RUGGED RIDGE 11543.16 Winch Mount Plate Gladiator JL and JLU Installation Guide
- June 15, 2024
- RUGGED RIDGE
Table of Contents
Part #11543.16
460 HORIZON DR. | SUWANEE, GA 30024
PHONE:770-614-6101 | FAX:
770-614-6069
www.omix-ada.com
11543.16 Winch Mount Plate Gladiator JL and JLU
OMIX-ADA ® TECHNICAL SUPPORT
PHONE: M-F 8am – 5pm EST 1-800-449-6649
| TICKET: webmaster@omixsupport.com
-
Disconnet fog lights and remove factory bumper, lower air dam, center cover, and lower cross bracket.
-
Remove OE Inner Frame Horn Bracket. Loosely attach Winch Plate reusing OE bolts.
Skip to Step 4 if installing Rugged Ridge Spartacus Front Bumper
Optional: if reinstalling OE lower air dam the lower air bracket will need to be modified. -
Remove OE Lower Air Dam Brackets, and set hardware aside. Using drimel and drill, slot factory brackets as shown. Debur area and paint to reduce the likelihood of corrossion.
-
Loosely attach Bottom Plate to Winch Plate using supplied 1/2” hardware.
-
Mopar Steel Bumper: Using OE bolts and slotted Air Dam Brackets, loosly attach Bottom Plate to lower cross member.
Rugged Ridge Bumper: Using supplied spacer, nut plate, and supplied 3/8” hardware, loosely attach Bottom Plate to lower cross member.
If installing Rugged Ridge Spartacus Front Bumper, complete steps 2-4 on Front Bumper Instructions. Then complete Winch Plate Instruction Step 6. -
Tighten Winch Plate hardware. Install Winch on Winch Plate.
If installing Rugged Ridge Spartacus Front Bumper, complete steps 7-12 on Front Bumper Instructions. -
Remove factory winch delete plate and fairlead cover plate from Mopar Steel Bumper. Position Bumper on Frame Horn and Bottom Plate using Factory Tow Hook. Loosely attach with factory nuts.
Tighten all Bolts. Attach lower air dam
Copyright © 2017 Omix-Ada ® , Inc.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>