ASAKUKI YH-935 Ultrasonic Top Fill Humidifier User Manual
- June 15, 2024
- ASAKUKI
Table of Contents
USER MANUAL
Ultrasonic Top-Fill Humidifier
Model No: YH-935
Please read carefully before use and save the instructions.
Questions or Concerns?
Please contact us: support@asakuki.com
Package Contents
| |
---|---|---
1 Humidifier| 1 Cleaning Brush| 1* User Manual
Specifications
Model No | YH-935 |
---|---|
Rated Voltage | AC 100V-240V, 50/60Hz |
Power | 25W |
Noise Level | ≤ 35dB(A) |
Capacity | 3L/0.8gal |
Suitable Area | Bedroom/Small Room |
Running Time | 12-30 hrs |
Mist Outpu | 150-300mL/H |
Net Weight | 1.27Kg/2.8 lbs |
Product Size | 191929 cm/7.48*7.481 1.41 in |
Safety Information
General Safety
- Only use the humidifier as described in this manual.
- When not in use for an extended period, turn the humidifier off and disconnect the plug from the outlet.
- Do not use the humidifier in wet environments.
- Keep the humidifier out of reach from children.
- Do not attempt to disassemble the humidifier or its components.
- Always unplug the humidifier from power before cleaning it or detaching the water tank from the humidifier base.
- Always place the humidifier on a flat, horizontal surface before using.
- Only fill the water tank with clean water. Never fill the water tank with any other liquids.
- Do not place the humidifier near heat sources such as stovetops, ovens, or radiators.
- Do not place the humidifier directly on carpets or rugs.
- Do not use non-Asakuki humidifier parts as replacement parts for this product.
- Do not cover the nozzle while the humidifier is on, as this may damage the humidifier.
- Remove the water tank from the base before moving the humidifier.
- Do not immerse the humidifier base, power cord, or power plug in water.
- If the humidifier is damaged or is not functioning properly, stop using it and contact Customer Support immediately.
- Not for commercial use. Household use only.
- To reduce the risk of fire, electric shock, or other injury, always follow all instructions and safety guidelines.
Power Cord & Plug
- Ensure that the plug fits properly into a polarized outlet.
- Do not handle the power cord or plug with wet hands. Keep the power cord and plug away from liquids.
- Your humidifier has a polarized plug (one prong is wider than the other), which fits into a polarized outlet in only one orientation. This is a safety feature to reduce the risk of electric shock. If the plug does not fit, reverse the plug to the correct orientation. If it still does not fit, do not bypass this safety feature and try forcing the plug into the outlet; instead, do not use it with the outlet.
Risk of Leaks and Electric Shock
- Do not add essential oils, supplemental water treatment liquids, or water filters into the water tank or base chamber, as this may damage the humidifier and cause leaks.
- Only add essential oils to the aroma pad.
Getting to Know Your Humidifier
Quick Easy Guide
MAX | The maximum amount of mist |
---|---|
MIN | The minimum amount of mist |
OFF | Off |
Blue LED light | Operation mode |
Red LED light | Water shortage |
Quick Easy Guide
Getting Started
Steps for filling water
- The humidifier should be placed on a flat surface
- Remove the pearl cotton pressed on the float
- Put the water tank back on the base(According to the symbols)
- Open the cover and fill in water
- Note that water must not exceed the maximum water level
- Cover the tank cover and plug in the power cord
Attention!
- Do not add water directly into the base.
- Do not add water through the mist tube.
- Do not use water treatment liquids or third-party water filters in this humidifier.
- Do not add water over the max line.
- Do not add essential oils into the humidifier. Only add it into the designated positions.
Using Your Humidifier
Operating steps
After the machine is plugged in, turn the fog switch clockwise,red indicator
light will lighten,when the water is added to the water level switch,the blue
light is on and the machine goes into spray mode, when spraying,the amount of
mist can be adjusted by the switch.
Attention!
Equipped with the function of lifting the water tank and power off, the
following situations are normal.
- When working normally, lift the water tank and stop working, place it back and it will start working again.
- In water shortage, lift the water tank it will stop working after about 10s due to the shaking of the water surface,refill water and place it back, it will work again.
Cleaning Maintenance
Cleaning Steps
The humidifier should be cleaned after a week of use or before being stored
away.
- Unplug the humidifier.
- Remove the water tank cover and the water tank from the base, and pour out any water from the tank and base chamber.
- Use a included cleaning brush or cotton swab to wipe the narrow place of the base.
- Rinse the cover, tank and base chamber with room temperature water. Do not let water into the air inlet or outlet when cleaning the humidifier’s base with running water.
Note:
- It is unnecessary to remove the float for cleaning in normal circumstances.
- If the float is removed, make sure to place it back in the correct position as inaccurate positioning may cause the humidifier to leak
- If water does accidentally enter the base’s inlet or outlet, place the humidifier base in a ventilated place to dry before using.
Descaling the Humidifier
- Fill the tank with 3 cups/ 710 mL of distilled white vinegar.
- Put the tank cover on and swish the vinegar around the tank.
- Place the tank on the base and soak for 15-20 minutes. vinegar will drain into the base chamber and loosen scale (mineral buildup) in the tank and in the base chamber (including the float).
