TURTLE BEACH Stealth 600 Gen 2 Headset for PlayStation Instruction Manual

Stealth 600 Gen 2 Headset for PlayStation
QUICK START GUIDE
STEALTH’ 600
GEN 2 USB
IMPORTANT READ BEFORE USING
Any questions?
turtlebeach.com/support
Model: Stealth- 600 Gen 2 USB for Xbox

IMPORTANT

PLEASE MAKE SURE YOUR HEADSET IS UPDATED WITH THE LATEST FIRMWARE.
Connect to the Turtle Beach Audio Hub for Windows or Mac® to update firmware.
turtlebeach.com/audiohub

CONTENTS

CHARGING

The Stealth” 600 Gen 2 USB gives you 24+ hours of recharge- able battery life. Make sure to charge it regularly before storing,

Headset Storage
Always charge your headset before storing it for any extended period of time (greater than 3 months). Never store the unit in temperatures above 113°F/45°C.

HEADSET CONTROLS

SUPERHUMAN HEARING™

Microphone Mute
Flip up mic to mute. There s an audible tone when the micis muted or unmuted.
Use Superhuman Hearing™ Mot to pingoint quiet audio cues ke enemy footsteps and weapon reloads.
During gameplay, you can activate and deactivate Superhuman Hearing” by pressing the POWER button once, quickly.

EQPRESETS

• Signature Sound
• Bass Boost
• Bass + Treble Boost
• Vocal Boost

LED BEHAVIORS

Breathing Green

| (While Charging & On) Battery Full

LED turns off when battery is fully charged if headset is off. Le voyant s’eteint lorsque la batterie est entierement chargee, si le casque est eteint.

I Double-Blink Green Clignote Deux Fois en Vert| Not Paired
Solid Red Rouge et Fixe| (While Charging) Battery Charging
Breathing Red| Battery Low

LED turns off when battery is fully charged if headset is off.

SETUP FOR XBOX

SURROUND SOUND FOR XBOX [ONLY AVAILABLE ON XBOX)

1. Goto Settings > Generat – Volume & Audio Output
2. Set Headset Format to Windows Sonc for Headshones

For updated setup instructions vist: turtlebeach.com/sonic

RE-PAIRING

1. From OFF, press and hold the POWER button on the headset untit the LED starts flashing rapidly.
2. Insert the transmitter into the console.
3. Press and hold the pin-hole button on the side of the transmitter until the LED starts flashing rapidly.
4. After a few moments, the headset and transmitter LEDs will become solid, indicating a successful pairing.

Regulatory Compliance Statements for the EAR FORCE Stealth” 600X Gen 2 USB
Models: Stealth00X-USB-RX & Stealth600X-USB-TX

Local Restrictions on Radio Usage
Caution: Due to the fact that the frequencies used by wireless devices may not yet be harmonized in all countries, these radio products are designed for use only in specific countries, and are not allowed to be operated in countries other than those of designated use, As a user of these products, you are responsible for ensuring that the products are used only in the countries for which they were intended and for verifying that they are configured with the correct selection of frequency and channel for the country of use. Any deviation from the permissible power and frequency settings for the country of use is an infringement of national law and may be punished as such.
To determine whether you are allowed to use your wireless network device in a specific country, please check to see if the radio type number that is printed on the identification label of your device is listed in the manufacturer’s OEM Regulatory Guidance document at the following http://www.turtlebeach.com/homologation or contact Turtle Beach directly.
Federal Communications Commission (FCC) Compliance Notices
This section includes the following FCC statements for the Stealth600X-USB-RX & Stealth600X-USB-TX:

• FCC ID: XGB-2372-RX & XG-2372-TX
• Class B Interference Statement
• RF Radiation Exposure & Hazard Warning
• Non-Modification Statement

Class B Interference Statement
This equipment has been tested and found to comply with the Limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications, However, there is no guarantee that interference will not occur ina particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outtet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

FCC Caution:
This device complies with Part 15 of the FCC Rules, Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
RF Radiation Exposure & Hazard Statement
To ensure compliance with FCC RF exposure requirements, this device must be installed in a location such that the antenna of the device will be greater than 2 cm (0.8 in.) from all persons. Using higher gain antennas and types of antennas not covered under the FCC certification of this product is not allowed. Installers of the radio and end users of the product must adhere to the installation instructions provided in this manual. This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.
Non-Modification Statement
Use only the supplied internal antenna. Unauthorized antennas, modifications, or attachments could damage the Stealthé00X-USB-RX & Stealthé600X-USB-TXand violate FCC regulations. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment. Please contact Turtle Beach for a list of approved 2.4 GHz antennas.
This product is compliant with the Consumer Product Safety Improvement Act of 2008, Public Law 110-314 [CPSIA] Canadian ICES Statements.
IC 3879A-2372RX & 3879A-2372TX [Stealth600X-USB-RX & Stealth600X-USB-TX)
This device compties with ICES-003 and RSS-247 of Industry Canada. Operation is subject to the following two conditions:

1. This device may not cause interference, and
2. This device must accept any interference, including interference that may cause undesired operation of the device.

