HENLWISON UHV WiFi Extender Booster User Guide

USER MANUAL
24-hour after-sales email: WIFIEXTENDER707@gmail.com

INTRODUCTION

Solid Green- ON
– System startup is complete.
Green light flashes rapidly
– The system is booting or upgrading.
| Internet Indicator| Unit- OFF – No intemet.
Solid Green- ON – Internet connected.
| Signal Indicator| Solid Red – Connected to host Wi-Fi, weak signal.
Solid Yellow
– Connected to host Wi-Fi, fair signal.
Solid Green
– Connected to host Wi-Fi, good signal.
| WAN/LAN Indicator| Flashing Green
– The extender is connected with network cable
| Reset Button| Press the reset button for 10-15 seconds, the power indicator will flash green, the extender will reboot.
| WPS Button| Short press the WPS button, the power indicator will flash red.
The power indicator will be solid red for 5 seconds when the extender matches the router successfully. The extender will reboot and extend signal.
The red light will be off when the extender matches the router overtime or unsuccessfully. And the extender will reboot automatically.

QUICK SETUP GUIDE

Step 1 Plug the Extender into a power outlet near your existing Wi-Fi Router.
Step 2 Open the Wi-Fi settings on your mobile phone or computer.
Search and connect to the “Repeater-xxxx’” Network in your wireless network list.
Note: If the setting page does not pop up automatically, launch your web browser and enter the IP address: 192.168.11.1 in the address bar.
Step 3 Click “LOGIN”
Step 4 Option 1: Choose Repeater Mode and wait 10 seconds.
The system scans all networks.

Step 5 Click on the name of the existing Wi-Fi Network you want to extend, e.g., XXXXXX
Step 6 Type your Wi-Fi password into the Password box and click Next button
Step 7 Click the Finish button. Once you complete the steps, your Extender reboots automatically. Place the Extender halfway between your Wi-Fi Router and the area with pool signal coverage.

The Extender’s default name is
your [Wi-Fi name -ext], the password remains the same as the existing WiFi Router’s Password

AP MODE SETTING

Step 1 Choose AP Mode and click Next button
Step 2 Type your network SSID and Wi-Fi password. Note: the password should be more than 8 digits.
Step 3 Click the Finish button. Once you complete the steps, your Extender reboots automatically.

Connecting the network cable after the configuration is finished.

FQA

How do I reset the Extender?

To reset the extender, use the reset pin to press the RESET button for 10-15 seconds to restore factory settings. The WiFi SSID of the wifi extender will be “Repeater-xxxx” after restoring successfully. Then set up again from the beginning.

Does the Extender work with 5G?

No, the Extender only operates in the 2.4GHz band.

I can’t see Wi-Fi Extender in my network list.

Please press the RESET button for 15 seconds, and wait 30 seconds. Then check the network list one more time.

I tried to open your IP address, but it says no internet or page error.

Please open your Wi-Fi settings and check your network. You need to be connected to the Extender network, not to the main router or mobile internet network! You will have a “no internet” connection near the network “Repeater- xxxx”, but it’s correct! Until you finish setup, the network will be without internet. NOTE: You can’t connect to the IP or site, when you have an internet connection because this is not an internet page, but the setting page of your Extender.

When I’m connected to Wi-Fi Extender, it says no internet.

This issue you have is because of the wrong password. Even if you are sure about the correct password, please reset your device and set it up again. NOTE: Check your password a few times! It’s CASE-SENSITIVE! Many phones use a first capital letter as a default, so please check if all letters are the same as your main router password!

After I install the Extender, which area will be the best to have it?

The Extender should be halfway between the Wi-Fi Router and the area with poor signal coverage. The Extender must receive a good signal from the Wi-Fi Router.

Need help? ,
We’re here for you!
If you have any issues with the device, Please contact us for assistance before opening a returen request.
24-hour after-sales email:
WIFIEXTENDER707@gmail.com

WIFIEXTENDER707@gmail.com
Web.: www.meestory.com.cn

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>