- Remove the tank, remove the tank cover, and pour out all vinegar.
- Remove the float from the base chamber by pulling it out of the float bracket. One side of this bracket is open to allow the float’s prongs to be removed from the bracket.
- Place the float in a small container. Fill with enough vinegar to cover the float. Let it soak for 15-20 minutes.
- Use a soft cloth and the included cleaning brush to remove scale from all parts.
- Rinse all parts until the vinegar smell is completely gone.
- Dry all parts with a cloth. Make sure all parts are completely dry before reassembling
Troubleshooting
The troubleshooting section below is for solving frequently asked questions
for the humidifier.
If your problem persists, please contact customer support.
Fault phenomenon | Cause Analysis | Method of exclusion |
---|---|---|
The switch indicator is not on | The power plug is not plugged in | Plug in the |
power cord and turn on the power
There is water in the tank, the display is lit, but the indication is always
indicated by the water shortage| There is too much scale on the atomizer
sheet| Cleaning the scale on the atomizer sheet
Abnormal mist| 1. Too much scale onhe atomizer sheet
2. Water is dirty or water is stored for a long time
3. The mist output set to the minimum gear position| 1. Cleaning the
atomizer sheet
2. Replace clean water;
3. Rotate the switch to adjust the mist mode
Abnormal noise| 1. Less water in the atomizing sink
2. Resonate with the desktop| 1. Add water
2. Placed on a firm and stable desk
Fog overflows from the tank| The tank is not in place or there is debris in
the water| Place the tank smoothly, refill some clean water
The sprayed mist has an odor| Water is not clean and it has been left for too
long.| Clean the sink, dry it, and replace it with clean water
Warning & Attention
Attention!
Prohibition
Please confirm whether the voltage in this city conforms tothe specification
of the product before use.
The product will produce moisture when working, pleasekeep away from other
household electrical appliances.
Do not place the product where it is exposed to strong light or hot air.
When not in use for a long time, please cut off the power and unplug the
power.
When pouring water into the tank, do not exceed the highest water level to
prevent water overflow into the body.
Do not use hard object to knock the surface of the humidi-fier to prevent the
shell from cracking.
Forbidden to disassemble
Non-professional personnel, do not dismantle the machine, so as to avoid
electric shock accident!
Prohibition
Do not place the product around a stove or other heatradiation source or
inflammable or explosive materialsto avoid accidents.
Please do not use wet hands to plug in or out the powerto avoid electric
shock.
When the machine is turned on, please do not touchthe atomizer sheet with hand
to avoid hurting.
The power line must not be scratched, damaged, exces-sively bent, pulled,
twisted, knotted, and do not press h-eavy objects on it or clamped or
processed to avoid therisk of electric shock.
Please do not put metal products, chemicals, detergentinto the water tank,
otherwise there will be poor atomi-zation problem.
This product is for indoor use only,keep out of reachof children.
Customer Service
Customer Service
If you have any questions or concerns about your new product, please contact
our helpful Customer Support Team.
2 Year Limited Warranty
Lifetime Technical Support
support@asakuki.com
www.asakuki.com
Made in China
Clean the water tank every 3 days
- Be aware that high humidity levels may encourage the growth of biological organisms in the environment.
- Do not permit the area around the humidifier to become damp or wet. If dampness occurs, turn the output of the oil diffuser down. If the oil diffuser output volume cannot be turned down, use the oil diffuser intermittently. Do not allow absorbent materials, such as carpeting, curtains, drapes, or tablecloths, to become damp.
- Unplug the appliance during filling and cleaning.
- Never leave water in the reservoir when the appliance is not in use.
- Empty and clean the oil diffuser before storage. Clean the oil diffuser before next use.
Warning: Micro-organisms that may be present in the water or in the environment where the appliance is used or stored, can grow in the water reservoir and be blown in the air causing very serious health risks when the water is not renewed and the tank is not cleaned properly every 3 days.
Manufacture: Chongqing ChuangHong DianZi ShangWu Youxian Gongsi
Address: CN, 401120, chongqing, chongging, beibuxinqu, 1zhuang11-3,
jinkaidadao 1228hao, beibuxinqu
WEEE-Reg.-Nr. DE 41980660
EU Responsible Person: C&E Connection E-Commerce (DE) GmbH
Address: Zum Linnegraben 20, 65933, Frankfurt am Main, Germany
Tel: +49 017 46508451
E-mail: info@ce-connection.de
Manufacture: Chongqing ChuangHong DianZi ShangWu YouXian Gongsi
Address:1 zhuang 11-3,jin kai da dao 1228 hao,bei bu xin qu,
Chongaing, 401120, China
UK Responsible Person: APEX CE SPECIALISTS LIMITED
Address: 89 Princess Street, Manchester, M1 4HT, UK
Contact: Wells
Tel: +441616371080
E-mail: info@apex-ce.com
Made in China
Documents / Resources
|
ASAKUKI YH-935 Ultrasonic Top Fill
Humidifier
[pdf] User Manual
YH-935 Ultrasonic Top Fill Humidifier, YH-935, Ultrasonic Top Fill Humidifier,
Top Fill Humidifier, Fill Humidifier, Humidifier
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>