Haier 959 Heat Pump Dryer User Guide

Haier 959 Heat Pump Dryer

THANK YOU!

THANK YOU FOR PURCHASING A HAIER PRODUCT!

Please read this instructions carefully before using this appliance. The instructions contain important information which will help you get the best out of the appliance and ensure safe and proper installation, use and maintenance.

Installation

• Ensure a location which allows opening the door fully. Do not install the tumble dryer behind a lockable door,
  a sliding door or a door with hinges on the opposite side of the tumble dryer door as this limits the full opening of the tumble dryer door.

• Install the appliance in a well-ventilated, dry place.

• Never install the appliance outdoors in a damp place, or in an area which may be prone to water leaks such as
  under or near a sink unit. In the event of a water leak cut power supply and allow the machine to dry naturally. Install or use the appliance only where the temperature is above 5°C.

• Do not place the appliance directly on a carpet or close to a wall or furniture.

• Do not expose the appliance to any frost, heat or direct sunlight or in the near of heat sources (e.g. stoves, heaters).

• Make sure that the electrical information on the rating plate agrees with the power supply. If it does not, contact an electrician.

• Do not use multi-plug adapters and extension cables.

• Make sure not to damage the electric cable and the plug. If damaged have it replaced by an electrician.

• Use a separate earthed socket for the power supply which is easy accessible after installation. The appliance must be earthed.

Control panel

Settings:

1. Hygienic indicator

2. Anti-crease indicator

3. Empty tank indicator

4. Clean filter indicator

5. Child-lock indicator

6. Display

7. Wifi indicator

8. Delay indicator

9. Signal indicator

10. Start/Pause button

11. Program knob

12. Power button
    Functions:

13. Hygienic button

14. Child-lock button

15. Anti-crease button

16. i-time button

17. Temp. button

18. Dry level button

19. Delay button
    

SETTINGS

• Power button
  In order to turn ON or OFF the appliance please press power button (12). Kindly remember to unplug the appliance when turning OFF the machine.

• Start/Pause
  Press Start/Pause to Start a drying cycle. Press button again to pause the drying cycle.

• Display
  The display shows the remaining time, the delay time and other related information.

• Wifi indicator

• This indicator remind users Whether the Wifi connected or not. If the Wifi connection is Successful. this indicator will light up.

APP PAIRING PROCESS

Download the
 App

• Child lock indicator
  Child lock is designed to prevent children from adjusting the program setting. To activate this function, after a cycle has been started, press the Hygienic and Anti crease button at the same time for 3 seconds until the indicator icon lights up. To deactivate it, press these 2 buttons for 3 seconds again.

• Buzzer indicator
  The buzzer is deactivated by default. To activate the buzzer function, press the 2 buttons (Dry level and Temp.) at the same time for 3 seconds or until you hear a beep sound. To deactivate it, press the same two buttons for 3 seconds again.

FUNCTIONS

• I-time button
  This function is designed to allow users to adjust cycle duration based on personal needs.

• Temp. button
  This button is set to adjust drying temperature based on personal needs or requirements. There are 3 levels:

• Dry-level button
  Press the button to set the final moisture content of the laundry at the and of the cycle. Cupboard| Ready to wear| Ready to iron
  ---|---|---

• Anti-crease indicator
  Anti-crease function is designed to help remove wrinkles of clothes. The drum will rotate after the drying cycle to stretch clothes so there is no need to worry about forgetting to take out clothes. When the drying cycle ends, if Anti-crease was previously selected the indicator will light up. The drum will keep rotation for another 6 hours with cold wind in.

• Hygienic indicator
  Hygienic function is designed to kill bacteria and mites as well as virus on clothes with high temperature. When selecting the Hygienic function, this indicator is the perfect cycle to use if you want to remove bad smells from the linens smoothing creases. This cycle can quickly refresh the garments that you need, ensuring the best compromise between time and drying performance.

• Delay
  Delay function allows users to delay the start time of the cycle (From 0 to 24 hours with 0.5 step hours). When activated, the indicator icon lights up.

PROGRAMS

Cotton
For drying cotton clothes or coats. The values on the Energy Label are based on this programme.

Mix
A new innovative cycle to dry different kinds of fabrics in the same time.

Synthetics
To dry synthetic fabrics that need an accurate and specific treatment.

