BRIZO 8GA-XAD-240 Auto Drain Valve Instruction Manual

113694 8GA-ADD-240 & 8GA-ADD-208
AUTO DRAIN INSTRUCTIONS
INSTRUCTIONS CONCERNANT

Image is for reference only.

Model Number: ____
Date of Purchase: ____
Register Online
www.brizo.com/customer-support/product-registration

To reference replacement parts and access additional technical documents and product info, visit www.brizo.com

1-800-355-6478
www.brizo.com/customer-support/contact-us

Read all instructions prior to installation.
CAUTION
Failure to read these instructions prior to installation may result in personal injury, property damage, or product failure. Manufacturer assumes no responsibility for product failure due to improper installation.
WARNING
Disconnect the power to the generator before removing the generator cover and connecting the Auto Drain.

Installation

This auto drain valve can be used on all 8GE-TSG series steam generators.

1. Connecting the Auto Drain to the drainage system
   a) When installing the Auto Drain valve, make sure the directional arrow on the valve points away from the steam unit.
   b) Using ½” pipe and a union (not supplied), connect the drain outlet to a drainage system. The pipe must be pitched down and away from  the steam generator; the water will drain by gravity.
   IMPORTANT: Any upward pitch of the drain would collect sediment, prevent proper draining and cause damage to the steam generator.
   NOTE: Do NOT connect the auto drain pipe to the steam line, Safety Relief Valve line, or to the generator pan.
   IMPORTANT: When connecting the drain outlet to the drainage system, be sure to follow National and Local Plumbing codes.
   c) Pipe the Auto Drain outlet to empty into a floor drain. The outlet should be connected to an indirect waste line and must have a minimum air gap of twice the diameter of the Auto Drain pipe. The air gap is measured from the top rim of the floor drain to the end of the Auto
   Drain pipe. The floor drain must be properly vented and trapped.
   NOTE: Valve MUST be in CLOSED position before use. Move lever up to release into the closed position (See Figure 1).

2.   Operation of the Auto Drain
   The Auto Drain valve is normally a closed valve which opens each time the steam generator drains. The valve is held closed throughout the steambath cycle and remains closed after the steambath until the steam generator cools for approximately 8 hours. During the Auto Drain cycle
   the drain valve will remain open for 3 minutes total. After 2 % minutes the water solenoid valve will open and flush the tank.

3. Wiring
   Make sure the power is disconnected to the generator. Have an electrician connect the two black leads from the valve to the terminal block located on the circuit board of the steam generator. Check the connection at the terminal block to make sure the wires are not shorted before turning the power back on.
   CAUTION
   Using an electrician for this step is recommended to avoid personal injury.

Figure 1

Limited Warranty on Brizo® Steam Bath and Steam Shower Products Applicable to products purchased and installed in the USA and Canada

Residential Steam Bath Generators: Brizo Kitchen and Bath Company (“Brizo”) warrants to the original consumer purchaser that the parts (except for electronic parts) of its residential steam bath generator purchased from authorized Brizo sellers will be free from defects in materials and workmanship for as long as the original consumer purchaser owns the home in which the steam bath was originally installed. This lifetime limited warranty does not apply to residential steam bath generators that are used in commercial applications (as defined herein).
Residential Electronic Parts, Controls, Spa Options and Accessories: Brizo warrants to the original consumer purchaser that the electronic parts of its steam bath generator and its controls, spa options and accessories purchased from authorized Brizo sellers will be free from defects in materials and workmanship for a period of two (2) years from the date that the product is received by the original consumer purchaser or their authorized representative (installation contractor, etc.). This two-year limited warranty does not apply to controls, spa options, electronic parts and accessories that are used in commercial applications (as defined herein).
Commercial Warranty: For the purposes of this warranty the term “commercial application” refers to installation in any setting in which the product is not being used for personal household use, including, but not limited to, hospitality applications, day spas and short-term and long-term rentals. Brizo warrants that the parts (including electronic parts) of its steam bath generators (including steam bath generators with model numbers beginning with 8GE that are 7.5kW-15kW), equipment, controls, electronic parts, spa options and accessories purchased from authorized Brizo sellers and used in a commercial application will be free from defects in materials and workmanship for a period of one (1) year from the date that the product is received by the original purchaser or their authorized representative (installation contractor, etc.).
What We Will Do: Brizo will, at its option, repair or replace, free of charge, any part that proves defective in material and/or workmanship under normal installation, use and service during the applicable warranty period as stated above. Brizo may elect to refund the purchase price. Replacement parts are subject to availability and may differ from those originally supplied. For residential applications, two (2) years following the date that the product was received by the original consumer purchaser or their authorized representative (installation contractor, etc.) and with prior approval by Brizo, Brizo will pay for labor for repair/replacement associated with warranty coverage. Thereafter, Brizo will not pay for labor associated with removal/repair/replacement of products covered by this warranty. For commercial applications, Brizo will, with prior approval by Brizo, pay for labor associated with warranty coverage for ninety (90) days from the date that the product is received by the original purchaser or their authorized representative (installation contractor, etc.). Thereafter, Brizo will not pay for labor associated with removal/repair/replacement of products covered by this warranty. These are the consumer’s exclusive remedies. What Is Not Covered: Because Brizo is unable to control the quality of Brizo products sold by unauthorized sellers, unless otherwise prohibited by law, this warranty does not cover Brizo products purchased from unauthorized sellers. This warranty does not cover damage caused by improper or negligent installation or use. Provided that Brizo is paying the cost of the labor under the terms above, this warranty does not cover repairs attempted by any person other than an authorized Brizo agent and shall be limited to the repair or replacement of defective parts by Brizo or its authorized agent.

