SPECTRA Wearable Breast Pumps User Manual
- June 14, 2024
- Spectra
Table of Contents
- PLEASE READ BEFORE USE
- PRODUCT DESCRIPTION
- Accessories Include
- CONTROL PANEL
- Battery Indicator and Milk Alarm
- REMOTE CONTROLLER INSTRUCTIONS
- ASSEMBLY
- Install the pump motor.
- SITTING POSITION FOR SUCTION
- STRUCTIONS FOR BRA ADJUSTING BUCKLE
- DIRECTION FOR USE
- POUR MILK
- BREAST MILK STORAGE AND THAWING
- TROUBLE SHOOTING
- CUSTOMER SUPPORT
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
**SPECTRA Wearable Breast Pumps User Manual
**
PLEASE READ BEFORE USE
- Please limit usage to no more than 15 minutes at a time. It is perfectly normal to not express much milk within this period at first. but with regular use, your body will eventually adapt to producing more milk..
- Research have shown that to achieve optimum breast milk production, you should be in a totally relaxed state. It helps you release the hormone oxytocin that stimulates your milk ejection. So, sit back on your favorite couch while listening to your favorite tunes, try deep breathing exercises or get your partner to give you a massage.
- The device comes with a massage function that you may use ( 1-3 mins) before pumping. This allows you to release the hormone oxytocin and increase milk production.
- Clean regularly, clean any pump parts that have been in contact with your breast milk and wash your hands before and after use.
- Choose the optimum suction level. Gradually increase the breast pump suction until it becomes slightly uncomfortable, and then turn it down a notch. The pump will resume from the last used suction level when restarted,
- Since this is a wearable breast pump, please ensure that you use a proper breast shield,
PRODUCT DESCRIPTION
Accessories Include
Pump motor +1 : Valve -2
Milk collector +1: Sealing ring -2
Linker-1 : Silicone gas cup 2
Type-C cable-1 : Bra adjustment buckle -1
Silicone massage petal +1 : Remote control-1
- All parts of the double breast pump are doubled except the remote control.
CONTROL PANEL
Follow the principle of massage first, then deep pumping.
3Modes
Massage function: 12 levels
(Massage first to stimulate milk production)
Suction function: 12 levels
(Please choose the optimum level, the pumping mode is designed for słow
suction, deep suction.)
Stimulation Mode: 6 levels
(Massage and suction used simultaneously which is excellent for sunken nipples
or new mother. open milk adopts 31 mode 3 short-frequency massages and
deep suction.)
Turn on/off: Press and hold the power button for 3 seconds,
Mode change: Press the mode kay M
Level change: Press the for keys to increase or decrease the level.
Battery Indicator and Milk Alarm
Flash Red: Battary low (require charging).
Glow Green: Battery is fully charged (Flashes green while charging).
Milk Warning: The alarm will flash red every 10 minutes. It is time to
take out the mik collector, the pump will auto off every 30 mins.
REMOTE CONTROLLER INSTRUCTIONS
Make sure that the breast pump is property put inside the nursing bra, press
and hold the power button of the pump motor for 3 seconds to turn it on, then
align the remote controller above the pump motor and switch modes to increase
or decrease the suction levels according to the buttons on the remote
controller (as picture). After use, long-press the power button of the remote
controller for 3 seconds to turn off the breast pump or long-press the power
button of the pump motor for 3 seconds to turn it off.
ASSEMBLY
STEP 1
Put the silicone gas cup into the linker, and press it with your hands to make the edges fasten tightly to ensure a perfect seal.
STEP 2
Install the valve into the bottom of the linker. Make sure it is installed in the correct direction.
STEP 3
Put the assembled linker into the milk collector.
STEP 4
Place the silicone massage petal into the milk collector and ensure it is sealed property to prevent leakages
STEP 5
Install the pump motor.
CLEANING NSTRUCTIONS
Before Use
- Remove the pump motor
- Place all the silicone parts in boiling water for 3 to 5 minutes.
- Wash the milk collector and Linker with warm soapy water and rinse woll
- Wipe down the parts with cloth or air dry before use.
After Use
- Rinse the milk collector, valve and linker immediately after use.
- Place all the silicone parts in boiling water for 3 to 5 minutes.
- Wipe down the parts with cloth or air dry before storage
- Do not submerge pump motor in water.
SITTING POSITION FOR SUCTION
Relax the body, sit in a comfortable chair and lean slightly forward(use cushion to support back). Make sure to keep the breast pump and milk collector upright
STRUCTIONS FOR BRA ADJUSTING BUCKLE
Adjust the length of bra straps to make suction more comfortable. One end of
the bra adjustment buckle hung on the inside buckle of the nursing bra. The
length of the bra strap can be adjusted by hanging the nursing bra buckle on
the other end of the bra adjustment buckle.
DIRECTION FOR USE
Press the silicone massage petal firmly against the breast, leave no gaps and make sure your nipples are centered. Keep it upright. Be careful not to distort the position of the product and the chest, otherwise the breast pump will not have suction,
In the bra placement
Note: Do not lie down while using the breast pump. If you feel any discomfort while expressing or notice blisters or chafing on your nipple or breast, try reducing the breast pump suction level.
Turn off and remove the pump carefully.
POUR MILK
Please keep breast pump upright, and remove the pump motor from pump body
careful, to pour the milk into the bottle, make sure the gap of milk collector
against the bottle mouth.
BREAST MILK STORAGE AND THAWING
Storage
Please use a clean and sterilized milk storage bag or a sealed milk bottle to store breast milk, Immediately refrigerate the milk to maintain its freshness.
Thawing
To thaw frozen breast milk, place it in the refrigerator overnight. In case of emergency, you may thaw the milk quickly and safely by placing the milk bottle in hot water or by using a food heater, However, it is important to consume the breast milk within 24 hours of thawing.
Warm Reminder 1
- Avoid repeatedly freezing breast milk
- Do not mix fresh breast milk with previously frozen breast milk
- Remember to drain any remaining breast milk after each feeding.
Warm Reminder 2
- Always check the temperature of the milk before feeding your baby,
- Avoid using a microwave to heat breast milk as it can damage important nutrients and antibodies.
- Uneven heating can cause local overheating and scalding, so heat the milk slowly and stir it wel
- Nerve put the bottle in boiling water, as it may cause cracking.
TROUBLE SHOOTING
Weak Or No Suction | 1. Check that the valve is property installed |
---|---|
Nipple Pain | 2. Charge the device before use, |
No/Little Mik Expressed | 3. Check that the product is placed comectly |
otherwise the breast pump will not have suctions.
Note : Please keep free to contact us if you have any product questions,
CUSTOMER SUPPORT
If you have any questions, please feel free to contact us: US : Breast Pump.vip@gmail.com EU/UK Breast Pump Service@163.com JP Breast Pump.vipservice@outlook.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>