FIAMMA VW T5 Pro 02096-71A Carry-Bike Instruction Manual
- June 13, 2024
- FIAMMA
Table of Contents
FIAMMA VW T5 Pro 02096-71A Carry-Bike
Package contents
TOOL REQUAID
DIMENSION
CARRY-BIKE
Check that nothing has been damaged or deformed during transport. In the event of doubts or questions concerning the installation, use or limitations of the product, contact the dealer. We recommend that the installation is carried out by qualifi ed personnel and in compliance with current local regulations.
Installation
Do not undo them completely
To fi x the lower brackets, it is necessary to pull down the structure.
Make sure that the fastening of the Carry-Bike is steady.
Tighten the screws fi rmly
Check the correct alignment of the bracket with the tailgate.
Safety instructions
Attention: keep the following labels and affi x them to the Carry-Bike rails.
For models with electric tailgate.
Attention: Before assembly, the customer is advised to contact their VW dealer
to check the correct seal of the gas pistons in accordance with the weight of
the carry-bikes and to check their wear. Fiamma denies all liability for
damage caused by pistons not suited to support the weight of the carry-bikes.
It is also advisable to carry out the installation carefully and to check,
during automatic closure of the tailgate, the correct adherence of the lower
brackets so as not to damage the rear lights.
Read the following instructions and warnings carefully; failure to observe
these installation and usage instructions as well as the laws for driving in
the relevant country may cause severe harm or damage for which the
manufacturer declines all responsibility. Before installation, ensure
compatibility with the vehicle on which the product must be installed.
In the event of an accident involving the vehicle and/or the product, ensure
that the product has not been damaged. In the event of damage, contact your
local retailer before moving the vehicle.
Fiamma declines every responsibility for any modifi cation of the product that
may cause damage and/or injury to things and people.
Checking that the wall/rear door is suffi ciently solid and suitable for
guaranteeing the resistance of the anchoring points is always mandatory. If
not, strength and compliance with the maximum load indicated in the
instructions are not guaranteed and it will be necessary to reinforce these
points. After having positioned the Carry-Bike on the rear axle of the
vehicle, the normal weight distribution on both axles would be modifi ed. This
variation must not exceed the maximum permissible axle load.
Never exceed the maximum permitted length and the total weight of the full-
load vehicle.
Make sure that loading occurs following a correct weight distribution; it must
be uniformly distributed (the heaviest bike must be placed near the wall of
the vehicle) to ensure better stability.
Always give warnings about the presence of the Carry-Bike on your vehicle,
using a clearly signal for leaning loads and, in case of limited rear
visibility, use the additional rear-view mirrors.
Take into account the presence of the Carry-Bike, paying attention during
driving and expecially during reversing manoeuvres, particularly if you have
parking assist system.
Always comply with speed limits and the Highway Code.
The speed should always be suitable to traffi c conditions and towed load.
In case of use of the bike carrier with tow make sure that the tow hook is
always accessible and the corner mobility of the tow is guaranteed (volume
measuring din 74058).
Check periodically the bicycle rack to make sure it is fi rmly attached,
especially during the fi rst kilometers of after long trips to avoid damages
of the Carry-Bike/vehicle. Make sure the belts are not loose and that the
holding brackets have not shifted. Replace worn components immediately.
Make sure that the support brackets are located where they cannot move or
shift sideways.
They also must not touch the roof of the vehicle, the hinges and the
corresponding bolts or screws.
While assembling, pay attention not to close the rear door if screws and
brackets of the Carry-Bike are not tightened, the light sources could be
damaged.
Make sure that, during roar door opening, the Carry-Bike and/or the Bike-Block
do not touch the roof of the vehicle (raised roof) and/or its opening systems
(pop-up roofs).
During Carry-Bike installation, verify that there is enough distance between
handlebars and/or pedals and the vehicle’s rear windows in order to avoid any
damages of the window van; do not leave accessories attached (bay seats,
baskets, etc) because vibrations could disengage bikes.
In some cases, the rear windscreen wiper may not work due to the presence of
bicycles. Be aware of the brush radius before operating the windscreen wiper.
On this type of Carry-Bike, bike covers are not allowed (Bike Cover).
It is advisable to remove the batteries from bicycles, before loading them on
the Carry-Bike while traveling.
Depending on the type of bicycles transported, check the correct visibility of
the rear lights. If the visibility is missing, provide a light repeater bar.
You can open the tailgate with the Carry-Bike mounted without bikes.
It is recommended to rotate the handlebars of bicycles to avoid damage to the
vehicle wall, for which Fiamma declines all responsibility.
RAIL PREMIUM Item No. 98656M150
RAIL PREMIUM S Item No. 98656M152
RAIL PREMIUM S FAT BIKE Item No. 98656M151
KIT RAIL PREMIUM 48 Item No. 98656M14
BIKE-BLOCK PRO D
BIKE-BLOCK PRO S D
BIKE-BLOCK PRO S
BIKE FRAME ADAPTER Item No. 06602-01-
PLASTIC SIGNAL Item No. 98782-005
ALU SIGNAL Item No. 98782-010
CABLE-LOCK Item No. 98656-338
LICENCE PLATE CARRIER Item No. 06146C01A
Warranty Fiamma
In case of defects with regards to materials and manufacturing, the customer
is entitled to the warranty in accordance with local laws and regulations of
the country in which the product was purchased.
Fiamma S.p.A. – Italy
Via San Rocco, 56
21010 Cardano al Campo (VA)
fiamma.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>