This warranty is void if any of the following should occur:

• The use of the product for an unintended application, including a commercial application for all products except those products for which a commercial application is appropriate.
• Failure to follow instructions, including care, cleaning and usage instructions, provided in the product’s owner’s manual.
• The product’s serial number has been altered or removed.
• The product is modified in any manner which Brizo concludes, after its inspection, affects the reliability of the product.
• The product has been improperly repaired by anyone not specifically designated or authorized by Brizo.
•  The product is damaged because it is not operated or installed in accordance with supplied instructions.
• The product is installed outdoors.
• The product is installed in a moist and/or humid area with unconditioned air or temperatures that exceed 104 degrees Fahrenheit.
• The product is damaged due to freezing.
•  The product is damaged by acts of God.

How to Make a Warranty Claim: To obtain warranty repair or replacement, contact Brizo at: 800-355-6478 or steamprodserv@brizo.com to receive an RGA# (Return Goods Authorization number) which must be on the carton that is returned via UPS Ground or equivalent. Proof of purchase (original sales receipt showing purchase date) identifying the model and serial number and documentation of the date of receipt of the product by the original purchaser or their authorized representative (installation contractor, etc.) must accompany all warranty claims.
Limitation on Duration of Implied
Warranties: Please note that some states/provinces (including Quebec) do not allow limitations on how long an implied warranty lasts, so the below limitations may not apply to you.
TO THE MAXIMUM EXTENT PERMITTED BY APPLICABLE LAW, ANY IMPLIED  WARRANTY, INCLUDING THE IMPLIED WARRANTIES OF  MERCHANTABILITY AND OF FITNESS FOR A PARTICULAR PURPOSE, IS LIMITED TO THE
STATUTORY PERIOD OR THE DURATION OF THIS  WARRANTY, WHICHEVER ISSHORTER.
Limitation of Special, Incidental or Consequential Damages: Please note that some states/provinces (including Quebec) do not allow the exclusion or limitation of special, incidental or consequential damages, so the below limitations and exclusions may not apply to you.
TO THE MAXIMUM EXTENT PERMITTED BY  APPLICABLE LAW, THIS WARRANTY DOES NOT COVER, AND BRIZO  SHALL NOT BE LIABLE FOR, ANY SPECIAL, INCIDENTAL ORCONSEQUENTIAL DAMAGES WHETHER ARISING OUT OF BREACH OF ANY EXPRESS OR IMPLIED WARRANTY, BREACH OF CONTRACT, TORT, OR  OTHERWISE.
Additional Rights: This warranty gives you specific legal rights, and you may also have other rights which vary from state/province to state/province. This is Brizo’s exclusive written warranty and the warranty is not transferable.

113720 8GA-PAN & 8GA-XAN
GENERATOR PAN INSTRUCTIONS

Image is for reference only.

Model Number: ____
Date of Purchase: ____

Register Online
www.brizo.com/customer-support/product-registration

To reference replacement parts and access additional technical documents and product info, visit www.brizo.com

1-800-355-6478
www.brizo.com/customer-support/contact-us

Read all instructions prior to installation.
CAUTION
Failure to read these instructions prior to installation may result in personal injury, property damage, or product failure. Manufacturer assumes no responsibility for product failure due to improper installation.

Generator Pan Installation

1.  Place the generator pan on a flat surface suitable for the Steam Generator.
2.  The generator pan pipe must be run in a manner as to not obstruct any possible flow of water out of the pan.
3. The generator pan pipe must terminate over a suitable waste receptor or extend outside the building in an observable location. The termination point must be at least 6”, but not more than 24”, above ground level.
4. The plumbing installation must conform to all local and national codes.
5.  The generator pan pipe must be run in a continuous downward slope to acheive adequate drainage. Termination of the drain line must allow complete drainage at all times, and not be affected by freezing temperatures.
6.  See separate plumbing and auto drain installation manuals for complete connection details.

