XIANDA S20PRO Open Bluetooth Headset User Manual
- June 15, 2024
- Xianda
Table of Contents
XIANDA S20PRO Open Bluetooth Headset
Specifications
- Bluetooth Version: BT5.3
- Transmission Distance: Android – 15 meters, Apple – 20 meters
- Call Time: Up to 8 hours
- Playing Time: Up to 8 hours
- Charging Case Standby Time: Up to 300 days
- Headphone Standby Time: Up to 200 hours
- Headphone Charging Time: 60 minutes
- Single Earphone Battery Capacity: 90mAh
- Charging Box Battery Capacity: 450mAh
- Input: 5V/1A
Product Usage Instructions
Touchable Area
The touchable area on the earphones is as follows:
- (L) Double Click: Play / Pause
- (R) Double Click: Next Song
- (L) Triple Click: Previous Song
- (R) Triple Click: Volume+
- (L) Press 1 time: Volume-
- (R) Press 1 time: Siri
- (L) Long Press 2s: Call / End Call
- (R) Long Press 2s: Standby / Power On / Power Off
Connection
To connect the earphones, please follow these steps:
- Open the charging box.
- Take out the earphones.
- Turn on Bluetooth on your device to search and pair.
Pairing
- Open the charging box.
- Take the left and right earphone out of the charging box. The white indicator will flash for 2 seconds.
- One earphone will flash a white light, while the other earphone will not flash.
- Turn on the Bluetooth of your mobile phone and search for “S20 Pro”. Click to connect.
- You will hear a voice notice indicating Bluetooth mode.
How to Reset
To reset the earphones, please follow these steps:
- Take the headset out of the charging case and then close the charging case.
- When the earphone flashes a white light, touch it 6 times continuously. Both left and right earphones can be operated in this mode.
- After that, put the two earphones back into the charging case and close the charging case.
- Then take out the two earphones again and wait for 6 seconds. The earphones will be paired automatically.
FAQ
-
Q: Can I clean the earphones with corrosive cleaners?
A: No, do not use corrosive cleaners to clean the earphones. -
Q: Can I expose the earphones to places with high temperatures?
A: No, please avoid exposing the earphones to places where the temperature is too high. -
Q: How should I dispose of used batteries?
A: Please dispose of or recycle used batteries according to the user guide. Do not attempt to open or disassemble the battery, and do not throw the battery into a fire as it may explode.
Accessories
- Charging box*1
- Bluetooth headset*2
- User Manual*1
- USB-C charging cable*1
- Sling*1
Parameters
- BT version: BT5.3
- Charging box standby time: about 300 days
- Headphone standby time: about 200 hours
- Talk time: about 480 minutes
- Playing time: about 480 minutes
- Charging time: about 60 minutes
Touchable area
Connection
Open the charging box, take out the earphones, and turn on Bluetooth to search
and pair.
Pairing:
- Open the charging box, take the left and right earphones out of the charging box, white indicator will flash for 2 seconds.
- One earphone will flash a white light; the other earphone will not flash.
- Turn on the Bluetooth of the mobile phone, search for “S20 Pro” and click to connect.
- Voice notice “Bluetooth mode”
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Note : This equipment has been tested and found to comply with the limits
for a class B digital device, under Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in
a residential installation.
This equipment generates uses and can radiate radio frequency energy and,if
not installed and used by the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will
not occur in a particular installation. if this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment into an autlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.
How to reset:
- Take the headset out of the charging case, and then close the charging case.
- When the earphone flashes white light, touch it 6 times continuously (the left and right earphones can operate the mode)
- After that, put the two earphones back into the charging case and close the charging case.
- Then take out the two earphones again, wait for 6 seconds and the earphones will be paired automatically
Instructions
Specifications
Precautions
- Do not use corrosive cleaners to clean the earphones.
- Do not expose the earphones to places where the temperature is too high. Please put the earphones at room temperature to work. The working temperature of the earphone is -20~80°C.
- Do not let the earphones touch sharp objects, so as not to cause scratches and damage.
- Please stay away from WIFI routers and other places where Bluetooth devices are concentrated, to avoid interference from other signal devices to this product.
- Please use this product within the effective distance (10M without occlusion).
- If it is not applicable for a long time, please store the earphones in a dry place and charge them at least once a month to prolong the battery life. Avoid extreme temperatures and dust.
- Please dispose of batteries and earphones according to local regulations, do not dispose of them as household waste.
Li-ion polymer battery
- Do not attempt to open or disassemble the battery.
- Do not short-circuit the battery.
- The battery may explode if thrown into a fire.
- Please dispose of or recycle used batteries according to the user guide
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>