TURTLE BEACH 2412RX Recon Air Wireless Chat Communicator User Guide

RECON A I R ™
CHAT COMMUNICATOR
WIRELESS
Any questions?
turtlebeach.com/support
Model: Recon Air™ Wireless Chat X-RX,
Recon Air™ Wireless Chat X-TX

https://support.turtlebeach.com/hc/en-us

CONTENTS

Recon Air ™ Wireless Chat Communicator|
---|---
Recon Air ™ Xbox Wireless Transmitter|
Eartips Small / Medium / Large|
USB-C Charging Cable|

CONTROLS

LED BEHAVIORS

“Paired” indication to dim 10 seconds after successful pair.
Solid, Red| Power Off
Fast Blinking, Red & Blue| Mobile Pairing Mode
Fast Blinking, Red & Blue| Firmware Updating
(While the headset is paired with a mobile device)
Pulsing, Red| Low Battery
(While ON)
Pulsing, Blue| Fully Charged
(While connected via USB)

“Paired” indication to dim 5 seconds after successful pair.
Flashing, Blue| Not Paired
Slow Breathing, Red| Mic Muted

The Recon Air ™ gives you 10 hours of rechargeable battery life. Make sure to charge it regularly before storing it.

SETUP

1.  Make sure your Xbox controller is connected to your console and powered on.
2. Connect your transmitter to your Xbox controller’s extension port and aux jack.
3. Press the button to power on the headset.
   Your headset and transmitter will pair automatically.

Go to Audio & Music > set Headset Volume to the maximum.
Adjust Headset Chat Mixer all the way to the right towards the Set Mic Monitoring to your preferred level.

PAIRING

Your Recon Air ™ can pair to the transmitter and your mobile device simultaneously so you can answer calls during gameplay. Follow these instructions to pair to your mobile device:

|
---|---
Power on the Recon Air ™ headset, and double press the Multi-Function Button to put the headset into mobile pairing mode.| Locate the headset within your phone or tablet’s Bluetooth ®settings and connect to it.

The headset and transmitter are paired out of the box, as indicated by the solid LED on the transmitter.
If your transmitter LED is double blinking blue, follow the steps to pair your headset and transmitter:

1. Plug the transmitter into the powered Xbox Controller, while holding down the multi-function button.
2. Press and hold the multi-function button on the transmitter until the transmitter’s pairing LED flashes rapidly, then release.
3.  From the OFF position, press and hold the multi-function button for 5s until the LED flashes red and blue to put the headset into pairing mode.
4.  Keep the headset and transmitter close together until the LED indications are solid, indicating a successful pairing.

ADDITIONAL FEATURES

When the headset is ON and paired to a mobile device, the multi-function button on the headset and its transmitter will allow you to switch between your console chat and a Bluetooth® phone call.

EARTIP REMOVAL

To change the eartips, pull firmly to remove them.
Choose the ear tip that fits best, align with the earbud, and stretch around the grill.

ADJUSTING THE EAR HOOK

The Recon Air ™ may be worn on your left or right ear. Remove the ear hook to switch its direction.

Regulatory Compliance Statements for Recon Air ™ Wireless Chat X-RX, ™ Recon Air Wireless Chat X-TX
Local Restrictions on Radio Usage

Caution: Due to the fact that the frequencies used by wireless devices may not yet be harmonized in all countries, these radio products are designed for use only in specific countries, and are not allowed to be operated in countries other than those of designated use. As a user of these products, you are responsible for ensuring that the products are used only in the countries for which they were intended and for verifying that they are configured with the correct selection of frequency and channel for the country of use. Any deviation from the permissible power and frequency settings for the country of use is an infringement of national law and may be punished as such.
To determine whether you are allowed to use your wireless network device in a specific country, please check to see if the radio type number that is printed on the identification label of your device is listed in the manufacturer’s OEM Regulatory Guidance document at the following URL http://www.turtlebeach.com/homologation or contact Turtle Beach directly.

