CONOPU OZM22Q02 Lint Removers for Clothes Instruction Manual

Lint Remover
Product Manual

Please read the manual carefully before use and keep it properly for future reference.

Product Description

Accessories Machine body, 2 blades as standard, Extra 2 blades included, charging cable, small cleaning brush,

Instructions for use

Steps to use

1. Place the garment flat on a flat surface (as in figure 1).
2. Press and hold the switch button for 2 seconds, the machine turns on and enters the 1st gear working state by default (the white light is always on). Press the switch button again briefly to cycle through the gears between 1-2-3-1, the number of times the white light flashes when switching gears corresponds to the gear. After switching on, press and hold the on/off button for 2 seconds in any gear and the machine will switch off (see fig. 2).
3. Move the shaver vertically and horizontally to remove lint balls (as in Fig. 3).

Warm tips: firstly pls put the clothes flat, cut the hair ball should pay attention to the following positions Warme Tipps
If you find any abnormalities or faults with this product, please stop using it immediately, handle it according to the type of fault and contact customer service for repair if necessary.
Note: This product should not be used on soft fabrics such as down jackets, satin, stockings etc. which are easily broken.
Steps for replacing the blades

1. Take off the bottom shell
2. Unscrew the stainless steel mesh
3. Replace the blade
4. Screw on the Stainless steel mesh and cover the bottom shell

Cleaning steps

1. Take off the bottom shell
2. Unscrew the stainless steel mesh
3. Clean with a small brush
4. Screw on the Stainless steel mesh and cover the bottom shell

Cautions

1. To clean the machine, use a neutral cleaner diluted with water, dip a cloth in the cleaner, wring it out and wipe the dirty spots, do not use banana oil or petrol as this can lead to fire or electric shock damage to the plastic parts.
2. Do not use in places where the ambient temperature is below 5°C or above 35°, where light can shine directly on the device, or where it is connected to hot objects such as heating equipment or incandescent lamps for charging. Otherwise, the charging time may become shorter and fire, electric shock and product deformation may occur.
3. The blade is a consumable product, after the service life, the blade will become blunt and will also lead to damage to the clothing, it is recommended to replace it with a standard time state of about 50 hours of use.

Fault Analysis & Troubleshooting

What to do if the machine doesn’t work
Reason analysis,

1. Check whether the knife net is screwed in place and whether the magnetic suction of the base is in place.
2. Check whether the machine has electricity.
3. Check whether the knife head and wind blade are stuck by foreign objects.
4. Contact customer service for after-sales advice.

What to do if the hairball is not cut cleanly when trimming
Reason analysis,

1. Check whether the knife net is screwed in place.
2. Check whether the machine has sufficient power.
3. Check whether the chip storage tank has accumulated too much, clean up in time.
4. Check whether the knife head is worn out, replace the blades.

What to do if the machine makes much noise when working
Reason analysis,

1. Check whether there are foreign objects stuck in the knife network and blades, clean in time.
2. Check whether the blades are damaged and replace it.

What to do if the machine fail to charge
Reason analysis,

1. Check if the charging socket is plugged in properly.
2. Contact customer service for after-sales advice.

Safety Attentions

1. Do not pull out the charging cable by grasping it, as this may cause the cable to break and the connector to be damaged.
2. Do not insert fingers or metal objects into the blade section as this may result in damage to the machine and injury to persons.
3. The cutting edge of the blade is very sharp, so use with extreme caution.
4. Do not open the machine when it is necessary to remove or install the cutter head.
5. As both the knife screen and the blades are thin, do not press down forcibly or hit them with hard objects to avoid damage.
6. Please install the knife net and blade correctly, otherwise it may cause injury to the user or damage to the product.
7. Please do not use the blade directly on clothing as this may cause damage to the clothing.
8. This product is only suitable for general clothing hairball trimming, please do not use it for other purposes as this may lead to unnecessary accidents or machine failure.
9. Please check the blades for damage or deformation before use, if there is any abnormality please do not use, otherwise damage to clothing may occur.
10. Do not place this product in a place where children can reach it or use it as a toy, as this may cause injury to children.
11. For safety reasons, please do not go outside while charging.

About the battery

1. This product has a built-in lithium polymer battery of 1200mAh, the battery comes with its own protection plate.
2. Charging can be completed in about 3.5 hours (it is recommended to use charger 5V, 1A), the indicator light shows red when charging, the indicator light shows green when charging is completed, each full charge can work for 60 minutes.
3. Before charging, please check if there are any foreign objects around the socket such as hair shavings, water drops, etc., clean it up before inserting it, otherwise it may lead to fire, electric shock or short circuit.
4. If not used for a long time, the battery will deteriorate due to natural discharge, so please charge it once every six months even if it is not used for a long time.
5. Do not place the machine in a place with high temperature or direct sunlight when charging, and remove the charger in time after charging to avoid accidents caused by overcharging the battery.

Warning

1. Do not disassemble the battery at will.
2. Be aware of any abnormalities in the machine during use to avoid damage or shock to the battery.
3. Do not place the removed battery in a place where young children may come into contact with it.
4. If the liquid inside the battery leaks, do not touch it with your hands. In case of accidental contact with eyes or skin, rinse immediately with water and consult a doctor immediately.
5. The lithium-ion polymer batteries used in this product are a renewable and environmentally friendly resource. When disposing of this product, please take the lithium-ion batteries to an officially designated recycling centre or a special battery recycling bin for reuse and do not throw them away.
6. When disposing of the device, the battery must be removed.
7. When removing the battery, the appliance must be disconnected from the power supply.
8. Batteries should be disposed of in a safe manner.

Product Parameters

Warranty

We appreciate your feedback and will do our best guarantee your satisfaction.
Within 1 year after your purchase,shall the product has defects, we will provide a refund or resend you a new one. Please email us with your concern and order number. Your inquiries will be taken care of as soon as possible.
This warranty only cover orders from authorized brand online stores and our official website. We are not responsible for any purchases from other distribution channels.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>