IHOMEKEE CM6810 Coffee Maker Instruction Manual

: June 14, 2024
: IHOMEKEE

Table of Contents

IHOMEKEE CM6810 Coffee Maker
KNOW YOUR ESPRESSO COFFEE MAKER
HOUSEHOLD USE ONLY
BEFORE FRIST USE
HOW TO BREW ESPRESSO
CLEAN YOUR ESPRESSO MACHINE
TO DELETE INTERNAL PARTS
TROUBLESHOOTING
CONTACT
Read User Manual Online (PDF format)
Download This Manual (PDF format)

IHOMEKEE CM6810 Coffee Maker

IHOMEKEE-CM6810-Coffee-Maker-product

KNOW YOUR ESPRESSO COFFEE MAKER

HOMEKEE-CM6810-Coffee-Maker-fig-1

Water tank
Filter
Spoon
Knob
Funnel
Lamp
Filter lock
Steam tube
Funnel handle
Nozzle
Carafe lid
Carafe handle
Carafe
Drip tray
Water station
Knob
Brewed coffee
Pause
Closed
Steam
Insert
Lock

HOUSEHOLD USE ONLY

Input voltage: 120V
Frequency: 60Hz
Power: 800W
Rated capacity of water tank: 0.24L

COFFEE GROUND
To get the best extraction and best flavour espresso, please use medium-coarse ground.

If the grind is too fine, water will not flow properly through the Filter and the result will be a bitter-tasting coffee. If it is too coarse, water will flow through too fast, resulting in a weak brew.

HOMEKEE-CM6810-Coffee-Maker-fig-2

BEFORE FRIST USE

Wash the glass carafe, filter and filter holder with mild detergent, then rinse the parts well.
To clean the steam wand, please add water into the water tank and turn the control knob to the PAUSE position, the red indicator will be on and the machine start to preheat the water.
When the machine is ready(the green indicator is on), turn the control knob to position.
To clean the inside of the machine, please follow the steps of “HOW TO BREW ESPRESSO”, add water only and don’t use coffee ground.
Do not immerse the appliance in water or attempt to reach any internal parts of the machine.

HOW TO BREW ESPRESSO

Brewing Espresso

Fill the Carafe with fresh, cold water to the desired mark and pour into the Water Tank.
Screw the water tank lid on tightly. Then Plug in the unit.
Place filter into filter holder, add coffee ground into the filter, then use the tamper to tamp ground gently, don’t tamp it too tight.
Insert the filter holder into the machine by holding the handle to the far left and lifting up until it is seated in its groove. Then turn the handle to the right until it shifts into the “LOCK” position.
The filter holder is locked tight when the handle is aligned at the “LOCK” position. If the handle isn’t aligned at the “LOCK” position, it will be dropped when the machine is working.
Place the glass carafe under the filter holder.
Rotate the Control Knob to the PAUSE position, the red indicator will be on and the machine start to preheat water.
When the machine is ready(the green indicator is on), rotate the Control Knob to the ED position.
Once the coffee has finished brewing (3 – 5 minutes), turn the Control Knob to the “OFF” position, and unplug the power cord.
Pour espresso into a cup and enjoy your espresso!

DO NOT remove the water tank lid or filter holder at any time while the appliance is under pressure or until the appliance has cooled down.

RELEASE PRESSURE

To clean Frothing Aid and release the pressure, place the milk pitcher under the steam wand, then turn the Control Knob to the position slowly and release the steam.
When the Frothing Aid stops releasing steam, turn the Control Knob to the “OFF” position and unplug the power cord.

HOW TO STEAM MILK

Please fill the water into the water tank. Add your desired amount of milk to the pitcher
Rotate the Control Knob to the PAUSE position, the red indicator will be on and the machine start to preheat water.
Dip the steam wand about half an inch into the milk. You can also lower the steam wand deeper into the milk to avoid splashing.
When the machine is ready (the green indicator is on), turn the control knob to the position slowly.
Swirl the milk until the desired amount of froth is reached.
Turn the control knob to the “OFF” position.

HOW TO MAKE CAPPUCCINO

To make cappuccino efficiently, you can steam the milk first by following the step of“ HOW TO STEAM MILK”. If you make espresso first, you will need to refill water to steam milk after making espresso.
Following the step of HOW TO BREW ESPRESSO to make espresso.
Pour the steamed milk and foam into your espresso, and you’re ready to enjoy your homemade cappuccino.

To avoid steam wand blocking, please add water to a cup and place it under the steam wand. Then turn the control knob to position to let the steam comes out for about 10 seconds. After that, turn the control knob to the OFF position.

RELEASE PRESSURE

To clean Frothing Aid and release the pressure, place the milk pitcher under the steam wand, then turn the Control Knob to the position slowly and release the steam.
When the Frothing Aid stops releasing steam, turn the Control Knob to the “OFF” position and unplug the power cord.

CLEAN YOUR ESPRESSO MACHINE

Clean after brewing

Always release steam and unplug the machine before cleaning.
Wipe the housing with a soft wet cloth. Do not use abrasive cleaners or scouring pads as they will scratch the finish.
Rinse detachable components such as filter ,filter holder, carafe, measuring spoon in warm water ,and reassemble them in place after cleaning.
Remove the frothing aid and wipe the frothing arm with a damp cloth. Unscrew the frothing tip and clean the valve with a needle or toothpick.

