HAUSHOF HH22050A Portable Carpet Spot and Upholstery Cleaner Instruction Manual
- June 14, 2024
- HAUSHOF
Table of Contents
HAUSHOF HH22050A Portable Carpet Spot and Upholstery Cleaner Instruction
Manual
Attentions
IMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS
READ ALL SAFETY WARNINGS AND INSTRUCTIONS BEFORE USING THIS PRODUCT.
WARNING: When using an electrical product basic precautions should always be followed to avoid electric shock, fire, and/or serious injury, including the following
- This appliance is intended for domestic household use only and should not be used for any other purpose or in any other application, such as for non-domestic use or in a commercial environment.
- If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
- This appliance can be used by persons with reduced physical, sensory or mental capabilities or lack of experience and knowl- edge if they have been given supervision or instruction concern- ing use of the appliance in a safe way and understand the hazards involved.
- Children shall not play with the appliance.
- The plug must be removed from the socket outlet before cleaning or maintaining the appliance.
- Regarding the detailed instructions for the method and frequency of cleaning and the precautions during user maintenance, refer to the section “CLEANING AND MAINTENANCE”.
- Following objects are strictly banned, otherwise the vacuum cleaner will be damaged or fire calamity will be caused, which bring such accidents as human body injuries:
- Don’t pick up large or sharp broken objects such as glasses.
- Don’t pick up harming or erodent liquids (solvent, corrosive, detergent…).
- Don’t pick up inflammable or explosive substance such as gasoline or alcohol
- Don’t pick up/ vacuum burning or glowing objects (cigarettes, matches, hot ashes).
- The liquid or steam must not be directed towards equipment containing electrical components, such as the interior of ovens.
- The filling aperture must not be opened during use.
- The appliance has to be unplugged after use and before carrying out user maintenance on the appliance.
- The plug must be removed from the socket-outlet before cleaning or maintaining the appliance.
- The appliance shall not be left unattended while it is connected to the supply mains.
- The appliance is not to be used if it has been dropped, if there are visible signs of damage or if itis leaking
- Keep the appliance out of reach of children when itis energized or cooling down.
- Do not leave the appliance unattended when it is switched on.
- Do not use the appliance for any purpose other than those described in this instruction manual.
- Always disconnect the appliance from the power supply i it is left unattended and before assembling, disassembling or cleaning.
- Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.
- Use only original accessories recommended by the
- Do not use outdoors:
- Children should be supervised to ensure that they do ot play with the appliance.
- Do not use with any opening blocked; keep free of dust, lint, hair, and anything that may reduce air flow.
- Do not use the appliance to pick up the following items :
- Dry dust
- Big plastic bags
- Metal such as needles, pins, etc.
- Lots of rubbish
- Large quantities of powder
- Large quantities of sands and pebbles
Parts Name
Body
120V-60Hz 3.0A 9Kra
Accessories
Water sucker with brush, for carpet, etc.
Right-angled water sucker, for cracks and the back of the chair.
Hose hook.
Preparation
Insert the hose hook into the machine.
Remove the clean water bucket from the body.
Turning the tank upside down, then open the screw cap and fill with clean
water. The maximum water capacity is about 1L.
Install the clean water bucket into the body.
Insert the handle into the water sucker.
Fix the hose and power cord before handling.
Instructions
Plug it in, turn on the power (start).
Press the watering button to spray clean water. Spray the stain with clean
water to let it surface. Do not spray continuously at the same spot. After
spraying, absorb the water, so as not to cause mildew and odor
Absorb water, spray clean water while absorbing sewage. Press the water
suction inlet on the stain, bring the water and dirt to the front and suck
them.
Stop spraying, and absorb the sewage. After using the cloth on which water is
easily retained, please blow dry or air dry.
Turn off the power (stop), unplug it. Pour away clean water and sewage, and
clean the sewage bucket.
For stubborn dirt
Apply the cleaning solvent to the carpet and rub the dirt with a brush to lift
it up. For the amount and usage of the cleaning solvent, please read the
manual carefully and use it correctly
Absorb the dirt and do not leave any solvent.
Recommended Detergent | Not appropriate |
---|
- Strong alkaline ionized water
- Baking soda
- Citric acid
- Hypochlorous acid
- Weak acid electrolytic water Such as detergent producing less foam
|
- Neutral detergent for kitchen use
- Strongly alkaline detergent
- Strongly acidic detergentWhen using a detergent with a lot of foam, the foam might get inside the cleaner.
Remark
- Do confirm that wash solvent does not cause damage to carpet before use.
