BUTURE BR300 Jump Starter Power Pack User Manual

BUTURE BR300 Jump Starter Power Pack

Package Content

Introduction

Thank you for purchasing BUTURE BR300 car jump starter. Please read the user manual carefully before you start to use the product.

Key Features

• A Powerful Jump Starter: Car Jump Starter can jump starts 12V cars, SUV, truck or van (6.OL petrol or 5.0L diesel engine) in seconds up to 20 times.
• Portable Fast Charger: Ensures the fastest charging efficiency, 4x faster than conventional charger.
• Safety Protection: Premium cells, circuitry and safety features protect you and your device from surge or short circuits.
• Powerful LED Lights: Ultra-bright LED flash light, strobe light, and SOS signal light that lasts 120 hours.

Know Your Product

1. Jump Starting Port
2. LED Light
3. Output 1
4. Output 2
5. Input
6. Power Switch
7. Battery Indicator

Powerful Circuit Protection System – Smart Clamps

1. Red Jumper Cable (+)
2. Black Jumper Cable (-)
3. Smart Clamp Plug

Getting Started

Charging your Jump Starter

1. Please use a 5V2A/9V2A/12V1.5A adapter to charge the product. (charging t cable is included, adapter is not included
2. Using a 5V/2A adaptor, it will take approximately 4 hours to fully charge the unit. In order to extend the battery life it is recommended to fully charge the unit every 3-6 months.

Turn On your Jump Starter

• Short press the power switch to boot the system, the battery indicator lights will turn on.
• For energy saving, the system will tum to standby mode if there is no operation within 20 seconds.

LED Light

Long press the power switch more than 3 seconds to tum on the light mode. There are three modes which are ON, SOS and Strobe, simply short press the power switch button to change the 3 modes or tum off the light mode. And you can also press the power switch button for more than 3 seconds to tum off the light mode.

Dual Outputs

This portable jump starter is also equipped with two smart outputs that provide the fastest charging speed(USB1 5V2.4A/9V2A/12V1 .5A; USB2 5V2.1A) for your portable electronic devices, such as phones,tablets, Bluetooth earphones, etc.

Start your Car

Note

1. This product is for 12V car only. Check to make sure that 3 or 4 indicator lights are illuminated (battery level is above 50%) before you use it to jump start your car.

2. Before using the jump starter to start the engine, please keep the doors and lights off.

3. Insert the plug of the smart clip completely into the jump starter, the green and red lights flash alternately.

4. Correctly clip the red and black clamps to the electrodes of the car battery (red to positive and black to negative)(The green light stays on)

5. Start the vehicle.

6. When the vehicle is started, remove the jumper cable from the vehicle battery immediately.

In any of the following situations, the smart clamp turns on protection mode:

need be charged
The red light is always on, and the buzzer sounds| The temperature of the smart clip is abnormal or the positive and negative poles may be short- circuited, please remove the smart clip immediately
The green light LED flashes slowly| The starting is not be finished after connecting the smart clip for 90 seconds

Charge your Car Battery

1. Use the original smart clip to start the car.
2. DO NOT use this unit if any cable clamp or cord is damaged.
3. Start only for 12V vehicles,or it will cause serious damage to the unit.
4. Do not jump start your car when the BR300 capacity is lower than 30%.
5. Do not connect two clamps together when the starter is powered on. And do not connect both cable clamps to the same piece of metal.
6. If the engine does not start on the first try, disconnect it from the car battery and wait for at least 20 seconds before reconnecting. Maximize three attempts in two minutes.
7. Once the engine is successfully started, disconnect the clamps within 30 seconds.

FAQ & Trouble Shooting

• Q: How to tum off this power pack?
  • A: This power pack will power off automatically when no load or charging is complete.
• Q: What kind of adapter should I use?
  • A: You can use the charger of your phone or tablet..
• Q: How long time to full charge the BUTURE BR300 jump starter?
  • A: About 4 hours through the 5V2A AC adapter.
• Q: How many times can this product start the vehicle with full capacity?
  • A: Up to 20 times.

Care and Maintenance

1. DO NOT put the product under direct sunlight or hot areas.
2. DO NOT drop or knock your car jump starter.
3. DO NOT disassemble the equipment, it may cause damage.
4. DO NOT use chemicals or detergents to clean the product.
5. DO NOT place the products in high high-temperature environment for long. The operating temperature: -20-60 “C.
6. Check the power of the product at least every three months, and charge the product in time.

Warranty And Contact

Warranty

• Our company provides customers with warranty of 24 months from the date of purchase.

Contact US

• For additional assistance or warranty cover claim, please contact us:
  • E-Mail: support@ibuture.com

FCC STATEMENT

Federal Communication Commission Interference Statement

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired operation.

Declaration of Conformity

We (Manufacturer is responsible for this declaration)

(Company name)

• Ekoo Electronic Co.Ltd.

(Company address)

• B09,block B.f2,bldg.b,runfeng Pioneer Park,no.973, minzhi Avenue. Minzhi St., Longhua, Shenzhen, CN (Company address)

declare under our sole responsibility that the product

• Trade name: BUTURE
• Equipment: Car Jump Starter
• Model No.: BR300

to which this declaration relates is in conformity with the essential requirement set out in the Council Directive on the Approximation of the laws of the Member States relating to LVD Directive(2014/35/EU) & EMC Directive(2014/30/EU) & RoHS(2011/65/EU) product is responsible to affix CE marking, the following standards were applied:

• EN 62368-1:2014+A11:2017
• EN 55032:2015+A11:2020
• EN 55035:2017+A11:2020
• IEC62321-3-1:2013
• IEC62321-4:2013
• IEC62321-5:2013
• IEC62321-6:2015
• IEC62321-7-1:2015
• IEC62321-7-2:2017
• IEC62321-8:2017

Full Name: George.wang
Position: Approbation Manager
Signature: George.wang
Place/Date: Shenzhen,China/Aug. 18-2021

Correct Disposal of this product

This marking indicates that this product should not be disposed with other household wastes throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. To return your used device, please use the return and collection systems or contact the retailer where the product was purchased. They can take this product for environmental safe recycling.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>