DELIMING

Mineral deposits built up in the Espresso Maker will affect the operation of the appliance. Your Espresso Maker must be delimed when you begin to notice an increase in the time to brew espresso, or when there is excessive steaming. Also, you may notice a build up of white deposits on the surface of the brew head. The frequency of cleaning depends upon the hardness of the water used. The following table gives the suggested cleaning intervals.

SUGGESTED CLEANING INTERVAL

Type of Water| Cleaning Frequency
Soft Water (Filtered Water )| Every 80 Brew Cycles
Hard Water (Tap Water )| Every 40 Brew Cycles

DELIME WATER TANK

Make sure the Control Knob is in the “OFF” position and that the Power Cord is unplugged from the electrical outlet.
When the espresso machine is cool and the pressure has been released, remove the water tank lid and fill fresh, undiluted white household vinegar into water tank.
Allow appliance to sit overnight with the vinegar solution in the water tank.
Discard vinegar through the top opening of the Espresso Maker by turning the machine upside down over the sink.
Rinse the water tank thoroughly with tap water by filling the tank half full with water and then pouring the water back out into the sink, repeating this step twice.

TO DELETE INTERNAL PARTS

Make sure you delete the inside of the Water Tank first by following the “Deliming Water Tank” steps above.
Fill the Glass Carafe to the 4-cup mark with fresh, undiluted white household vinegar to the top of the metal band and pour it into the Water Tank.
Screw the Water Tank Lid and make sure the Lid is on tight.
Insert the Filter Holder (with Filter) in its groove and turn the handle to the right until it shifts to the “LOCK” Position. Place the Glass Carafe with a lid under the filter holder.
Plug the power cord into the electrical outlet.
Rotate the Control Knob to the PAUSE position, the red indicator will be on and the machine start to preheat water. When the machine is ready(the green indicator is on), Turn the Control Knob to the position.
When vinegar reaches the 2-cup mark on the Glass Carafe, place a cup with cold water under the Frothing Aid. Insert the Frothing Arm into the water and turn the control knob to the PAUSE position to heat the water. When the machine is ready, slowly turn the control knob to the position.
Allow steam to fully run out.
Turn Control Knob to the OFF position.

Repeat Steps 1 – 7 as necessary using only tap water to rinse any remaining traces of vinegar out of the appliance. Allow the unit to cool for 30 minutes between each rinse cycle.

TROUBLESHOOTING

PROBLEM	POSSIBLE CAUSES	EASY SOLUTION

No Water Comes Out

| · Water tank is empty

· Coﬀee ground is too ﬁne

· Appliance not turned

· on or plugged in

Coﬀee tamped too ﬁrmly

| · Fill water into the water tank

· Use medium ground

· Plug in the power cord

· Tamp ground gently

a”rCoouﬀnedetchoemeedsgouotf the Filter Holder”

| · Portaﬁlter not inserted

· in the group head correctly There are coﬀee grounds

· around the ﬁlter basket rim. Too much coﬀee in the ﬁlter.

| · Rotate ﬁlter holder to

· lock position from Clean excess

the rim of the ﬁlter basket to ensure a proper seal in

· group head.of ground

Adjust dose

PROBLEM	POSSIBLE CAUSES	EASY SOLUTION

No steam

| · Water tank is empty

· Appliance not turned on

· or plugged-in blocked Steam wand is

| · Fill water into the water tank

· Plug in the power cord

· Clean steam wand, Refer to ‘ clean after brewing’

“Coﬀtoeoe scloomwelys” out| · Coﬀee grind is too ﬁne

· Coﬀee tamped too ﬁrmly

| · Use medium ground

· Tamp ground gently

IMPORTANT NOTICE

Read these instructions carefully before using the appliance.
Before using check that the voltage of the wall outlet corresponds with the coffee maker rating plate.
Close supervision is necessary when your appliance is being used near children or disabled persons.
Do not use the appliance on or near a hot surface or in a heated oven.
Remove the plug from the wall outlet before cleaning or when not in use and allow the appliance to cool down completely before taking off or attaching components, or before cleaning. Do not operate any appliance with a damaged cord or plug or after the appliance malfunctions, or is dropped or damaged in any manner. Return the appliance to the nearest authorized service facility for examination, repair or electrical or mechanical adjustment.
The accessories that are not recommended by the manufacturer may cause injury to persons or damage to appliances.
Do not pull the power cord wrap it around the appliance, or flex the power cord.
Place the appliance on a flat surface or table, do not hang the appliance over the edge of the table or counter.
Ensure the power cord does not touch a hot surface.
Do not touch the hot surface of the appliance (such as stainless steel, tray and the cover, steam pipe and the sleeve, inner cover of the tank, filter holder and the metal filter just boiling).
Do not remove the filter holder when the appliance is brewing coffee or when steam and hot water escape from the filter holder and ensure to release of the pressure in the water tank before removing the filter holder.
In case of water leakage from the carafe or overflowing from the lid, stop using the appliance immediately and rearrange the carafe to ensure the centre of the lid is aligned with the spout of the filter holder.
Do not operate appliances without any water in the water tank.
Connect the plug to the wall outlet before using it and turn any switch off before the plug is removed from the wall outlet.
As the brewing coffee is hot, handle it carefully and avoid being burned.
Be careful of steam and avoid being burned when making cappuccino.
Do not immerse the appliance or power cord in water or any other liquid.
Save these instructions for the future.