Paulmann 705.28 MaxLED 1000 LED Strip RGBW Basic Set Instruction Manual
- June 15, 2024
- Paulmann
Table of Contents
Paulmann 705.28 MaxLED 1000 LED Strip RGBW Basic Set
Product Information
Specifications
- Model: A++
- Energy Efficiency Rating: A
- Water Protection: IP20
- Driver for 705.28: 50VA
- Driver for 705.29: 75VA
- Battery Type: Li-Ion (CR2025, 3V, 150mAH)
Product Usage Instructions
Safety Instructions
Please follow the safety instructions below to ensure safe usage of the product:
- Refer to safety instructions numbered 1, 12, 14, 17, 23, 25, 26, 33, and 34 in the user manual.
Installation
- Make sure the power is turned off before installation.
- Place the product in the desired location.
- If required, connect the appropriate driver for your model (705.28: 50VA, 705.29: 75VA).
- Ensure proper water protection based on the IP rating (IP20 for indoor use, IP44 for outdoor use).
Battery Replacement
To replace the battery, follow these steps:
- Ensure the power is turned off.
- Locate the battery compartment on the product.
- Open the battery compartment cover.
- Remove the old battery.
- Insert a new CR2025 Li-Ion battery with the correct polarity (+/-).
- Close the battery compartment cover securely.
Maximum Distance
The maximum distance for each model is as follows:
- 705.28: 1.5m
- 705.29: 3m
- 705.30: 2.5m
INSTALLATION
Replaceability
- Light source or
- the operating device can be replaced by end users without permanent damage to the luminaire.
- Light source or
- The operating device can be replaced by a qualified electrician without permanently damaging the luminaire
- . The light source or
- the operating device is not replaceable, the luminaire must be replaced.
This product contains a light source with an energy efficiency
class.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>