Baoqi BQ886 Wireless Remote Control Massager Instruction Manual
- June 15, 2024
- Baoqi
Table of Contents
OPERATING INSTRUCTION
Vibration Operation
- Long press ” “or” NO OFF “to power on, the LED light flashes and enters the standby state. At this time, you can use the remote control.
- In standby mode: Press” “or” NO OFF “to start vibration. There are 10 vibration frequencies that can be switched continuously. (if no signal command is received for more than 3 hours, the product will automatically shut down.)
- Long press” “or” NO OFF” to power off. LED lights are off.
- The product has weak vibration and cannot be turned on, please charge it.
Invisible charging port. (DC5V)Insert the charging cable straight.
Luminous Remote Control Operation
Short press: 10 vibration frequencies can be switched continuously
Long press: Standby mode
Vibration is strengthened, increasing by 6 levels in turn
Vibration is weakened, decreasing by 6 levels intern
It becomes brighter after absorbing the light source.
(When the remote control cannot be operated, please replace the “CR2032”
button battery.)
(The contents of this manual may be modified due to product improvement
without prior notice, and the actual product shall prevail.)
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
RF wamings for Portable device: The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.
MADE IN CHINA
Documents / Resources
|
Baoqi BQ886 Wireless Remote Control
Massager
[pdf] Instruction Manual
BQ886 Wireless Remote Control Massager, BQ886, Wireless Remote Control
Massager, Remote Control Massager, Control Massager
---|---