MORNINGSTAR 150-300 HW SureSine Inverter User Manual
- June 15, 2024
- Morningstar
Table of Contents
MORNINGSTAR 150-300 HW SureSine Inverter User Manual
Warranty Registration: https://www.morningstarcorp.com/product-registration/
In the Box:
Tools Required:
Minimum Clearance Requirements:
Mounting:
Step 1: Choose mounting location
A) Determine how and where the inverter will be mounted.
B) Ensure the inverter is protected from sun, rain, and dust.
Step 2: Wiring accessibility and air flow clearance
A) Plan and confirm wire routing-access.
B) Verify that the mounting screws will not penetrate wires or other objects
located on the opposite side of the surface.
C) Verify that there is at least 6″ of space around the unit.
Step 3: Mark and drill holes
A) Place the inverter on the wall where the unit will be mounted.
B) With a pencil or pen, mark the center of each keyhole slot; two (2) on top
and two (2) on the bottom.
C) Remove the inverter and drill four (4) 1/8″ (3.175 mm) holes where the
marks were made.
Step 4: Secure the inverter
A) Place the SureSine onto the surface and align the keyhole slots with the
four (4) pilot holes.
B) Use the four (4) #10 screws (included) to secure the SureSine to the
surface.
For optimal ventilation and cooling, mount in portrait style orientation.
Portrait Orientation TERMINAL TORQUE REQUIREMENTS
*For recommended/minimum wire sizes and disconnect/fuse sizes per application, and terminal block installation for the remote switch or communications options, see the SureSine Installation and Operations Manual.
Power UP Sequence:
- Connect Battery/Battery Bank. (STEP 11)
- Close all circuit breakers, disconnect switches, or insert fuse into fuse holder. (STEP 12)
- Put the AC Output Mode Switch in the ON (or REMOTE) position. (STEP 13)
Power DOWN Sequence:
- Put the AC Output Mode Switch in the OFF position.
- Open all circuit breakers, disconnect switches, remove fuses from fuse holders.
- Disconnect Battery/Battery Bank.
Specifications*:
DIP Switch Settings:
LED Indications:
AC Output Mode Switch:
1 The Status LED flickers ON very briefly when the LED is OFF. The Status LED
flickers OFF very briefly when the LED is GREEN or RED solid. The “heartbeat”
occurs every 5 seconds.
2 0.5 Hz. Rate
3 See the SureSine Inverter Installation and Operations Manual for details.
Contact Information:
Technical Support:
morningstarcorp.com/support
Phone: 1-215-321-4457
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>