MANAYO DM3 In Line Microphone Preamp User Manual
- June 15, 2024
- MANAYO
Table of Contents
MANAYO DM3 In Line Microphone Preamp
Product Description
MANAYO DM3 is a high quality, ultra-low noise in-line microphone preamplifier with larger gain than other products. Whether you are a professional recording studio or a podcaster or video creator who are using a dynamic or ribbon microphone, this preamplifier can improve the sensitivity and performance of your low-output microphones, by providing a fixed 28db clean gain to boost up your recording signal and improve your audio performance.
Product Specification
- Gain: 28dB;
- Input Dynamic Range:102db;
- Output Noise<6uV;
- Frequency Response:20Hz-20KHz +/-0.1 dB;
- THD+N:<0.05°/o@1 KHz;
- Input lmpedence:3 KO
Operating Instruction
Installation Guide 1
Plug the DM3 amplifier into an audio interface/ mixer with 48v phantom power supply and connecting it to a dynamic or ribbon microphone by a xlr cable as shown in the picture above. Please turn on the 48v phantom power on your audio interface/mixer when using, otherwise the DM3 mic preamp will not work .
Installation Guide 2
Plug the DM3 preamp into your dynamic or ribbon microphone and connect it to a an audio interface/ mixer with 48v phantom power supply by a xlr cable as shown in the picture above. Please turn on the 48v phantom power on your audio interface/mixer when using, otherwise the DM3 mic preamp will not work.
Announcements
If the microphone does not work after DM3 mic preamp is connected, please confirm:
- DM3 in-line mic preamp is only suitable for dynamic microphone and ribbon microphone. If your microphone is a condenser microphone, DM3 will not work.
- DM3 in-line mic preamp requires a 48v phantom power supply to start working. If your audio interface does not have a 48v phantom power supply, DM3 will not work.
Q &A
Q: The microphone does not work after connecting DM3.
A: we will carefully test and check to ensure that each product can work
normally before shipping them to Amazon. Therefore, if it cannot be used,
please check: 1. Is your microphone a condenser microphone. Because DM3 are
only compatible with dynamic microphones and ribbon microphones. 2. Please
confirm whether the 48v phantom power supply is turned on, because DM3 can
only work with 48v phantom power supply. 3. Check whether the microphone
switch is on. 4. Check whether the volume control button of the monitoring
headphone is on.
Q: Whether there will be noise after connecting DM3.
A: The function of DM3 is to improve the sensitivity of the microphone
and boost up 28db gain to your mic, which is larger than other products
(average 20-25db gain). Therefore, after connecting DM3, the performance of
the signal collected by your microphone will be greatly improved, including
amplifying the ambient noise around you. Therefore, please use the DM3
amplifier in a quiet environment.
Q: DM3 needs 48v phantom power supply, will it damage my microphone?
A: The 48v phantom power supply only supplies power to the DM3
preamplifier, the power will not be transferred to your microphone, so it will
not damage your microphone.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>