genkinno P1 SE Cordless Robotic Pool Vacuum Cleaner User Manual

genkinno P1 SE Cordless Robotic Pool Vacuum Cleaner

INTRODUCTION

• Thank you for choosing the Genkinno robotic pool cleaner.
• This user manual helps you to keep your robot performing at its best. Please take a few moments to read through it.
• If you have any questions, contact our customer service for assistance or visit www.genkinno.com for more information.

Genkinno Customer Service:

• Email:support@genkinno.com.
• Facebook: @genkinno

WARNINGS AND CAUTIONS

IMPORTANT SAFETY INSTRUCTIONS, READ AND FOLLOW ALL INSTRUCTIONS!
Please adhere strictly to the following WARNINGS:

• Only use the accessories recommended or sold by the manufacturer.
• This model only applies to swimming pools with a flat floor.
• Do not allow children to ride on the cleaner or play with it.
• Use the original and authorized power adapter only.
• The charging adapter must be connected to a leakage-protected socket when charging.
• Do not operate the cleaner when people or animals are in the pool. While charging, the cleaner should be uncovered and kept in a cool place to prevent damage to internal electrical components caused by overheating.
• Only certified professionals can disassemble the sealed driving kit of the cleaner.
• Do not operate the cleaner while the pool filter is running.
• Oil sealant for the servo contains grease, which can cause water pollution if exposed.
• If the cleaner needs to be stored for a long period, it should be charged every three months to maintain battery life between 400/0 and 600/0.
• Please use the original and authorized power adapter only. If the cleaner is not charged for a long time, the battery voltage will be lower than the over-discharge protection voltage due to the self-discharge of the battery, which may cause fatal damage.
• Do not use or store the cleaner near any heat source.
• Do not pierce the shell of the cleaner with nails or other sharp objects.
• Do not hammer, impact, or throw the cleaner.
• Make sure the charging socket is dried before charging.

FCC Caution

• Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.

• This radio is designed for and classified as “General population/uncontrolled use”, the guidelines are based on standards that were developed by independent scientific organizations through periodic and thorough evaluation of scientific studies. The standards include a substantial safety margin designed to assure the safety of all persons regardless of age or health.
• Body and limbs operation; this device was tested for typical body and limbs operations and kept Omm for body wearing. To maintain compliance with RF exposure requirements, use accessories that maintain an Omm for body-worn.
  • Note: This equipment has been tested and found to comply with the limits for a Class B digital device, under part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
• This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used per the instructions, may cause harmful interference to radio communications.
• However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
• This appliance can be used by children aged 8 years and above and persons with reduced physical, sensory, or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning the use of the appliance in a safe way and understand the hazards involved.
• Children shall not play with the appliance.
• Cleaning and user maintenance shall not be done by children without supervision.

Please ensure that the following PRECAUTIONS are implemented:

• Check the wheels to make sure they turn properly.
• Always clean and wash the filter tray after use.
• Turn off the cleaner when maintaining, cleaning, or when it is not in use.
• The cleaner should be stored in a cool and ventilated place, away from direct sunshine.
• Due to the limitations of the battery capacity, the cleaner is only suitable for swimming pools with sizes up to 1614 sq. ft (150nK); otherwise, the cleaning effect will be impacted or reduced.

Water Conditions

• Use the Robotic Pool Cleaner in the following water conditions:

IIN THE BOX

1. 1 X Genkinno P1 SE
2. 1 X Water Filter Tank (filter included)
3. 1 X Charger
4. 1 X User Manual
5. 1 X Floating Cable
6. 1 X Handle

ROBOTIC POOL CLEANER PARTS

Robotic Pool Cleaner

1. Drain
2. Charge Input
3. Power Button
4. Battery Level LED
5. Function LED
6. Floating Cable
7. Handle/Antenna
8. Release Button
9. Anti-collision Rubber
10. Wheel

Water Filter Tank

USING FOR THE FIRST TIME

Charging the Cleaner

Connect the cleaner and the included charger to charge the battery.