Typical Installation

Limited Warranty on Brizo® Steam Bath and Steam Shower Products Applicable to products purchased and installed in the USA and Canada

Residential Steam Bath Generators: Brizo Kitchen and Bath Company (“Brizo”) warrants to the original consumer purchaser that the parts (except for electronic parts) of its residential steam bath generator purchased from authorized Brizo sellers will be free from defects in materials and workmanship for as long as the original consumer purchaser owns the home in which the steam bath was originally installed. This lifetime limited warranty does not apply to residential steam bath generators that are used in ommercial applications (as defined herein).
Residential Electronic Parts, Controls, Spa Options and Accessories: Brizo warrants to the original consumer purchaser that the electronic parts of its steam bath generator and its controls, spa options and accessories purchased from authorized Brizo sellers will be free from defects in materials and workmanship for a period of two (2) years from the date that the product is received by the original consumer purchaser or their authorized representative (installation contractor, etc.). This two-year limited warranty does not apply to controls, spa options, electronic parts and accessories that are used in commercial applications (as defined herein).
Commercial Warranty: For the purposes of this warranty the term “commercial application” refers to installation in any setting in which the product is not being used for personal household use, including, but not limited to, hospitality applications, day spas and short-term and long-term rentals.
Brizo warrants that the parts (including electronic parts) of its steam bath generators (including steam bath generators with model numbers beginning with 8GE that are 7.5kW-15kW), equipment, controls, electronic parts, spa options and accessories purchased from authorized Brizo sellers and used in a commercial application will be free from defects in materials and workmanship for a period of one (1) year from the date that the product is received by the original purchaser or their authorized representative (installation contractor, etc.).
What We Will Do: Brizo will, at its option, repair or replace, free of charge, any part that proves defective in material and/or workmanship under normal installation, use and service during the applicable warranty period as stated above. Brizo may elect to refund the purchase price. Replacement parts are subject to availability and may differ from those originally supplied. For residential applications, two (2) years following the date that the product was received by the original consumer purchaser or their authorized representative (installation contractor, etc.) and with prior approval by Brizo, Brizo will pay for labor for repair/replacement associated with warranty coverage. Thereafter, Brizo will not pay for labor associated with removal/repair/replacement of products covered by this warranty.
For commercial applications, Brizo will, with prior approval by Brizo, pay for labor associated with warranty coverage for ninety (90) days from the date that the product is received by the original purchaser or their authorized representative (installation contractor, etc.). Thereafter, Brizo will not pay for labor associated with removal/repair/replacement of products covered by this warranty. These are the consumer’s exclusive remedies.
What Is Not Covered: Because Brizo is unable to control the quality of Brizo products sold by unauthorized sellers, unless otherwise prohibited by law, this warranty does not cover Brizo products purchased from unauthorized sellers. This warranty does not cover damage caused by improper or negligent installation or use. Provided that Brizo is paying the cost of the labor under the terms above, this warranty does not cover repairs attempted by any person other than an authorized Brizo agent and shall be limited to the repair or replacement of defective parts by Brizo or its authorized agent.
This warranty is void if any of the following should occur:

• The use of the product for an unintended application, including a commercial application for all products except those products for which a commercial application is appropriate.
• Failure to follow instructions, including care, cleaning and usage instructions, provided in the product’s owner’s manual.
• The product’s serial number has been altered or removed.
• The product is modified in any manner which Brizo concludes, after its inspection, affects the reliability of the product.
•  The product has been improperly repaired by anyone not specifically designated or authorized by Brizo.
•  The product is damaged because it is not operated or installed in accordance with supplied instructions.
•  The product is installed outdoors.
• The product is installed in a moist and/or humid area with unconditioned air or temperatures that exceed 104 degrees Fahrenheit.
• The product is damaged due to freezing.
• The product is damaged by acts of God.

How to Make a Warranty Claim: To obtain warranty repair or replacement, contact Brizo at: 800-355-6478 or steamprodserv@brizo.com to receive an RGA# (Return Goods Authorization number) which must be on the carton that is returned via UPS Ground or equivalent. Proof of purchase (original sales receipt showing purchase date) identifying the model and serial number and documentation of the date of receipt of the product by the original purchaser or their authorized representative (installation contractor, etc.) must accompany all warranty claims.
Limitation on Duration of Implied Warranties: Please note that some states/provinces (including Quebec) do not allow limitations on how long an implied warranty lasts, so the below limitations may not apply to you. TO THE MAXIMUM EXTENT PERMITTED BY APPLICABLE LAW, ANY IMPLIED WARRANTY, INCLUDING THE IMPLIED WARRANTIES OF MERCHANTABILITY AND OF FITNESS FOR A PARTICULAR PURPOSE, IS LIMITED TO THE STATUTORY PERIOD OR THE DURATION OF THIS WARRANTY, WHICHEVER IS SHORTER.
Limitation of Special, Incidental or Consequential Damages: Please note that some states/provinces (including Quebec) do not allow the exclusion or limitation of special, incidental or consequential damages, so the below limitations and exclusions may not apply to you. TO THE MAXIMUM EXTENT PERMITTED BY APPLICABLE LAW, THIS WARRANTY DOES NOT COVER, AND BRIZO SHALL NOT BE LIABLE FOR, ANY SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES WHETHER ARISING OUT OF BREACH OF ANY EXPRESS OR IMPLIED WARRANTY, BREACH OF CONTRACT, TORT, OR OTHERWISE.
Additional Rights: This warranty gives you specific legal rights, and you may also have other rights which vary from state/province to state/province. This is Brizo’s exclusive written warranty and the warranty is not transferable.

References

• brizo.com
• Contact Us : Customer Support : Brizo
• brizo.com/customer-support/product-registration

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>