Woodpeckers 43695989194990 Protractor T-Square Owner’s Manual

: June 16, 2024
: Woodpeckers

Table of Contents

43695989194990 Protractor T-Square
ADJUST THE ANGLE
SCRIBING GUIDES
CALIBRATION
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

PRECISION WOODWORKING
PROTRACTOR T-SQUARE
OWNER’S MANUAL

43695989194990 Protractor T-Square

Scan the QR code above to watch the video or visit woodpeck.com under the video tab towards the bottom of the product page.

https://www.woodpeck.com/ott-protractor-t-square-2022.html

If you think you’re missing anything, email us at mailroom@woodpeck.com
You can also call us at 800-752-0725 from 9:00 a.m. to 4:00 p.m. EST Monday – Friday.

ADJUST THE ANGLE

Loosen the (2) Angle Lock Knobs on the rear of the T-Square. The Angle Lock Knobs do not need to be loosened very much, one quarter to a half turn should be more than enough. FIGURE A.
Rotate the Blade relative to the Protractor Head until the desired angle is achieved.
Re-tighten the Angle Lock Knobs to secure the angle.
The angle is read from the Hairline Indicator. FIGURE B.

SCRIBING GUIDES

Set the Blade angle to 90°
NOTE: The Scribing Guides only function correctly when the blade is set to 90°.
Place a mechanical pencil in the desired hole, then slide the Head along the edge of the material while moving the marking instrument with your other hand.

CALIBRATION

The Hairline Indicator is factory calibrated on the Protractor T-Square.
If the angle measurements are off, re-calibration may be necessary.

Begin by loosening the (2) Angle Lock Knobs on the rear of the T-Square.
Set the T-Square to 90° by using a known good square reference, such as a Woodpeckers 1281 Square (sold ). FIGURE B.Separately at woodpeck.com.
Once set to 90°and lock the (2) Angle Lock Knobs to secure the angle. FIGUREA.
Next, loosen the (2) Button Head Screws that secure the Hairline Indicator to the pivoting core using the Hex Wrench.
Keep the Hairline Indicator pressed against the circular section at the top end of the Blade, and pivot until the Hairline reads exactly on the 90° line.
Tighten the (2) Button Head Screws on the Hairline Indicator in place.

Your Protractor T-Square is now re-calibrated. Woodpeckers, LLC Strongsville, Ohio
woodpeck.com
© 2023 Woodpeckers, LLC
**[woodpeck.com](http://woodpeck.com)
At Woodpeckers we are constantly reviewing & improving our tools.
The most current version of our instruction manuals are always available to download at woodpeck.com.
(Located in the bottom section of the tool’s page under the “Additional Information” or “Instructions” tabs.)
Be the first to know all the new products, OneTIME Tools & sales by subscribing to our eClub. (Located at the top center of our webpage woodpeck.com.)
Subscribe to our YouTube channel to stay up-to-date on all the latest tool tips & tricks.
INTERACT WITH US! Follow us on Facebook, Instagram & TikTok!
Enjoy shop tips, project ideas, tool techniques & more in our Woodworking Resource Center/Blog. (Located at the bottom center of our webpage woodpeck.com.)
WARNING!** This product can expose you to chemicals, including chromium, which is known to the State ofCalifornia to cause cancer and birth defects orother reproductive harm.
For more information go to www.P65Warnings.ca.gov