ZMG 5 Tiered Outdoor Fountain with Glass Ball Instruction Manual
- June 15, 2024
- ZMG
Table of Contents
ZMG 5 Tiered Outdoor Fountain with Glass Ball
PRODUCT INFORMATION
MODEL NAME : ZMG 5 Tiered Outdoor Fountain with Glass Ball
Fountain Assembly instructions
Please refer to parts letters when assembling. If you need some more installation videos or warranty information & return policy, please Scan QR cord
ASSEMBLY INSTRUCTIONS
-
STEP 1
POSITION THE STATUE PORTION OF THE FOUNTAIN ON AN EVEN SURFACE. PUSH LEAD TO THE HOSE AND THEN CONNECT THE PUMP TO THE HOSE (AS SHOWN). -
STEP 2
POSITON BOWL ON EVEN SURFACE, PLACE STATUE PORTION OF FOUNTAIN ONTO BOWL-BASE. LET OUT THE POWER CABLE FROM BACK OF THE FOUNTAIN -
STEP 3
FILL THE FOUNTAIN WITH WATER AND ENSURE THE PUMP IS COMPLETELY SUBMERGED IN WATER -
STEP 4
PLACE SMALL STONES AND CANDLES ON THE FOUNTAIN AS YOU LIKE. -
STEP 5
ENSURE THE CABLE IS POSITIONED TO FORM A DRIP LOOP SO THAT NO WATER CAN SEEP FROM THE BACK TO THE MAIN OUTLET/PLUG. -
STEP 6
ONCE THE FOUNTAIN IS ASSEMBLED, INSERT THE PLUG INTO THE PROPER OUTLET. WATER MAY TAKE A SHORT TIME TO BEGIN FLOWING AIR CLEARS FROM THE PUMP TO THE HOSE. WATER FLOW IS ADJUSTABLE BY THE LEVER ON THE SIDE OF THE PUMP.
BE SURE TO DISCONNECT FROM THE MAIN OUTLET. BEFORE MAKING ANY FOUNTAIN ADJUSTMENTS
IF THE WATER SPLASH OUT OF THE FOUNTAIN OR IF YOU WANT THE WATER RUN SLOWER, YOU CAN ADJUST THE SWITCH ON THE PUMP
WARNINGS:
- FOR INDOOR USE ONLY.
- CHECK FOR LEAKS AND SPLASHING AFTER INITIAL SET-UP.
- DO NOT LEAVE THE FOUNTAIN RUNNING FOR LONG PERIODS OF TIME AND NEVER UNATTENDED.
- CHECK THE AREA AROUND FOUNTAIN REGULARLY TO ENSURE NO LEAKAGE.
MAINTENANCE
- KEEP WATER CLEAN TO REDUCE MINERAL BUILD-UP, CLEAN PERIODICALLY.
- THE PUMP MUST ALWAYS BE FULLY SUBMERGED IN WATER (EVEN WHEN NOT IN USE) AND NEVER BE PERMITTED TO RUN DRY AS THIS COULD CAUSE PERMANENT DAMAGE. ALSO, WITHOUT SUFFICIENT WATER, IT WILL ALSO CAUSE NOISE.
- DISCONNECT THE POWER & EMPTY BASIN IF THE FOUNTAIN WILL NOT BE IN USE FOR AN EXTENDED TIME.