LUXRITE LR24966 4 Inch Module Interchangeable Trim Spotlight Instruction Manual
- June 15, 2024
- LUXRITE
Table of Contents
**LUXRITE LR24966 4 Inch Module Interchangeable Trim Spotlight Instruction Manual
**
IMPORTANT:
READ ALL INSTRUCTIONS BEFORE INSTALLING FIXTURES. KEEP FOR FUTURE
REFERENCE. SAFETY:
FOR YOUR SAFETY, THIS FIXTURE MUST BE WIRED IN ACCORDANCE TO LOCAL ELECTRICAL
CODES AND ORDINANCES. ALL WORK SHOULD BE DONE BY A QUALIFIED ELECTRICIAN.
WARNING: MAKE SURE POWER IS OFF FROM THE ELECTRICAL PANEL BEFORE STARTING
INSTALLATION OR ATTEMPTING ANY MAINTENANCE. INDOOR INSTALLATION ONLY. TOOLS
REQUIRED: SAW, MEASURING TAPE, ELECTRICAL WIRING (USE TAPE AND GAUGE SUITABLE
FOR APPLICATION TO CONNECT THE FIXTURES.
PRE-INSTALLATION
- Mount the appropriate trim (Round or Square) on the module.
- Twist the trim to lock on the module securely.
- Turn power OFF from the electrical panel before starting installation.
- Locate a suitable position to place the fixture and open in accordance to the cut-hole dimensions (refer to Hole Cut Table for appropriate size).
- Run electrical wire from the switch (power supply) through the mounting hole-use NMD90 Romex or BX cable.
DRIVER WIRING
-
Open the hardwire box swing cover and remove the appropriate knockout(s).
-
Insert the electrical supply cable through the knockout and secure with a cable connector (sold sepparately).
-
Using wire nuts, connect green ground wire of cable to green wire on box. Connect black wire of cable to black wire of box. **(Fig. 2)
**
-
Place all wiring and connections back into the box and close the cover.
-
Insert hard wire box through the mounting hole. **(Fig. 3).
**
NEW CONSTRUCTION APPLICATIONS: Hard wire box shall be firmly secured to
studs, joists, or similar fixed structura units.
REMODEL APPLICATIONS: Do not require the hard wire box to be firmly
secured after the mounting plates, studs, joists, or structural units have
been concealed.
FIXTURE INSTALLATION
-
Connect the fixture to the hard wire box by inserting and twisting the male/female connectors and use switch to select Color Temperature. **(Fig. 5).
**
-
Push spring loaded clips on the fixture upwards and insert fixture base into the mounting hole. Release the clips and fixture will be pulled flush to the ceiling. **(Fig. 6).
**
-
Once assembly is complete, turn on power to confirm fixture is working properly.
4″ MODULE
4″ ROUND TRIM
4″ SQUARE TRIM
4″ MODULE – CUTOUT: @ 3.75″ (95mm)
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>