Arpha D100 Keyless Entry Door Lock Instructions
- June 15, 2024
- arpha
Table of Contents
Arpha D100 Keyless Entry Door Lock
Product Information
This product is a lock that can be programmed with different codes for access. It has a reset button for restoring factory settings and adding new codes. The lock has an administrator code and user codes, with the first three passwords created being administrator codes by default.
Specifications
- Reset Button: Long press for 5 seconds to restore factory settings
- Administrator Code: 6-8 digits
- User Code: 6-8 digits
- Indicator: Green light
Product Usage Instructions
Restore Factory Settings
To restore the lock to factory settings, follow these steps:
- Long press the reset button for 5 seconds.
- You will hear a long beep, indicating that the lock has been reset to factory settings.
- Note: It is necessary to reset the lock before use.
Add Code
Adding Administrator Code
If there is no existing administrator code, follow these steps:
- Short press the reset key.
- Enter your new administrator code (6-8 digits) on the keypad.
- Press the button to confirm the code.
- Repeat the administrator code again and press the button.
- You will hear a long beep and see the green light flash, indicating that the administrator code has been added successfully.
Adding User Code
If the administrator codes have already been created, follow these steps:
- Press the reset key.
- You will hear two short beeps as a prompt.
- Verify the administrator password.
- Enter your code (6-8 digits) on the keypad.
- Press the button to confirm the code.
- Repeat the user password again and press the button.
- You will hear a long beep and see the green light flash,indicating that the user code has been added successfully.
Programming Guide
Operation process
Restore Factory Settings
Long press the reset button for 5 seconds, it will be reset to factory settings until a long “beep”.
Note: It’s a must to reset the lock before use.
Add code
If there is no administrator code
Please short press reset key, enter your new administrator code (6–8 digits)
ended with the “ ” button, then repeat the administrator code again and press
the “ ” button. A long “beep” and green light flashes. Then it’s done.
Note: The first 3 passwords created are administrator codes by default.
If the administrator codes have been created
Press the reset key, and two short “beep” will prompt, verify the administrator password, then enter your code (6–8 digits) ended with the “ ” button, repeat the user password again and press the “ ” button. A long “beep” and green light flashes. Then it’s done.
Specifications
| Feature | Description |
|---|---|
| Reset Duration | 5 seconds |
| Administrator Code Entry | 6–8 digits followed by “✓” button |
| Confirmation Signal | Long beep and green light flash |
| Default Administrator Passwords | First 3 created |
FAQ
How do I restore the factory settings?
Press and hold the reset button for 5 seconds until you hear a long beep.
Do I need to reset the lock before using it?
Yes, it is essential to reset the lock before its initial use.
How do I add an administrator code?
What indicates that the code has been successfully set?
A long beep followed by a green light flash indicates the code has been successfully set.
How many default administrator codes are there?
There are three default administrator codes.
How many digits can the administrator code and user code have?
Both the administrator code and user code can have 6-8 digits.
What happens if I forget the administrator code?
If you forget the administrator code, you will need to restore the lock to factory settings and add a new administrator code.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>