VCK JDFSX0001AGL Air Circulator Fan User Manual

VCK JDFSX0001AGL Air Circulator Fan

• READ AND SAVE THESE INSTRUCTIONS
• Attention: Pictures in the book are for reference on
• Thank you for purchasing the VCK LE-PF001 Air Circulator Fan. If you need any assistance, please contact our support team [email protected] with your product model number and order number.

IMPORTANT SAFETY INSTRUCTIONS

Read Guidance for Safe Operation and Instructions Carefully.

1. To reduce the risk of fire or electric shock, do not use this fan with any solid-state speed control device.
   • This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of electric shock, this plug is intended to fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug.
   • If it still does not fit, contact a qualified electrician. Do not attempt to modify this safety feature.
2. 3. This appliance is not intended for use by persons (including children) with reduced physical, sensory, or mental capabilities, or lack of experience and knowledge unless they have been supervised or instructed to use the appliance by a person responsible for their safety.
3. Do not leave the fan running unattended.
4. Unplug or disconnect the appliance from the power supply before servicing.

READ AND SAVE THESE INSTRUCTIONS

1. The instructions about the cord and plug are below
   • This product employs overload protection (fuse). A blown fuse indicates an overload or short-circuit situation. If the fuse blows, unplug the product from the outlet. Replace the fuse as per the user servicing instructions (follow product marking for proper fuse rating) and check the products. If the replacement fuse blows, a short-circuit may be present and the product should be discarded or returned to an authorized service facility for examination and/or repair.
   • Do not operate any fan with a damaged cord or plug. If damaged, return to an authorized service facility for examination and/or repair.
   • Do not run a cord under the carpeting. Do not cover the cord with throw rugs. runners, or similar coverings. Do not place the cord under furniture or appliances. Arrange the cord away from the traffic area where it might be tripped over.
2. The fan should be used under rated voltage.
3. Connect power only after the fan is fully assembled.
4. Never insert fingers, pencils, or any other object through the protective cover when the fan is running.
5. Unplug from the outlet when not in use, when moving the fan from one location to another, before putting on or taking off parts, and before cleaning.
6. Make sure the fan is on a stable surface when operating to avoid overturning.
7. Do not use a fan near a window. Moisture may create electrical hazards.

SPECIFICATIONS

Product Component

1. Control panel
2. Remote control
3. Body
4. Base
5. Pole (20 inches)
6. Pole(2.75 inches)
7. Nut
8. Power cord

ASSEMBLY INSTRUCTIONS

1. Base Installation: insert the riser into the chassis hole, then align the L-shaped screws with the riser screw holes, and twist clockwise firmly by “Step 1
2. Body installation: installation of the chassis and riser placed on level ground, remove the body, the body fixed seat hole aligned with the riser inserted, inserted in place will be locked screw twisted firmly by “Step 2-3”
3. Place it on an even and stable surface, plugged into 120V AC power only.
4. Reter to steps 1-3 for pole replacement (Depending on the location and needs of use).

OPERATION INSTRUCTION

Remote Control Quick Start Guide (Fig.4)

1. ON/OFF
   • Press once to turn ON/OFF
2. Left-right Oscillating
   • Press once to 70° left-right oscillating
3. Up-down Oscillating
   • Press once to 85° left-right oscillating
4. Speed
   • Press once to Increase wind speed (01-02-…32 speed/Long press for quick selection)
5. Speed
   • Press once to Reduce wind speed (32-31-…01 speed/Long press for quick selection)
6. Time Setting
   • Press once to increase the scheduled time (01-02-…24 H/Long press for quick selection)
7. Time Setting
   • Press once to increase the scheduled time (24-23-..0 1H/Long press for quick selection)
8. Quiet Mode
   • Press once to Quiet Mode
9. Safety Child Lock
   • Press once to turn ON/OFF Safety child lock mode (Press and hold “+” &”-” on the panel together to turn ON/OFF the safety child lock mode).
10. Smart Mode

• Press once to choose baby wind- comfortable wind – strong wind-Alintelligent wind speed mode-Free Choice Mode in turn.
• Baby Wind — Default 01 wind speed.
• Comfortable Wind — Default 16 wind speed.
• Strong Wind — Default 32 wind speed.
• All   intelligent wind speed mode – Automatic adjustment of air speed according to the room temperature.
• Free Mode — adjust the wind speed gear size at will
• Note: When the above 4 modes are selected, press “+” &”-” again to adjust the wind speed, it will automatically turn to the free selection mode.

Panel indication (Fig.5)

• The buttons on the panel such as ON/OFF, Left-right oscillating, Up-down oscillating, Safety child lock, and Quiet Mode have the same functions as those of on the remote controller.

