SPLITSKY 400ML Aroma Diffuser User Manual

Table of Contents

SPLITSKY 400ML Aroma Diffuser

This diffuser uses ultrasonic waves to instantly vaporize water and essential oil in the tank, to produce a cool fragrant mist.

Product Description

Remove the cover. Fig1
Connect one end of AC adaptor to the port of the bottom. Fig2
When adding water, use the scale mark to add the right amount of water to the tank.(Do Not add high temperature water) from the water pipe pay attention to the filled water level; do not exceed the max line, Please do not add water when the product is working. Drop essential oil into water tank vertically. Fig 3
Replace the cover to the diffuser. Fig4
Insert the AC adaptor to the power outlet.
Press button “MIST”, choose the working hours you want (1H, 3H, 6H or ON), “NO” is the continuous working, but when press “MIST’ button five times (from lH), the power will be off. Fig 5
Press “light’ button to change the color of LED light. There are 7 colors of lights, you can choose the lights you are like. Fig 6
lf you have not used it for a long time, please pour out the water from water tank, dry and keep it well. If you want to use it again, please use the neutral detergent to clean the water tank again, then you can use it
When the power is on, the initial state of diffuser is on timing “1H”.
lf no water in the tank, even though the press the “MIST”, the diffuser will automatically turn off.
You can control the mount of mist,
Large mist: Keep pressing the “MIST” button for 3 seconds and 2 sounds
Small mist: Keep pressing the “MIST” button for 3 seconds and 1 sounds

Product use time: 6 hours
The amount and intensity of mist produced will be vary, but this is not unusual and should not be considered as a fault.
Factors that affect mist include water type, humidity, temperature, air currents.
Auto power off when water runs out.

In the event of the unit being knocked over or tipped during use, please follow the steps as below to avoid malfunction:

Unplug the unit and remove cover.
pour out any remaining water from the water tank.
shake the unit gently to drain water, and then keep it natural air drying for at least 24 hours.

After using 5-6 times or 3-5 days, please clean the product as follow:

Unplug the power supply and remove cover.
Pour the remaining water out of the water tank.
Add a amount of detergent and warm water, use swab to wipe it gently and cleaning cloth to dry it lightly.
Refer to the following pictures, to avoid water flow into the air outlet, pour off water abide by the left picture, not the right one.
Do not use other acids or enzymes detergents, otherwise it may give off poisonous gas or cause malfunction.
Note: Be sure to use a mild detergent.

Please follow below to avoid malfunction of the diffuser:

Do not fill water over 400ML”MAX* at any time.
Do not switch on power when the water tank is empty.
Do not touch the ultrasonic vibration plate.
clean regularly as per maintenance instructions to avoid malfunction.
Always unplug from power supply before maintenance.
For hygiene reasons, after use, pour away remaining water from “DRAIN SIDE” of tank, and wipe it with a clean dry cloth.
Use the cup to add water into the tank do not fill water directly from the water pipe.
Do not let mist below on furniture, clothing, walls etc.
Keep away from direct sunshine.
Always keep on plat surface, do not place on carpet, duvet or unstable area.
Keep away from electronic equipment, such as TV and Auto equipment.
Do not tip the product this may cause water to enter the mechanism and cause malfunction.
use tap water only, does not use mineral water sparkling water etc.
Never move product in use.
Do not touch any part of the product with wet hands.
Keep out of reach of children and pets.
Keep cord clear of pathways, and do not pull forcefully at any point.
lf smoke or burning smell is detected, unplug immediately.

Please refer to the table below in the event of the product operating abnormally:

If the product doesn’t work well, please refer to the flawing points before requesting repairs:

Can not switch on or switch off|

No mist or abnormal mist|

Not enough water? or too much water 7
Please add the right amount of water in the tank, water must never be fi lied over 400ML (MAX).
Dirt on the ultrasonic plate?
Please refer to maintenance instructions remove and re-install correctly, so mist can be released freely.
Cover and inner cover are not installed properly?
Dirt on the air suction port on the underside of the base?
If too much dust in the air suction port, the mist will be restricted to come out. Just clean it.

Water leak out of the diffuser|