ICOFRU SPT-S01 Solar Shed Lights Indoor Instruction Manual
- June 14, 2024
- ICOFRU
Table of Contents
ICOFRU SPT-S01 Solar Shed Lights Indoor Instruction Manual
Introduction
- It is an indoor & outdoor solar powered light.
- Suitable for places where no power supplied like shed, gazebo, garage, barn, chicken coop, workshop, storage room, carport, basement, shipping container, attic, van, camp, tools room, grill area, aisle etc.
- No need extra electricity fee. Easy to install the light.
- Charging during the daytime, lighting at night or daytime.
- With a smart remote, which can adjust on/off, 5 working modes, 4 brightness, 3 lighting time.
Specifications
- Solar Panel: 6V/5W
- Battery: 4400mAh
- LEDs: 180PCS, SMD2835, 0.2W, 4000K-6000K
- Lumen: 1000LM
- Output: 7W (Fully charging)
- Remote Control: 3-5m under the light
- Waterproof Level: IP65
How to Test Mode 1, 2, 3
- After receiving the solar light , connecting the lamp and solar panel. Please press the button “ON”, the light will on
- Press the button “1” you will see the light is off. Then fully cover the solar panel. When motion detected, the light is super bright. After no motion detected 15 seconds, the light is dim
- Press the button ”2”, when motion detected, the light is super bright. After no motion detected 15 seconds, the light will turn off
- Press the button “3”, the light will keep to turn on
Note: When testing mode 1,2,3, the solar panel is always fully covered
How to Test Mode 4, 5
- Solar panel covered or do not covered, press the button “4”, when motion detected, the light is super bright. After no motion detected 15 seconds, the light will turn off.
- Solar panel covered or do not covered, press the button “5”, the light will keep to turn on
Usage After Installing
Mode 1 (for night only): full bright for 15 seconds when motion detected,
or dim light
Mode 2 (for night only): full bright for 15 seconds when motion detected,
or light off
Mode 3 (for night only): No motion sensor, constant lighting
Mode 4 (for full day): full bright for 15 seconds when motion detected,
or light off
Mode 5 (for full day): No motion sensor, constant lighting
Installation
-
Drill holes and fix the solar panel. Please choose a place where there is direct sunlight at least for 5 hours a day to install solar panel, the recommended installation height is 4-5m.
-
Connect the light with the solar panel.
-
Hang the light using wire or rope.
Notes
- When you using the remote, you have to target the middle of the lamp.
- Please charge it 6 hours at least under sunlight before using it.
- Don’t rush to install the solar pendant lights, please test the solar light at first when you receiving it.
- The charging time and the lighting time of the solar light will change with sunlight intensity, geographical location, weather conditions, seasons, and other conditions.
- It is recommended to clean the surface of the solar panel every two months.
- It is recommended to use mode 2 on rainy days or in the fourth quarter.
After-Service
If you have any problems when using it, please contact us.
Email: support@icofru.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>