Quick dry
A short timing cycle that allows you to have items ready in a short time. Perfect to dry small amount of light weight Chemical fiber or cotton clothing.

Timer
Specifically design for different type of fabrics. The users can decide with complete autonomy the drying time by themselves.

Delicate
A cycle design to dry delicate fabrics that need an accurate and specific treatment.

Remote
Select this program to remotely control the device through WiFi settings. In this case, the start of cycle will take place through the App commands.

Wool
For drying wool clothes. It is recommended to reverse all clothes before drying

Towel
Sets the best drying parameters for towels and other durable fabrics. Providing high heat and keeping at the same time they integrity of the cotton fiber.

Duvet
The perfect cycle for your duvets, that minimize the tangles and folds thanks specific movement of the drum.

Sports
Takes care of your technical garments used for sport and fitness. the machine dries gently with special care to avoid shrinking and deterioration of elastic fiber.

I-Refresh
An Haier patent-owned cycle, that allows the machine to take of your different fabrics together ( cotton ) and synthetic), drying them out with only 30’.

****|

| ****

DRYING TIME

| SELECTABLE OPTION
---|---|---|---
8| 9| 10| 11| min| Hygienic| Anti crease| Delay| Temp.| Dry level| i-time
| Cotton| 8| 9| 10| 11| 150| ✓| ✓| ✓| ✓| ✓| timer
| Mix| 4| 4| 4| 4| 125| ✓| ✓| ✓| ✓| ✓| timer
| synthetics| 4| 4| 4| 4| 100| ✓| ✓| ✓| ✓| ✓| timer
| Quick dry| 1| 1| 1| 1| 30| ✓| ✓| ✓| ✓| | timer
| timer| 8| 9| 10| 11| /| ✓| ✓| ✓| ✓| —| ✓
| Delicate| 2| 2| 2| 2| 100| ✓| ✓| ✓| ✓| ✓| timer
| Remote| /| /| /| /| /| —| —| —| —| —| —
| Wool| 1| 1| 1| 1| 70| ✓| ✓| ✓| —| —| ✓
**| Towel| 6| 6| 6| 6| 220| ✓| ✓| ✓| ✓| ✓| timer
| Duvet| /| /| /| /| 250| ✓| ✓| ✓| ✓| —| timer
| Sports| 4| 4| 4| 4| 94| ✓| ✓| ✓| ✓| ✓| timer
**| i-Refresh| 1| 1| 1| 1| 30| ✓| ✓| ✓| ✓| —| ✓

Care and maintenance

Lint filter cleaning
To clean the lint filter ( please clean the lint after every cycle ):

1. Open the door;

2. Extract the filters A and B in sequences pulling them upwards as showing in the figure.
   

3. Gently remove lint’s from both filter using your fingertip or a soft brush. a cloth or under water running.
   

4. Close both filters by repositioning them inside the door. making sure thy are positioned correctly in place.

Heat exchanger cleaning

1. Remove the kickplate;

2. Turn the handle anti-clockwise and pull out the front cover;

3. Gently remove the sponge filter frame.

4. Gently remove the sponge from the frame;

5. Wash the sponge by holding it under the running tap running it so to remove any dust are fluff. Wring out the sponge and refute it carefully on the frame.

6. Refit the sponge filter frame ensuring that is it in the correct position.

Notice

If the lint/ the condenser filter is very dirty. it can be cleaned under running water. let it dry thoroughly before use.

Water tank

Pull out the water tank from its housing. Than empty the water tank. Once you finish please reinstall the water tank to the tumble dryer.

IMPORTANT: Empty the water tank after each drying cycle. See empty the water tank section of the manual.

Drain Hose installation

In order to avoid to empty the water container after each drying cycle, the water can be discharged directly to a
waste water drain pipe ( figure 1 ).

1. The water drainage system is located at the back of the machine on the lower right side;
   

2. Disconnect the hose(A) from the fitting (B) by pulling it upwords. Close the Extracted tube with the cap (C) supplied with the kit (figure 2):
   

3. Connect the hose into the fitting (B) making sure it (figure 3-4).
   

Care label

Please check the care labels on your garment. especially when placing it in the tumble dryer for the first time.
Below are the most commonly used symbol.

 May be tumble dried.

 Tumble dry – high heat.

 Do not tumble dry.

 Tumble dry – low heat.

Customer Support

Download the hOn App

For information please refer to www.haier-europe.com

References

• haier-europe.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>