To prevent radio interference to the licensed service (i.e. co-channel Mobile Satellite systems) this device is intended to be operated indoors and away from windows to provide maximum shielding. Equipment (or its transmit antenna) that is installed outdoors is subject to licensing and not supported by Stealth600X-USB-RX & Stealth600X-USB-TX.
RF Radiation Exposure & Hazard Statement
To ensure compliance with RSS-102 RF exposure requirements, this device must be installed in a location such that the antenna of the device will be greater than 2 cm (0.8 in.) away from all persons. Using higher gain antennas and types of antennas not covered under the IC certification of this product is not allowed. Installers of the radio and end users of the product must adhere to the installation instructions provided in this manual. This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.
European Union and European Fair Trade Association Regulatory Compliance
This equipment may be operated in the countries that comprise the member countries of the European Union and the European Fair Trade Association. These countries, listed below, are referred to as The European Community throughout this document: AUSTRIA, BELGIUM, BULGARIA, CYPRUS, CZECH REPUBLIC, DENMARK, ESTONIA, FINLAND, FRANCE, GERMANY, GREECE, HUNGARY, IRELAND, ITALY, LATVIA, LITHUANIA, LUXEMBOURG, MALTA, NETHERLANDS, POLAND, PORTUGAL ROMANIA, SLOVAKIA, SLOVENIA. SPAIN, SWEDEN, UNITED KINGDOM, ICELAND, LICHTENSTEIN, NORWAY, SWITZERLAND
Declaration of Conformity
Marking by this symbol:

indicates compliance with the Essential Requirements of the Radio Equipment Directive (RED) of the European Union (2014/53/EU). This equipment meets the following conformance standards:

Safety’

IEC 60950-1: 2005 (2nd Ed.) + Am 1: 2009 + Am 2: 2013 (CB Scheme Certificate),
EN 62368-1: 2014 + All (T-Mark License),
IEC 62368-1: 2014 (CB Scheme Certificate),
EN 50332-1: 2013, EN 50332-2: 2013, EN 71-3: 2013
Additional licenses issued for specific countries available on request EMC’
EN 55032: 2015, CISPR 32: 2015,
EN 301 489-1 V2.1.1 (2017-02), EN 301 489-17 V3.1.1 (2016-11)
EN 61000-4-2: 2009, EN 61000-4-3: 2006 + Al : 2008 + A2: 2010,
EN 61000-4-8: 2010 EN 61000-4-4: 2012,
EN 61000-4-6: 2013
(only used when cables are over 3 meters long)
The products are licensed, as required, for additional country specific standards for the International Marketplace. Additional issued licenses available upon request.

Radio: EN 300 328v2.1.2 [2019-07] SAR: EN 62311: 2008
Environmental : RoHS 2015/863 amending Annex II to 2011/65/EU, WEEE 2012/19/EU, REACH 2006/1907/EC, Packaging 94/62/EC, Battery 2006/66/EC, Toys Safety Directive 2009/48/EC
Please visit the following URL for a complete copy of the Declaration of Conformity: http://www.turtlebeach.com/homotogation
Warning! This is a Class B product. In a domestic environment, this product may cause radio interference, in which case, the user may be required to take appropriate measures.
This symbol on the product or its packaging indicates that this product must not be disposed of with your other household waste. Instead, it is your responsibility to dispose of your waste equipment by handing it over toa designated collection point for the recycling of waste electrical and electronic equipment. The separate collection and recycling of your waste equipment at the time of disposal will help conserve natural resources and ensure that itis recycled in a manner that protects human health and the environment. For more information about where you 7 can drop off your waste for recycling, please contact your local authority, or where you purchased your product.
Turtle Beach Europe Ltd is obligated as a producer with a main activity of selling under The Producer Responsibility Obligations (Packaging Waste] Regulations 2007. To fulfil our obligation we are registered with Comply Direct and their Recycling Room. Here you will find advice and information on packaging waste management, recycling symbols and the waste hierarchy principles of reduce, reuse and recycle.
https://www.comptydirect.com/the-recycling-room/

To access the rating label:

1. Remove the lef ear pad by pulling the ear pad straight up using your thumb,
2. 0nce youve released the cloth from the lip o top, pull the ear pad straight back and it should slip right off. Toreplace the ear pad, follow the same process n reverse.

Not seeing what you’re looking for here?
Visit turtlebeach.com/support
for the latest Tech Support information

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>