CLIM ART 307002 In Channel Incredibly Durable Rain Guards Instruction Manual
- June 15, 2024
- Clim Art
Table of Contents
CLIM ART 307002 In Channel Incredibly Durable Rain Guards
INSTALLATION MANUAL
SIDE WINDOW DEFLECTORS
- Before installing the deflectors, please read the manual.
- Incorrect installation of deflectors can cause danger or injury.
COMPLETE SET
- 4 (2) Piece Set (the product may differ from the illustration in the instructions)
- Front Driver Side Window Deflector
- Front Passenger Side Side Window Deflector
- Rear Driver Side Window Deflector
- Rear Passenger Side Window Deflector
- Instruction manual
- Plastic blade (1 piece)
- Alcohol wipe (2 pieces)
- Fastening bracket (4 pieces)
ATTENTION!
- ATTENTION! Read the installation instructions carefully and follow all POINTS in the text! Incorrectly Installed deflectors can be dangerous. If In doubt, please contact Calm Art.
THE TERMS USED IN THIS INSTRUCTION MANUAL
- Deflector frame
- Back part of deflector
- Front part of deflector
ATTENTION! Protective film, DO NOT REMOVE!
FRONT DEFLECTORS
REAR DEFLECTORS
FRONT DEFLECTORS
- ATTENTION! Clean the installation surface with a supplied alcohol wipe. If the deflector installation process is not followed, the manufacturer does not guarantee the secure installation of the product.
- Make sure the car windows are clean and dry. Next, lower the side windows completely and clean the grease off the inner surface of the window channel with an alcohol wipe.
- Remove the protective liner from the tape on the deflector.
- Place the front section of the deflector on the lower frame of the window as shown in the illustration.
- Shift the deflector forward, fitting the deflector frame , into the channel completely. Make sure the deflector is placed above the lower window frame.
- Bending the center part of the deflector outwards, insert the rear section of the deflector into the channel, leaving a gap above it.
- Starting with the front section of the deflector, insert it into the window channel.
- Immediately after installing the deflector, adjust its position by carefully pulling it outwards.
- To ensure the best installation of the deflector and the best adhesion between the tape and the surface of the rubber seal, it is strongly recommended that you use the plastic blade, moving it slowly between the window’s inner rubber seal and the deflector.
- Raise the window until it touches the deflector. Carefully pulling the deflector outwards, roll up the window with abrupt movements. Repeat this action 4-5 times, then leave the window closed.
- Repeat points 1.1 to 1.9 on the opposite side of the vehicle.
- REAR DEFLECTORS (FOR FOUR-DOOR VEHICLES)
- Make sure the car windows are dean and dry. Next, lower the side windows completely and dean the grease off the inner surface of the window channel with an alcohol wipe.
- Remove the protective liner from the tape on the deflector.
- he deflector must be installed starting at the rear. To do so, place the rear section of the deflector frame irate the channel and move the front section upwards. Position the entire deflector frame iron the window channel.
- Immediately after installing the deflector, adjust its position by carefully pulling it outwards.
- Place the fastening brackets onto the outside part of the rubber seal as shown in the picture. The fastening brackets must touch the lower part of the deflector.
- To ensure the best installation of the deflector and the best adhesion between the tape and the surface of the rubber seal, it is strongly recommended that you use the plastic blade, moving it slowly between the window’s inner rubber seal and the deflector.
- Raise the window until it touches the deflector. Careful pulling the deflector outwards, roll up the window with abrupt movements. Repeat this action 4-5 times, then leave the window dosed.
- Repeat points 2.1 to 2.7 on the opposite side of the vehicle.
CONGRATULATIONS!
Your unique and durable deflectors are installed to give you joy! From this
moment on we hope you enjoy their appearance!
- If you have any questions about warranty, technical aid or requests for missing (lost) parts, do not hesitate to contact
- Customer Service: by phone : + 1 888 311 11 25, by email: customerservice@sparklinesinc.com.
- We are glad to work for you and your vehicle to produce high quality products, which have ideal fit, easy installation and enjoyment with everyday use.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>