YAMAHA IN-TSK-Y-RMAX-007 Plug and Play Turn Signal Kit Installation Guide
- June 15, 2024
- Yamaha
Table of Contents
YAMAHA IN-TSK-Y-RMAX-007 Plug and Play Turn Signal Kit
INSTALLATION INSTRUCTIONS
for CFMOTO UFOCE 1000
- Do not discard packaging until product has been successfully installed.
- Components may be installed in locations other than where shown. Alway verify wire harness length.
- While routing, follow factory wiring when possible.
- Use provided dielctric grease on all connections.
- Always consult labels on Harnesses when making connections.
- Avoid rotating or hot components when securing.
- Before drilling any holes, check behind area to be drilled for any interference.
Plug and Play Turn Signal Kit:
-
ECU
-
Horn Kit
-
Turn Signal Switch
-
Hazard and Horn Switch
-
Wire Ties
-
4x – LED Signal
to rear of machine
-
to Left Rear Tail Light
-
to Right Rear Tail Light
-
to License Plate Light (opt)
-
to Turn Signal Switch
-
to Horn / Hazard Switch
-
to ECU
-
to Horn
-
to LED’ s
-
green and black wires = right yellow and black wires = left
Remove Accessory Panel
Rear
- Plug in Harness and secure ECU to Accessory Panel with hardware shown; tighten.
- Locate stock connector shown.
Before drilling any holes, check behind area to be drilled for any interference.
LED Signals:
- User may install in locations different than shown.
- Drill a Ø3/4” hole in body and install LED Signal. Repeat for remaining LED Signals.
- Plug LED Signals into corresponding inputs on Harness.
- Secure all Wires as needed.
If Light is hard to insert separate as shown.
- Separate LED from Gasket.
- Install Gasket into hole.
- Install LED into Gasket
Horn
- User may install Horn in location different than shown.
- Install Horn to Bracket.
- Connect Harness to Horn.
- Secure to location shown; tighten.
Super ATV recommends testing Switches before permanently mounting.
- Connect Harnesses to Switches.
- Secure Switches.
Accessory to Turn Signal Kit Wiring
Left Turn Signal Harness shown in illustrations.
Super ATV recommends using a handheld mini torch, or lighter, to activate heat shrink on Connector.
Customer Support
Need help with your installation?
sales@superatv.com
1-855-743-3427
www.superatv.com
8:00am – 8:00pm EST M-Th
8:00am – 7:00pm EST Friday
9:00am – 2:00pm EST Saturday
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>