Dongguan 2BAKS-CM58 CM58 Wireless Remote Control Toy Car User Manual

Dongguan 2BAKS-CM58 CM58 Wireless Remote Control Toy Car

Safety notice

• The model is not toy, please read the manual carefully before use.
• This product contains small parts. Children under the age of 14 are strictly prohibited from using it to avoid the risk of suffocation caused by accidental ingestion; children over the age of 14 must use it in the presence of a guardian, and do not leave the guardian’s line of sight to avoid accidents
• Adults must be present when charging; please place it out of the reach of children when charging and storing.
• The moving parts are dangerous. It is forbidden to put fingers, hair, clothes and other items into the gap between the tire and the car body, so as not to be stuck by the rotating parts.
• Due to functional requirements, this product contains sharp parts, please operate according to the correct steps and usage methods, and pay special attention to eye safety.
• Please do not bend, throw or use this product in other violent ways to avoid damage to the product or cause an accidents.
• This product has a built-in battery, please do not put it into water or fire (such as stove, gas stove, etc.), to avoid explosion.
• Any accidents such as injury to others or damage to items caused by operating errors are the responsibility of the operator, and the company will not be responsible.

Scenario warning

• Do not use and store this product in high temperature, low temperature, high humidity and other environments
• Do not running in places where cars are driving or near children to avoid dangers such as collisions.
• Do not running on sand, water or dusty places to avoid to cause product failure
• Do not running it on the bed, the wheels are entangled and cannot rotate, continuous refueling will cause damage to the vehicle.
• Do not drive towards people or animals to avoid accidents.
• Do not vote for the vehicle, as the model car may be damaged if dropped from a height of more than 20cm.

Maintenance

• Hitting hard objects while driving may cause damage.
• it is recommended to add fences around the site to prevent damage when the product falls.
• In low voltage alarm state, the front and rear lights flash quickly, please turn off the power in time to prevent battery damage.
• Before each use, please check and clean the wheels, chassis, and foreign objects in the gear gap.
• When storing for a long time, keep the battery voltage at 3.7V, and charge and discharge once every 3 months.

Note

• The products, accessories, Transmitter etc. in the manual are schematic diagrams and are for reference only.
• Due to product updates and upgrades, there may be slight differences between the actual product and the sche matic diagram, please refer to the actual product.

TX fuction description

Drivina and steering

Fine-tuning

• Throttle fine-tuning: After the vehicle is powered on, it will move forward or backward by itself, and TH throttle fine-tuning can be adjusted.
• Direction fine-tuning: The vehicle cannot drive straight, you can adjust the ST steering fine-tuning.

Light/Fuction Key

Charging
The Transmitter has a built-in 18650 battery, which can be charged through USB-C. The indicator light is red when charging, and the indicator light turns off when it is fully charged; please do not charge with overvoltage (5V), otherwise the transmitter will be damaged.

Screen
Forward and reverse: During use, if you find that the throttle or direction is reversed, you need to reverse the channel in the transmitter menu.

Vehicle fuction description

Bind

Please hang the wheels of the vehicle

1. Power on the vehicel then press the key within 10 second until green blue LED fast blink meaning vehicle in bind mode.
2. Select the or option on the transmitter «Setting>, «Advanced> menu, respectively to the car’s TELEMETRY ON> or mode. car will red blue slow blink or red green slow blink after bind success.
3. User need exit transmitter from bind menu and cycle vehicle power.

Light status indication

Charging
The indicator light is red when charging, and fully charged is green, charging allowable input voltage is 5V, overvoltage charging will damage the vehicle.

Troubleshooting

Inspection report

Thank you for purchasing, Enjoy vehicle use time !

Campany information

WWW.LDARC.COM

Manufacturer: DongGuan LDARC Technology Co…,Ltd
Address: JinTianDa Logistics Park, NO.180-140 DongShen Rd, YanTian, FengGang, DongGuan, GuangDong, China
Email: [email protected]
Made In China

More manual

Email: [email protected]

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>