MeTra 95-7866B Dash Kit Instruction Manual
- June 4, 2024
- Metra
Table of Contents
95-7866B Dash Kit
Instruction Manual
KIT COMPONENTS
A) Double DIN Radio Housing
B) DDIN Brackets (To hold Display above radio)
WIRING AND ANTENNA CONNECTIONS (Sold Separately)
- 70-1721 Honda harness – 1998-up
- 40-HD10 -Honda antenna adapter- 2005-up
TOOLS REQUIRED:
Small Flat Blade Screwdriver/ Panel Removal Tool
- Phillips Screwdriver
- Socket Wrench
KNOWLEDGE IS POWER
Enhance your
installation and fabrication skills by enrolling in the most recognized and
respected mobile electronics school in our industry.
Log onto www.installerinstitute.com or
call 800-354-6782 for more information
and take steps toward a better tomorrow.
ACURA MDX 2001-2006
| 
---|---
- Disconnect the negative battery terminal to prevent an accidental short circuit.
- Unclip and remove trim panel around radio/display including alc vents. (Figure A)
- Remove (6) mounting screws and remove the audio/display unit from the dash. (Figure B)
- Remove (8) screws from the audio unit and (4) screws from the display unit and remove the brackets from the audio/display assembly.
Continue to kit preparation.
DISPLAY UNIT ASSEMBLY
“‘Note: Refer also to the instructions included with the aftermarket radio.
| 
---|---
- Locate the factory wiring harness in the dash. Metra recommends using the proper mating adapter from Metra or AXXESS. Re-connect the negative battery terminal and test the unit for proper operation.
- Slide the Double DIN head unit or stacked ISO head units into the bracket/radio housing assembly and secure the Double DIN head unit or stacked ISO head units to the assembly using the screws supplied with the radio. (Figure A)
- Reassemble the dash in reverse order of disassembly.
Acura MDX with Factory Navigation
On some models the factory climate controls will stop working after replacing the radio, you can follow the steps below to correct this issue.
Steps
- Locate the White 14-Pin connector that came out of the radio.
- Place a 70ohm resistor across pin 9 (Blue) and Pin 10 (Pink).
Note: The connector will have 14 total openings for wires, but may not have 14 wires. If you do not have a 70ohm resistor, you may use any value from 70 to 100 ohms.
1·800·221·0932 www.metraonline.com
REV.08124/09 © COPYRIGHT 2003-2009 METRA ELECTRONICS CORPORATION INST99-7866B
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>