THULE 302043 Elite Van XT Bike Racks Instructions

THULE 302043 Elite Van XT Bike Racks

Product Information

• Product Name: Thule Elite Van XT Black VW Crafter < 2017 MB Sprinter > 2006
• Model Number: 302043
• Manufacturer: Thule
• Weight: 10.5 kg
• Max Load Capacity: 35 kg

Product Usage Instructions

Installation

• Attach the product to the VW Crafter < 2017 or MB Sprinter > 2006 according to the provided installation instructions.
• Use the provided screws and brackets for secure installation.

Glue Application

• Thule recommends using Dekalin MS 5, SIKA 252, or Terostat MS937 glue for sealing purposes.
• Follow the instructions provided by the glue supplier for preparation and sealing.

Usage

• Ensure that the product is properly installed and secured to the vehicle.
• Load the bikes onto the bike carrier frame, starting with the biggest/heaviest bike closest to the car.
• Fasten all bikes securely using the included long strap.
• Remove any loose parts from the bikes, such as child seats, baskets, locks, and cycle pumps before departure.
• Check that all belts and fasteners are secure before each trip and retighten if necessary.
• Note that the vehicle’s total length will increase when the bike carrier is attached, and the bikes may increase the vehicle’s total width.

Accessories

• Additional accessories such as Strap Lock (307389) and Locking Wire (538000) can be used for added security and convenience.

Safety Instruction

• Thule absolves itself of responsibility for any personal injuries or damage caused by incorrect fitting or use of the product.
• Follow all safety instructions provided in the manual.
• Always ensure that the product is properly installed and secured before use.
• Do not exceed the maximum load capacity of 35 kg.
• Make sure that all bikes are securely fastened to the bike carrier frame using the included long strap.
• Remove any loose items from the bikes before transportation to prevent danger to others.
• Check and tighten all belts and fasteners before each trip.
• Be aware that the vehicle’s dimensions may change when the bike carrier is attached.

Please refer to the user manual for more detailed information and specific instructions for your vehicle model.

CONTENT

INSTALLATION

Preparation and sealing according to the prescripts of the glue supplier.

Preparation and sealing according to the prescripts of the glue supplier.

USE

ACCESOIRES

 Technical specifications

• Bike-carrier unit weight: 10,5 kg
• Permitted load capacity: max 35 kg

Safety instructions

1. Thule absolves itself of responsibility for any personal injuries or consequential damage to property or wealth caused by incorrect fitting or use.
2. The bike carrier shall be assembled and fitted securely in accordance with the instructions.
3. Firstly check that the wall – where the bike carrier is to be placed – is solid. If not, please reinforce.
4. Preparation and sealing according to the prescripts of the glue supplier. Wait 48 hours before loading the bike carrier.
5. The bike carrier or the transported goods are not allowed to hide the vehicle’s rear light & license plate.
6. The vehicle driver is solely responsible for ensuring that the product is in faultless condition and that carrier and load is securely fastened.
7. Always position the biggest/heaviest bike first and closest to the car, and then position the smaller/lighter bike.
8. Before departure all loose parts should be taken off the bikes, like child seats, baskets, locks and cycle pumps etc. The bikes should contain no loose items during transport and cause danger to others.
9. Always secure all bikes to the bike carrier frame using the included long strap.
10. Check that belts and other fasteners are secure, retighten if necessary.
11. The vehicle’s total length increases when the bike carrier is attached. The bikes themselves may increase the vehicle’s total width and height. Take especial care when reversing and/or entering garages or ferries etc.
12. Replace any damaged or worn parts immediately.
13. The car’s on-road behavior may change especially when taking curves and during braking when the product is fitted.
14. Applicable speed limits and other traffic regulations shall always be followed.
15. Speed should always be tailored to suit safety considerations with regard to traffic conditions and the load being carried.
16.  If projecting more than 40 cm beyond the outer edge of the light emitting surface of the clearance resp. position lamps of the rear mounted carrier, the load shall be provided to the front with a white lamp at the side not more than 40 cm from its edge and not more than 1,5 m above the lane. A red lamp shall be visible towards the rear.
17. The fitted rear mounted carrier or the transported goods are not allowed to cover the vehicle’s third brake light (ISO). The vehicle’s brake light shall be visible from the left and the right sides as follows: relative to the vehicles longitudinal axis at a 10 degree horizontal angle, upwards; relative to the upper edge of the lamp – at a 10 degree vertical angle downwards, relatively to the lower edge of the lamp at a 5 degree vertical angle. If these values are not met, an optional replacement brake light shall be fitted.
18. The carrier is constructed to carry standard-bike-frames. Tandem bikes may not be carried.
19. Modifications to this product are not permitted.
20. Clean the bike carrier regularly using warm water or car shampoo, especially when using / after using at coasts (salt-water) or during times when salt on roads is being used (winter).
21. Check that the bike carrier is securely fitted after driving a short distance (50km) and thereafter at regular intervals.
22. Keep the instructions safely in the car.

Thule NV, Kortrijkstraat 343 – BE 8930 Menen, BELGIUM
infoRV@thule.com
www.thule.com
© Thule Group 2020. All rights reserved

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>