AC mains power.
- Do not place any naked flame sources, such as lighted candles, on or near the device. Do not install near any heat sources such as radiators, stoves, or other devices that produce heat.
- Avoid exposure to extreme heat or cold.
- Only use attachments/accessories specified for this device. Make no modifications to the system or accessories. Unauthorised alterations may compromise safety, regulatory compliance, and system performance.
- Only use the supplied aerial or an approved replacement.
- To reduce the risk of fire or electrical shock, do not expose the device to rain or moisture. Do not expose this device to dripping or splashing, and do not place objects filled with liquids, such as vases, on or near the device. As with any electronic products, use care not to spill liquids into any part of the system. Liquids can cause a failure and/or a fire hazard.
- Disconnect this device from AC mains power during lightning storms or when unused for long periods of time to prevent damage to this device.
- To prevent risk of fire or electric shock, avoid overloading AC mains power outlets or extension cords.
- Long-term exposure to loud music may cause hearing damage. It is best to avoid extreme volume when using headphones, especially for extended periods.
- Do not install this device in a confined space. Always leave a space of at least 10cm around the device for ventilation and ensure that curtains or other objects never cover ventilation openings on the device.
Guarantee
Register your product to get an extended three-year guarantee.
As standard, this product is guaranteed to be free from defects for a period
of two years from date of purchase, but this is extended to three years if you
register your product at www.ruarkaudio.com.
This guarantee remains valid providing this product has been treated with due
care and attention. Product failure through accidental damage, excessive wear
and tear, negligence or unauthorised modification will void this guarantee.
If this product was purchased in the UK and it develops a fault, please
contact the retailer from which it was purchased, or contact us directly via
our website www.ruarkaudio.com/support.
For products purchased outside the UK the distributor in the country of
purchase guarantees the product. For details, please contact the local Ruark
distributor or outlet.
If returning this product, please ensure it is packed in its original
packaging and a proof of purchase is included.
This guarantee in no way varies or removes the purchaser’s statutory rights.
Errors and omissions excepted.
General care
- Clean with a soft, lint-free duster or slightly dampened cloth. Do not use wax sprays or other substances as these may damage the surface finish or impair performance.
- Do not expose your unit to direct sunlight, high humidity, dust, excessive vibration or extreme temperatures, all of which can affect the finish, performance and reliability of the unit.
- Recommended operating temp. range is 5°C to 40°C.
- Natural wood finishes will vary and lighten or darken with age, particularly when exposed to sunlight.
Copyright and trademarks
© Ruark Audio. All rights reserved. Ruark Audio, the Ruark Audio logo, and
other Ruark Audio marks are owned by Ruark Audio and may be registered.
Ruark Audio assumes no responsibility for any errors that may appear in this
manual and the information contained in it may change without notice.
Bluetooth® and associated logos are registered trademarks owned by Bluetooth
SIG, Inc.
All other trademarks are the property of their respective owners.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>