• Clean the charging port before charging.
• The red indicator light on the adapter indicates that the battery is currently charging.
• The green indicator light on the adapter indicates that the charging process has been completed.

Turn on the Cleaner

• Press the start button once and the cleaner will power on.
• The power indicator LED will turn green.

Check the Battery Level

USING THE ROBOTIC POOL CLEANER

Robotic Pool Cleaner Status Indicator
The cleaner includes LED status indicators, please refer to the table below to understand the machine status indicated by different flashing methods.

Pl SE Status Indicator

Blue constant| Auto mode with SOW suction power

Auto Mode

Once turned on, the cleaner’ s default mode is Auto mode, where the cleaner will begin to operate approximately 1 to 2 minutes after being placed inside the pool.

Placing the Robotic Pool Cleaner into the pool

Release it and let it sink to the floor of the pool.

Path Planning

When it moves ahead and reaches one side of the pool, it can start to plan the following route parallel to the first route automatically.

Power Mode Switch

• The cleaner’ s maximum suction power of IOOW will activate automatically when the cleaner encounters large leaves and other debris.

Auto Parking

• When the cleaner has completed its cleaning session, or the battery is low, it will park itself so that you can easily take it out.

Removing the Robotic Pool Cleaner from the Pool

• Locate and grab the floating cable, you can then pull the cable to remove the cleaner from the swimming pool.

Cleaning After Use
It is highly recommended to clean the filter basket after each cleaning cycle.

1. Press the button
2. Pull out of the water filter tank.
3. Open the water filter tank.
4. Clean the water filter tank.
5. Take out the filter.
6. Clean the filter.

OFF-SEASON STORAGE

If the cleaner will not be in use for an extended period, perform the following storage steps:

• Please ensure that the cleaner is turned off.
• Make sure that no water is left inside the cleaner.
• Thoroughly clean the filter basket and panels and insert them back into place.
• Roll up the cable so that it has no kinks.
• Store the cleaner indoors away from direct sunlight or weather elements such as rain or snow.
• If the cleaner needs to be stored for a long period, it should be charged every three months to maintain battery life between 40%-60%.

FREQUENTLY ASKED QUESTIONS (FAQ)

1. How large of a swimming pool can be cleaned?
   • Due to the limitations of battery capacity, the cleaner is only suitable for swimming pools with a size of up to 1614 sq. ft (150nf); otherwise, the cleaning ability will be affected.
2. How deep underwater can it work?
   • Because the floating cable is 2 meters, to keep the cleaner running properly, we suggest a max depth of no greater than 2 meters (about 6.6 feet).
3. How do I safely remove my cleaner from the water?
   • Gently pull on the floating cable to bring your cleaner to the edge of the pool and then remove it.
4. How often should I clean the filter?
   • It is highly recommended to clean the filter basket after each cleaning cycle.
5. Can the P1 SE clean the walls and the waterline?
   • This cleaner is designed to clean the floor/ground of a pool underwater. It cannot clean the walls or the waterline properly.
6. What is the runtime of the P1 SE? How long does it take to fully charge?
   • It takes approximately three hours to fully charge the cleaner, thanks to its safe fast-charge technology. Once fully charged, it can provide up to two hours of use, enough to clean most pools several times over.

SPECIFICATIONS

415X276X200 mm (LXWXH)

Weight| 9. lbs (4.4kg)
Storage Temperature| -4° to 113° F (-20° to 45° C), RH 75%
Pool Slope| Max 15°

WARRANTY

• This product has passed all quality control and safety tests per all relevant laws and regulations and the highest safety standards.

Warranty Information

• The warranty covers 24 months (only applies to the battery and motor) from the date of original purchase.
• This warranty is voided if the product has been altered, misused, or has been repaired by unauthorized personnel.
• The warranty extends only to manufacturing defects and does not cover any damage resulting from the mishandling of the product by the owner.
• The order number or record must be presented for any claim or repair during the warranty period.

CONTACT

• Genkinno support: http://www.genkinno.com/support.
• Genkinno service: If you have any questions about this document, please contact Genkinno by sending a message to support@genkinno.com.
• Facebook: @genkinno

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>