WELLSHAVE 8317 Men Shaver Instruction Manual

MODEL. 8317
MEN SHAVER

HAIR TRIMMER INSTRUCTION MANUAL

SPECIFICATIONS

A. Protective cap
B. Swivel head
C. Turret head base
D. Turret head release button
E. Power button
F. Charging indicator
G. Beard trimmer
H. Cleaning brush
I. USB Charging cable
J. User manual

Charging time: about 1.5 hours
Running time: about 1.5 hours
Capacity: 700mAh
Applicable adapter| Input: 100-240V 50/60Hz
Output: DC 5V 1000mA
Power: 5W

SAFETY

• Keep the instruction manual for future use and read this manual thoroughly before operating this device. Follow all safety instructions to prevent damage from improper use.

• The device is intended for household use only.

• Never use the device if the shaving head or the USB charging cable show signs of damage.

• This product must only be used with the voltage corresponding to the information on the device.

• Use only with the power supply unit supplied with the device.

• After charging, disconnect the USB charging cable.

• Note: Always keep the USB charging cable dry.

• When charging the device, do not allow it to come into contact with water or any other liquid.

• Never use the device if the blade blocks are visibly damaged. – After charging, always disconnect the USB charging cable from the wall socket.

• Do not drop the device.

• To protect the USB cable, do not bend, kink or perform other actions that may damage the overall integrity of the cable.

• Never place the device, accessories or USB charging cable on or near hot surfaces.

• Ensure that the voltage on the product matches the voltage in the area where the product will be used.

• Always keep the device out of the reach of children.

• Do not use the device if it is damaged. In case of damage, stop using it immediately and contact our customer service for instructions on how to return it for repair or replacement. If the supplied USB charging cable is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified person to avoid danger.

• This device may be used by children over 8 years of age and persons with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, if they are supervised or instructed in the safe use of the device and understand its hazards.
  Children must not play with the device. Cleaning and user maintenance should not be performed by children without supervision.

• A damaged power cable cannot be repaired. Be sure to dispose of the USB cable according to environmental regulations.

OPERATING INSTRUCTION

PACKAGE CONTENT (Fig. A)

Shaver x1
Trimmer x1
USB power cable x1
User manual x1
Protective cover x1
Rotating head x1
Cleaning brush x1

TRAVEL LOCK

• The shaver is equipped with a travel lock to prevent accidental turning on.
• Activate travel lock: press and hold the power button 3S, the indicator light converges from the ends; the travel lock is activated
• and the shaver is locked (fig. B).
• Deactivate travel lock: hold down the power button 3S, the light spreads to both ends; the travel lock is deactivated. (Fig. C)

CHARGING THE DEVICE

• Connect the USB charging cable to the applicable adapter and other power supply or directly to your computer. (Fig. D)
• Keep the product and USB charging cable dry while charging.
• The light blinks when the battery is low and continues to rise and fall during charging; the light illuminates for 3 seconds and then blinks for 1 second to indicate that the battery is fully charged. (Fig. E)
• Note: Use only the applicable adapter with this unit. It must be charged for at least 1.5 hours before first use. A 5-minute charge provides approximately one use.

SHAVING

• Press the power button to turn on the shaver. (Fig. F& J}
• Press the power button to turn the shaver off after use. (Fig. H&L)
• This shaver can be used with or without a cord. (Fig. F)
• Clean the shaver after each use with the brush provided and put on the protective cap when not in use to avoid damage.
• Do not use it if the shaver is damaged as it may hurt your skin.
• DRY SHAVING (Fig. G}
• Best results are achieved when used on dry skin.
• It may take 2 to 3 weeks for skin to become accustomed to dry shaving.
• When shaving, apply only light pressure with straight and circular movements against the direction of beard growth.
• wet shaving (fig. G)
• You can also use this shaver on wet skin while showering with shaving foam or shaving gel. Follow the steps below to shave with shaving foam or shaving gel:
• Apply water to your skin.
• Apply shaving cream or shaving gel to your skin.
• Rinse the shaver to allow it to glide smoothly over your skin.

TRIGGERING

• This operation requires replacing the attachment, see “Attachment Replacement and  Cleaning Instructions” to replace the trimmer head. {Fig. I)
• Use the trimmer head to shape your beard or sideburns. (Fig. K)

WARNING

• To avoid personal injury, keep this product away from water when charging.
• Be careful with the blades as they are very sharp.
• Never press on the blades and the shaving net, or on hard objects, as this may cause irreparable damage to the shaver or its components.

REPLACEMENT OF ATTACHMENT & CLEANING

• Turn off the unit when changing or cleaning attachments. (Fig. A).

• Remove the rotating head by lifting it up from the shaver. (fig. B)
  To reassemble the rotating head, place it in an accurate position on the shaver and press it down until it locks into place. The rotating head release button should be in the same direction as the front of the shaver.

• Press the rotating head release button to open the shaver head. (Fig. C)

• Pull the shaving unit off the rotating head (fig. D).

• Clean the beard residue located on the inside of the rotating head and shaving unit. (fig. D)

• For thorough cleaning, turn the latch counterclockwise to remove the attachment frame (fig. E), then remove the shaving blades and nets in turn from the shaving unit. (fig. FJ

• Brush off the beard residue thoroughly with the brush and rinse under water. weekly use (fig. G).

• Place the shaving nets, blades and shaving frames back into the shaving unit in turn (fig. H). Make sure the holding frame is locked, otherwise the shaving head cannot be closed smoothly.

• Mount the shaving unit back on the base of the rotating head; and mount the rotating head back to the shaver. (Fig. IQ.

• Refer to (fig. A) to remove the rotary shaver head; mount the trimmer head with the blade facing the back of the shaver and push the trimmer head down until it locks into place. (Fig. J)

• Clean the trimmer with the brush or by rinsing it under running water. (Fig. K}

• Clean the trimmer under running water and let it dry before using it again (fig. L).

WARNING

• The device must be cleaned regularly so that you can continue to enjoy its top performance and optimal results.
• You should always turn off the shaver before cleaning it.
• Ensure that no water gets into the shaver or charger to avoid the risk of electric shock when it is put back into use.
• This product is IPX6 rated so it can be cleaned under running water. Do not completely submerge the unit in water.
• Disconnect the USB power cable (adapter) before using a device for an extended period of time, store it carefully.
• Make sure it is unplugged and completely dry.
• Store the device in a cool, dry place.
• Keep device out of the reach of children.

STORAGE

•  use a device for an extended period of time, store it carefully. – Make sure it is unplugged and completely dry.
• Store the appliance in a cool, dry place.
• ENVIRONMENTS. device is kept out of the reach of children.
• This device contains a built-in rechargeable battery. The battery must be removed from the device before disposing of it.
• Never replace the battery with other types of batteries, especially non-rechargeable ones. This may cause fire or electric shock.
• Never dispose of batteries in the regular garbage; make sure to dispose of batteries at an official recycling center or a collection point.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>