Federal Communications Commission (FCC) Compliance Notices
This section includes the following FCC statements for the Recon Air ™:

• FCC ID: XGB-2412RX (Headset), XGB-2415TX (Transmitter)
• Non-Modification Statement
• Class B Interference Statement
• RF Radiation Exposure & Hazard Warning

Class B Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.
FCC Caution:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: [1] This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
RF Radiation Exposure & Hazard Statements
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End users must follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must not co-locate or operate in conjunction with any other antenna or transmitter.
Non-Modification Statement
Use only the supplied Internal antenna. Unauthorized antennas, modifications, or attachments could damage the Recon Air ™ Models and violate FCC regulations. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment. Please contact Turtle Beach for a list of approved 2.4 GHz antennas. This product is compliant with the Consumer Product Safety Improvement Act of 2008, Public Law 110-314 (CPSIA)

aaa-ABCDE1
aaa-ABCDE2

To prevent possible hearing damage, do not listen to high volume levels for long periods.

Canadian ICES Statements
This device complies with Industry Canada’s license-exempt RSS.
Operation is subject to the following two conditions:

1. This device may not cause interference, and
2.  This device must accept any interference, including interference that may cause undesired operation of the device.

RF Radiation Exposure & Hazard Statement
The product complies with Canada’s portable RF exposure limits set forth for an uncontrolled environment and is safe for intended operation as described in this manual. Further RF exposure reduction can be achieved if the product can be kept as far as possible from the user body or set the device to lower output power if such a function is available.

European Union and European Fair Trade Association (EFTA) Regulatory Compliance
This equipment may be operated in the countries that comprise the member countries of the European Union and the European Fair Trade Association. These countries, listed below, are referred to as The European Community throughout this document:
AUSTRIA, BELGIUM, BULGARIA, CYPRUS, CZECH REPUBLIC, DENMARK, ESTONIA, FINLAND, FRANCE,, GERMANY, GREECE, HUNGARY, IRELAND, ITALY, LATVIA, LITHUANIA, LUXEMBOURG, MALTA, NETHERLANDS, POLAND, PORTUGAL, ROMANIA, SLOVAKIA, SLOVENIA, SPAIN,
SWEDEN, UNITED KINGDOM, ICELAND, LICHTENSTEIN, NORWAY, SWITZERLAND

Declaration of Conformity

Marking by this symbol:
indicates compliance with the Essential Requirements of the Electromagnetic Compatibility Directive, 2014/30/EU and Low Voltage Directive, 2014/35/EU.
This equipment meets the following conformance standards:

Safety:| EN 62368-1: 2014 (T-Mark License),
IEC 62368-1: 2014 (CB Scheme certificate)
EN 50332-1: 2013, EN 50332-2: 2013, EN 71-3 :2013
---|---
Emissions:| EN 55032: 2015, CISPR 32: 2015
Immunity:| EN 55024: 2010, CISPR 24: 2010
Environmental:| REACH 2006/1907/EC, RoHS 2015/863 amending Annex II to Directive 2011/65/EU, WEEE 2012/19/EU, Packaging 94/62/EC,
Toy Safety Directive 2009/48/EC, Battery 2006/66/EC
Radiofrequency:| 2400MHz
Operating frequency:| 2400~2483.5MHz
Max. Output power:| 10dBm

CC XX xx YY yyy Z z wW
CC XX xx YY yyy Z z wW
R-R-VTB-XXXXXXX
R-R-VTB-XXXXXXX
IFETEL;XXXXXXXX

RECON AIR ™ WIRELESS CHAT COMMUNICATOR FOR XBOX
turtlebeach.com/support
IMPORTANT
Download the companion mobile app for iOS or Android to update your firmware as needed without having to wire in.
turtlebeach.com/audiohubhttps://qrgo.page.link/YXUdB
V_XQ02

Documents / Resources

| TURTLE BEACH 2412RX Recon Air Wireless Chat Communicator [pdf] User Guide
2412RX, XGB-2412RX, XGB2412RX, Recon Air Wireless Chat Communicator, 2412RX Recon Air Wireless Chat Communicator
---|---

References

• Turtle Beach® Audio Hub - Download Firmware Updates for PC & Mac
• Turtle Beach Support
• Turtle Beach Support

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>