- When using detergent, first test it on the edge of the fabric being cleaned to make sure that there is no discoloration.
- Do not use diluent, aniline, chloroform, and flammable solvents.
- Do not spray any liquids such as insecticides, hair care products, or lubricating oil.
- Do not use the product to vacuum flammable or combustible substances. (such as kerosene, gasoline, thinner, copy product toner, etc.)
- Do not use the product to vacuum oil, smoke or steam.
- Do not use the product to vacuum dry dust.
- Do not operate this unit near combustible substances such as lit cigarettes or incense sticks, doing so may increase the risk of fire.
- Only water (clean tap or recommended Detergent) that is 40°C or cooler should be put into the clean water tank.
Attention
Cleaning of bucket
Take out the clean water bucket in the direction of arrow, unscrew the screw
cap and pour away the remaining water.
Install the empty bucket and then turn on the power again, press the watering
bution to remove the remaining water from the machine.
it the machine and pour away the remaining water at the botiom.
Cleaning of sewage
When the sewage reaches the maximum water level, stop working and turn off the
power. Remove the sewage bucket in the direction of arrow.
Open the upper cover of the sewage bucket and pour away the sewage. Do not
tilt or shake the sewage bucket when carrying it; otherwise, the sewage will
outflow easily.
Clean the bucket, upper cover and sealing strip. Clean the sewage bucket in
time after use, so as not to cause bacteria and smell,
Install the sealing ring, cover and fasten the sewage bucket,
Buckle the sewage bucket into the body. Lock the sewage bucket, do not shake;
otherwise, it is easy to leak and affect the cleaning
Stop using when the water in the sewage bucket exceeds the maximum water
level, clean the sewage bucket; otherwise, the water will flow into the
machine.
Cleaning and Maintenance
After use every time, remove them from the body, rinse thoroughly with water
and air dry.
Disassembly of water sucker.
Disassembly of water sucker cover.
Installation of water sucker cover: 1. the pin and hole fit well 2. Press in
until clicking sound to make sure the installation is in place\
When cleaning the water sucker, empty the nozzle ifitis blocked.
Check the hose for breakage and leakage.
Rinse the inlet air sponge and filtering sponge after use, and replace them if
they are damaged
Pour away the sewage before it exceeds the maximum water level. If the machine
continues to be used after the sewage exceeds the maximum water level, the
floating ball will work and the suction will stop. When the water flows into
the machine, turn off the machine and clear away the water inside the machine,
pipe and bucket
Attention
- Stop running and unplug it before maintenance.
- Do not water the machine to avoid electric shock.
- Do not use the detergent, diluent, benzene and other chemical agents to clean the machine.
Consumables, Fault a Handling
-
Seal ring for upper cover
-
Inlet air sponge
-
Filtering sponge
-
Screw cap
In the event of exceptions in use, read this manual carefully and confirm the following points before repair.
Status | Fault cause analysis | Handling |
---|---|---|
‘The machine does not work after the switch is turned on |
- The plug is not properly connected and loose, resulting in poor contact.
- The internalline or power cord is broken.
- The machine set overheats and the. protective device operates
| Turn off the power and plug it again. Call the repair telephone. Refer to
the instructions for protective device,
When the watering button is pressed, there is no water or little water|
- The nozzle is blocked.
- The handle or pump is damaged
| Remove the water sucker and rinse the nozzle with clean water. Call the
repair telephone.
There is no dust collection or the suction is very weak|
- The power switch is not turned on. « The sewage bucket is ful, causing the floating ball to work.
- The hose is abnormal.
- The sewage bucket s not installed in place.
- The inlet air sponge is blocked
| Turn on the power switch. Clean up the sewage and use it again. Check the hose for cracks, breaks and clogs. Install the sewage bucket properly. Clean or replace the sponge.
Enviroment Friendly Disposal
Disposal of the Appliance
This product has been marked with a symbol relating to removing electric
and electronic waste. This means that this product shall not be discarded with
household waste but that it shall be returned to a collection system.
It will then be recycled or dismantled in order to reduce the impact on the environment. Electric and electronic equipment can be hazardous for the environment and for human health since they contain hazardous substances.
Disposal of the Packaging
The packaging consists of cardboard and correspondingly marked plastics that can be recycled. & Make these materials available for recycling
Zhejiang Yili Machinery And Electric Co., Ltd
No.111, Lingxiu Road, Luoxing Street,
Jiashan County,
JIAXING CITY,
Zhejiang Province 314100