BATTERIES

1. Remove the card in the direction of the arrow to power on the remote control (Fig.6).

Replace with a new battery NOTES:

1. Push the button next to the battery cover to release the battery cover.
2. Insert 1 x CR2025 type lithium battery, making sure the “+” side is facing up as shown in the diagram (Fig.7).
3. Once the battery is installed, push the battery cover closed.

BATTERY WARNING AS BELOW

1. Please keep the battery out of the reach of children. If a child swallows the battery by mistake, please seek medical attention immediately.
2. Do not charge or throw into fire to avoid explosion or leakage.
3. Please put it in a dry and cool place.
4. Please wipe the battery before use.
5. Please insert the battery in the correct direction.

REMOTE CONTROLLER OPERATION

• Point the remote controller to the receptor in front of the fan and press the desired button. The remote controller will work at distances of up to five meters and an angle of 30 degrees between the right and left of the receptor.
• Note: The batteries must be removed from the remote controller before it is scrapped and properly disposed of.
• This product contains a lithium button/coin cell battery. If a new or used lithium button/coin cell battery is swallowed or enters the body, it can cause severe internal burns and can lead to death in as little as 2 hours. Always completely secure the battery compartment. If the battery compartment does not close securely, stop using the product, remove the batteries, and keep it away from children. If you think batteries might have been swallowed or placed inside any part of the body, seek immediate medical attention.
• a) The cells shall be disposed of properly, including keeping them away from children; and b) Even used cells may cause injury.

USER SERVICING INSTRUCTIONS

1. The motor is equipped with a thermal fuse which will turn the fan off to protect it from burning out because of overheat, which keeps plastic parts of the fan from deformation.
2. Do not use the fan, if the plug is damaged. Turn to the support team [email protected] for help.

CLEANING

1. Be sure to unplug the power cord from the outlet before cleaning.
2. Plastic parts should be cleaned thoroughly with clean water, mild soap, and a damp cloth or sponge.
3. Be sure not to get water or other liquid enter the inside of the motor.
4. Dry all parts completely before plugging into the socket.

WARRANTY & CUSTOMER SUPPORT

• Thank you for purchasing the VCK Air Circulator Fan. Please read this user manual carefully and keep it for future reference.
• If you need any assistance, please contact our support team [email protected] with your product model number and order number.
• Please read all instructions before attempting to use this product. VCK warrants as limited herein to the original purchaser of retail that each new Fan, shall be free of defects in material and workmanship for a period of one (1) year from the date of original purchase. This one (1) year warranty is limited to the Motor and Electric Element.
• In the event of malfunctions or failure of your Fan, simply deliver or send the
• Fan, postage prepaid along with PROOF OF PURCHASE, within the warranty period of one (1) year, to VCK reserves the right to inspect the claimed defective part or parts to determine if the defect or malfunction complaint is covered by this warranty. VCK shall within sixty (60) days after receipt of the product, at its option, repair and/or replace the defective part or parts free of charge. This warranty shall only cover defects arising from normal usage.
• VCK takes no responsibility whatsoever if the Fan should fail during

the warranty period because of:

• Misuse, negligence, physical damage, or accidents.
• Lack of maintenance (see instructions for proper maintenance).
• Repair by any unauthorized party during the warranty period.
• Damage caused by connection to an improper input voltage (see specification label on your Fan).
• VCK makes no further warranties or representations, express or implied except those contained herein. No representative or dealer is authorized to assume any other liability regarding the Fan. The duration of the implied warranty granted under State law, including warranties of merchantability and fitness for a particular purpose is limited in duration should the duration of the express warranty grant it hereunder.
• VCK shall in no event be liable for direct, indirect, special or consequential damages.
• Some states do not allow limitations on how long an implied warranty lasts, and/or the above limitations or exclusions may not apply to you.
• This warranty gives you specific legal rights and you may have other rights which vary from state to state.

FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT

To assure continued FCC compliance:

This equipment has been tested and found to comply with the limits for a Class B digital device, under Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used under the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

CAUTION:
To assure continued FCC compliance: Any changes or modifications not expressly approved by the grantee of this device could void the user’s authority to operate the equipment.
[email protected]

Documents / Resources

| VCK JDFSX0001AGL Air Circulator Fan [pdf] User Manual
JDFSX0001AGL Air Circulator Fan, JDFSX0001AGL, Air Circulator Fan, Circulator Fan, Fan
---|---
| VCK JDFSX0001AGL Air Circulator Fan [pdf] Instruction Manual
JDFSX0001AGL Air Circulator Fan, JDFSX0001AGL, Air Circulator Fan, Circulator Fan, Fan

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>