MANAYO PM5 Phono Pream For MM Turntable User Manual
- June 15, 2024
- MANAYO
Table of Contents
MANAYO PM5 Phono Pream For MM Turntabl
Product Introduction
PM5 is a phono preamplifier suitable for MM cartridges, which can converts the phono signals to line level signals. The shell of the body is made of aluminum alloy, which is light, strong and durable. Gold plated RCA input/output jack design allows for more stable transmission and more durable quality This device is equipped with gain control and volume control knob, you can more accurately adjust the output audio amplitude and quality to match the power amplifier input requirements more easily.
Function Introduction
- Power Switch: Flip upward to turn on the power after connecting to the power supply.
- Power Indicator: After the power switch is turned on, the green indicator is steady on.
- Gain Control Knob: The input gain can be adjusted from +6db to + 36db
- Volume Control Knob: Control the volume of the output signal.
- 3.5mm Headphone Jack: You can listen to music through headphones (when the headphone is connected, the output of the back panel will be disconnected).
Function Introduction
- Power Input : AC12v 500mA (Please use the dedicated power adapter).
- Signal Input: Suitable for MM cartridges.
- Amplifier output : Connect external active speakers.
- GND : Used to connect the ground cable of turntable. (If your turntable does not need a ground cable, it can be omitted)
Specification
- Gain range : 6~36db
- Power Adaptor Output: 12V AC 500mA
- Product Adaptor Input Voltage : 120AC 60Hz Phono Preamp DC Input
- Voltage :+/-12V DC
- Input sensitivity : -24db
- Output Voltage Level:6V
- Load Impedance : 2.7MQ
- SNR ≥ -78db
- THD ≤ 0.01%
- Frequency Response : 10-20KHz
- Product Weight : 390g
- Product Dimensions : 20612339mm
Operating Instruction
NOTE
- Check whether the correct adapter is used when connecting to the power supply
- Please be sure to use good quality cable to connect the turntable and active speaker to avoid extra noise.
When starting to use PM5, the correct sequence to turn on the equipment is turntable -PM5- active speaker; The shutdown sequence is active speaker -PM5- record player. Please put the volume knob in a larger position, adjust the gain knob to get the suitable volume, there will be less background noise if the gain knob at a smaller position, and the music will be more clean.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>